Direct analysis of methylated trivalent arsenicals in mouse liver by hydride generation-cryotrapping-atomic absorption spectrometry.

Growing evidence suggest that the methylated trivalent metabolites of inorganic arsenic (iAs), methylarsonite (MAs(III)) and dimethylarsinite (DMAs(III)), contribute to adverse effects of iAs exposure. However, the lack of suitable methods has hindered the quantitative analysis of MAs(III) and DMAs(III) in complex biological matrices. Here, we show that hydride generation-cryotrapping-atomic absorption spectrometry can quantify both MAs(III) and DMAs(III) in livers of mice exposed to iAs. No sample extraction is required, thus limiting MAs(III) or DMAs(III) oxidation prior to analysis. The limits of detection are below 6 ng As/g of tissue, making this method suitable even for studies examining low exposures to iAs.

Focused microwave-induced combustion: a new technique for sample digestion.

A procedure for sample digestion based on focused microwave-induced combustion (FMIC) is proposed. This system was developed using a commercial focused microwave oven with a lab-made quartz sample holder and a modified glass vessel. Oxygen flow was used to start and support the combustion. A botanical sample was used to evaluate the operational conditions for further Al, Ba, Ca, Fe, Mg, Mn, Sr, and Zn determination by inductively coupled plasma optical emission spectrometry. Pelletized samples were positioned on the quartz holder, and 50 microL of 6 mol L(-1) NH(4)NO(3) solution was added as igniter. Combustion was completed in less than 2 min, and the temperature was higher than 950 degrees C. The use of a reflux step, the position of sample holder inside the vessel, sample mass, ignition and combustion time, oxygen flow rate, and condenser type were evaluated. Results were compared with those obtained by focused microwave-assisted wet digestion and by high pressure microwave-assisted wet digestion. Agreement of 95-103% was obtained for certified reference materials digested by FMIC (reflux step with 10 mL of 4 mol L(-1) HNO(3)). With the proposed procedure, a complete sample decomposition (residual carbon content lower than 0.5%) was achieved with low consumption of reagents as only 10 mL of diluted nitric acid was necessary. Low relative standard deviation (lower than 3.8%) was observed and high amount of sample (up to 1500 mg) could be digested that allowed lower limits of detection.

Evaluation of sample preparation methods for elastomer digestion for further halogens determination.

In this work, three sample preparation methods were evaluated for further halogen determination in elastomers containing high concentrations of carbon black. Samples of nitrile-butadiene rubber, styrene-butadiene rubber, and ethylene-propylene-diene monomer elastomers were decomposed using oxygen flask combustion and microwave-induced combustion (MIC) for further Br and Cl determination by ion chromatography (IC), inductively coupled plasma optical emission spectrometry (ICP OES), and inductively coupled plasma mass spectrometry (ICP-MS). Extraction assisted by microwave radiation in closed vessels was also evaluated using water or alkaline solution. Digestion by MIC was carried out using 50 mmol l(-1) (NH(4))(2)CO(3) as the absorbing solution. The effect of the reflux step was also evaluated. Accuracy was evaluated using certified reference materials with polymeric matrix composition and by comparison of results using neutron activation analysis. Agreement for Br and Cl was better than 95% by MIC using 5 min of reflux, and no statistical difference was found using IC, ICP OES, and ICP-MS for determination of both analytes. For MIC, the relative standard deviation (RSD) was lower than 5%. Using extraction in closed vessels, a high amount of residues was observed, and recoveries were lower than 45% for both analytes. For oxygen flask combustion, the agreement was similar using MIC but RSD was higher (20%). The residual carbon content, an important parameter used to evaluate the digestion efficiency, was always below 1% for MIC. Using MIC, it was possible to digest elastomers with high efficiency, resulting in a single solution suitable for halogen determination by different techniques.

Evaluation of sample preparation methods for cereal digestion for subsequent As, Cd, Hg and Pb determination by AAS-based techniques.

Sample preparation methodsforcereal digestion were evaluated for the first time for subsequent As, Cd, Hg, and Pb determination by atomic absorption spectroscopy techniques. Microwave-assisted digestion (MW-AD) under high and medium pressure and microwave-induced combustion (MIC) were evaluated. The use of MIC made it possible to digest 700 mg of samples, and agreements of 97, 96, 100 and 92% were obtained for As, Cd, Hg and Pb, respectively, when 7 mol L-1 HNO3 was used as the absorbing solution. It was not necessary to dilute the digests obtained to avoid interferences in the quantification of As, Cd, Hg, and Pb. Although high pressure MW-AD was efficient for cereal digestion, interferences were observed on analyte determination. Limits of quantification obtained by MIC were 0.034 (As), 0.015 (Cd), 0.021 (Hg) and 0.105 (Pb) µg g-1, which are suitable to attain the maximum levels recommended by international agencies in cereal samples.

Trypanosoma evansi: levels of copper, iron and zinc in the bloodstream of infected cats.

The aim of this study was to evaluate the concentrations of copper, iron and zinc in blood serum of cats experimentally infected with Trypanosoma evansi. Animals were divided into two groups: control and infected with T. evansi. The animals were infected with 10(8) trypomastigotes each and parasitemia was estimated daily for 56 days by microscopic examination of smears. Hematological and biochemical parameters were evaluated for monitoring of the disease. Serum metal levels were determined in blood samples collected at days 7, 28 and 56 of the experiment. Inductively coupled plasma optical emission spectrometry was used to measure the levels of copper, iron and zinc. Significant differences were observed among groups (P<0.05). Increased levels of copper and decreased iron and zinc levels were observed. A decrease in the number of red blood cells was also observed 7 days after inoculation. Biochemical parameters were not altered. Therefore, the infection by T. evansi might alter the serum metal levels, causing metabolic disturbances in cats.

Sputtering deposition of magnetic Ni nanoparticles directly onto an enzyme surface: a novel method to obtain a magnetic biocatalyst.

A simple one-step method based on the sputtering deposition of Ni nanoparticles (NP) has been developed for the production of magnetic biocatalysts, avoiding the complications and drawbacks of methods based on chemical functionalisation or coating of magnetic NP. This new technique provided high levels of recovery, reusability and catalytic activity for the lipase-Ni biocatalyst.

Determination of halogens in coal after digestion using the microwave-induced combustion technique.

The microwave-induced combustion (MIC) technique was applied for coal digestion and further determination of bromide, chloride, fluoride, and iodide by ion chromatography (IC). Samples (up to 500 mg) were combusted at 2 MPa of oxygen. Combustion was complete in less than 50 s, and analytes were absorbed in water or (NH(4))(2)CO(3) solution. A reflux step was applied to improve analyte absorption. Accuracy was evaluated for Br, Cl, and F using certified reference coal and spiked samples for I. For Br, Cl, and F, the agreement was between 96 and 103% using 50 mmol L(-1) (NH(4))(2)CO(3) as the absorbing solution and 5 min of reflux. With the use of the same conditions, the recoveries for I were better than 97%. Br, Cl, and I were also determined in MIC digests by inductively coupled plasma mass spectrometry, inductively coupled plasma optical emission spectrometry, and F was determined by an ion-selective electrode with agreement better than 95% to the values obtained using IC. Temperature during combustion was higher than 1350 degrees C, and the residual carbon content was lower than 1%. With the use of the MIC technique, up to eight samples could be processed simultaneously, and a single absorbing solution was suitable for all analytes and determination techniques (limit of detection by IC was better than 3 microg g(-1) for all halogens).