Performance of Gelatin Films Reinforced with Cloisite Na+ and Black Pepper Essential Oil Loaded Nanoemulsion.

The concern about consuming eco-friendly products has motivated research in the development of new materials. Therefore, films based on natural polymers have been used to replace traditional polymers. This study consists of a production of films based on gelatin reinforced with black pepper essential oil-loaded nanoemulsions and Cloisite Na+. The films were characterized by water vapor permeability, mechanical and thermal properties, surface contact angle, X-ray diffraction and scanning electron microscopy. It was observed that the films containing the nanoemulsion have higher permeability values and an increase in their mechanical resistance. The addition of nanoclay contributed to an increase in the surface hydrophobicity of the film and an increase in the tensile strength, at break, by about 150%. The addition of essential oil nanoemulsions led to an increase in thermal stability. The presence of clay dispersion contributed to the formation of a surface that was slightly rougher and grainier. The addition of the black pepper essential oil nanoemulsion resulted in an increase in porosity of the gelatin matrix. Through X-ray diffraction analysis, it was possible to conclude that both the polymeric gelatin matrix and the essential oils nanoemulsion are intercalated with the clay dispersion.

Upcycling Microbial Cellulose Scraps into Nanowhiskers with Engineered Performance as Fillers in All-Cellulose Composites.

Cellulose is everywhere and renovates in nature continuously and rapidly, while petroleum does not. Unlike the latter, cellulose biodegrades and may represent a carbon sink. Inspired by the multiscale architecture of cellulose, we report on all-cellulose composites comprising cellulose ether as a matrix and highly pure bacterial cellulose nanocrystals (BCNCs) as fillers. Optimum performance as a packaging material was achieved by engineering BCNC surface chemistry as well as the filler-in-matrix dispersion, targeting the replacement of unsustainable, fossil-derived plastics intended for single-use applications. Cost could pose a hurdle, eliminated through the valorization of underutilized scraps from industrial operations, which is also in line with the circular bioeconomy in terms of the integral use of biomass. As far as performance, the optically transparent hydroxypropyl methylcellulose (HPMC) films presented improved tensile strength (from 61 ± 6 to 86 ± 9 MPa) and Young's modulus (from 1.5 ± 0.2 to 2.7 ± 0.4 GPa) while reduced elongation at break (from 15 ± 2 to 12 ± 2%) and water vapor permeability (from 0.40 ± 0.02 to 0.31 ± 0.01 g mm h-1 m-2 kPa-1) when filled with only 5 wt % of (120 ± 31) nm long, (13 ± 3) nm wide, 88% crystalline BCNC. This dual, win-win effect of BCNCs on the mechanical and barrier properties of HPMC films was enabled by a suitable dispersion state, achieved via high-energy mixing, and quenched by casting. This study adds to the current literature on all-cellulose composites and helps pave the route for the technical and economical feasibilities of replacing non-renewable, non-biodegradable plastics in short-term applications by materials that are both renewable and biodegradable, that are also produced through green protocols and isolated from surplus biomass, and that still perform similarly or even better.