An innovative sampling interface for monitoring flowing pharmaceutical powder mixtures.

A chute was designed following the principles of the Theory of Sampling to minimize the variations in powder flow and provide all particles in the flowing blends with the same opportunity of being selected as a sample. The design also reduces the thickness of the chute to allow the analysis of a higher portion of the flowing blends by a near infrared spectrometer. The blends that flowed through the chute had Carr's index values that fluctuated between 23 and 25 percent, indicating passable flowability. A powder fowling evaluation demonstrated that there was no powder accumulation at the inspection window of the chute. The mass flow rate profiles indicated that the system achieves mass steady-state in approximately 30 s and a throughput of 30 kg/h which makes it suitable for continuous manufacturing operations. An in-line NIR calibration model was developed to quantify caffeine concentrations between 1.51 and 4.52 % w/w. The spectra obtained from each experiment had minimal baseline variation. The developed NIR method was robust to throughput changes up to approximately ±7 %. The test blends in the caffeine concentration range between 2.02 % w/w and 4.02 % w/w met the dose uniformity requirements of the Ph.Eur. 9.0, chapter 2.9.47. Variographic analysis was done to estimate the analytical and sampling errors which yielded values below 0.01 (%w/w)2. The obtained results showed that this chute could also be used in a continuous manufacturing line or other applications with flowing powders.

In-line monitoring of low drug concentration of flowing powders in a new sampler device.

A novel sampler device for flowing powders was tested to quantify drug concentrations as low as 0.76% w/w in pharmaceutical powder blends. The sampler device was developed based on the powder flow behavior within a tablet press feed frame, following the principles laid down in the Theory of Sampling. Two Near-Infrared (NIR) spectroscopic calibration models were developed with powder blends that varied from 0.52 to 2.52% w/w and 1.51-4.52% w/w. The calibration models were able to determine caffeine concentration in test set blends with root mean square error of predictions and bias below 0.1% w/w. Samples were collected from the sampler device and analyzed by ultraviolet-visible (UV-Vis) to determine the caffeine concentration. A high agreement between the in-line NIR predictions and the sampled UV-Vis results was found. The paddle wheel speed in the sampler can be varied up to ±10% without affecting NIR predictions; however, the models did not respond adequately to a 25% increase in this speed. Variographic analysis showed that the sampler device may quantify low drug concentrations with nugget effects below 0.0050 (%w/w)2. This study demonstrate that the sampler device may handle throughputs up to 45 kg/h, without significantly affecting the physical properties of powder blends.