Influence of the parameters of the Er:YAG laser on the apical sealing of apicectomized teeth.

Failures in the sealing of the tooth apex have been considered to be responsible for most of the failures of apical surgeries. The Er:YAG laser has been proposed as an alternative for the use of rotator instruments in surgical endodontics due to its precision, lack of vibration, less post-operative discomfort, bacterial reduction, and less stress for patients and professionals. Following approval by the ethics committee, 12 extracted human canines without previous endodontic treatment with anatomically normal roots and free from apical lesions were washed in running tap water and disinfected. The teeth were sectioned axially at the crown-root junction and submitted to routine endodontic treatment. The apical limit was set at 1 mm before the apical foramen. The root canals were routinely filled with Gutta-Percha points and Sealer 26 and were randomly distributed into two groups (n = 6). In group I, apicectomy was performed with the Er:YAG laser (KAVO KEY Laser II®, Germany, λ = 2.940 nm, pulsed mode, 2051 tip, with air spray cooling, 250 mJ/15 Hz). Apical cut was performed of perpendicular mode 3 mm from the apical foramen. In group II, the same procedures and the same sequence as above was used, varying only the parameters of the Er:YAG laser (400 mJ/6 Hz). Sealing of the cervical end the apex was carried out with acrylic resin; the roots were covered by a layer of epoxy glue and two layers of nail polish. The specimens were divided into groups and fixed, by the cervical third, on wax. Impermeabilization of the residual root apical third was performed following the same procedures used in the cervical third but the residual apex was left free from the impermeabilization. After that, the roots were immersed in a 2% methylene blue solution and placed in a bacteriological oven for 48 h and then washed in running tap water for 2 h. The samples were sagittally split into two parts. The segments were visually observed and the one showing the greatest level of dye leakage was selected and kept in an individual container and coded accordingly. Apical staining was measured using a stereoscopic magnifying glass, a compass, and a caliper. The measurement was performed by three endodontists, previously calibrated, and unaware of the sample coding. The results showed that group I showed the greatest level of dye leakage. There was a significantly difference between the groups (p = 0.001). It is concluded that the apicectomies carried out with 400 mJ/6 Hz showed the smallest infiltration value.

Influence of laser therapy on the dynamic formation of extracellular matrix in standard second degree burns treated with bacterial cellulose membrane.

The present study aims to assess the influence of Aluminum-Gallium-Indium-Phosphide laser (AlGaInP laser, λ = 660 nm), whether or not in association with the application of a membrane of bacterial cellulose (Nexfill™), during recovery from induced second-degree burns at the dorsum of Wistar rats. (Rattus norvegicus, Wistar). Forty-eight animals have been distributed into four groups: Control (burns remained untreated), Group I (laser-treated), Group II (treated with Nexfill), and Group III (laser + Nexfill™). In addition to a morphological analysis, immunohistochemical analysis has been performed for type I collagen, type III collagen, fibronectin, and laminin. The Fisher's Test was used to assess differences among groups (p < 0,05). A larger amount of collagen type III was observed in Control, Group II and Group III when compared with Group I (p < 0,05). Group I and Group III have shown a greater collagen deposition when compared with Group II (p < 0,05), but the amount of collagen was similar in Group I, Group III, and Control. Group III has shown larger fibronectin amounts in comparison with Group II (p < 0,05). As regards laminin, Group I has shown a predominant discontinuity pattern on the basal lamina in comparison with Control, Group II, and Group III (p < 0,05). It is concluded that in this current study the laser when used alone (Group I) hasn't influenced collagen deposition neither has it acted on fiber pattern (fibril and/or reticular). Moreover, laser application hasn't accelerated the repair of wounds caused by inflicted second-degree burns.

Evaluation of the effects of polarized light (λ400-200 nm) on the healing of third-degree burns in induced diabetic and nondiabetic rats.

OBJECTIVE: The study evaluated, by light microscopy, the repair process on third-degree burns on diabetic and nondiabetic rats, illuminated or not, with a polarized light (PL) source. BACKGROUND DATA: Burns are severe injuries that result in the loss of fluid and destruction of tissue, infection, and shock that may result in death. Diabetes mellitus is a public health problem that, being uncontrolled, causes severe disturbance to the body metabolism, including on wound healing. PL sources have been shown to be effective in improving healing in many situations. MATERIALS AND METHODS: Ninety male Wistar rats were divided into two groups (n=45): nondiabetic and diabetic. In one of the groups, diabetes mellitus was induced by streptozotocin. A third-degree burn, measuring 1.5×1.5 cm(2), was created in the dorsum of each animal. Phototherapy (λ400-2000 nm, 10.2 or 20.4 J/cm(2)) started immediately after burning and was repeated daily until animal death (7, 14, and 21 days). Specimens were taken, processed, and stained with H&E and Sirius red and immunomarked with cytokeratin (CK) AE1/AE3. Descriptive analysis was performed by light microscopy. RESULTS: Animals subjected to phototherapy showed an acceleration of the repair, the dose of 10.2 J/cm(2) being the one that caused best results, including higher deposition of collagen, quicker inflammatory reaction, and improved revascularization. CONCLUSIONS: Our results suggest that the use of PL (10.2 J/cm(2)) improves the healing of third-degree burns on both diabetic and nondiabetic animals.

Polarized light (λ400-2000 nm) on third-degree burns in diabetic rats: immunohistochemical study.

AIM: The aim of this study was to evaluate with light microscopy the healing process of third-degree burns on diabetic rats treated with polarized light (λ400-2000 nm, 20 or 40 J/cm(2)/session, 40 mW/cm(2), 2.4 J/cm(2)/min, 5.5-cm beam diameter). BACKGROUND: Uncontrolled diabetes mellitus causes severe disruption of the body's metabolism, including healing. Polarized light sources have been shown to be effective in improving healing in many situations. ANIMALS AND METHODS: Diabetes mellitus was induced with streptozotocin (60 mg/kg) in 45 male Wistar albino rats, and a third-degree burn (1.5 by 1.5 cm) was created on the dorsum of each animal under general anesthesia. The animals were randomly distributed into three groups: control, 20 J/cm(2), and 40 J/cm(2). Each group was then divided into three subgroups based on time of death (7, 14, 21 d). Phototherapy (20 or 40 J/cm(2) per session) was carried out immediately after the burning and repeated daily until the day before death. Following animal death, specimens were removed, embedded in paraffin, sectioned, and stained with hematoxylin and eosin (HE) or Sirius Red or immunomarked with CK AE1/AE3 antibody. Qualitative and semiquantitative analyses were performed under light microscopy. The results were statistically analyzed. RESULTS: The animals treated with 20 J/cm(2) showed significant differences with regard to revascularization and re-epithelialization. Although the 40 J/cm(2) group showed stimulation of fibroblastic proliferation as an isolated feature, no other difference from the control was observed. CONCLUSION: Our results suggest that the use of polarized light at 20 J/cm(2) effectively improves the healing of third-degree burns on diabetic animals at both early and late stages of repair.