RESUMO
Detailed studies of the luminescent properties of the Si-based 2D photonic crystal (PhC) slabs with air holes of various depths are reported. Ge self-assembled quantum dots served as an internal light source. It was obtained that changing the air hole depth is a powerful tool which allows tuning of the optical properties of the PhC. It was shown that increasing the depth of the holes in the PhC has complex influences on its overall photoluminescence (PL) response due to the simultaneous influences of counteracting factors. As a result, the maximal increase in the PL signal of more than two orders of magnitude was obtained for some intermediate, but not full, depth of the PhC's air holes. It was demonstrated that it is possible to engineer the PhC band structure in such a way as to construct specific states, namely bound states in continuum (BIC), with specially designed dispersion curves being relatively flat. In this case, such states manifest themselves as sharp peaks in the PL spectra, and have high Q-factors which are larger than those of radiative modes and other BIC modes without such a flat dispersion characteristic.
RESUMO
The effects of resonance interaction of plasmonic and photonic modes in hybrid metal-dielectric structures with square Al nanodisk lattices coupled with a Si waveguide layer were investigated using micro-photoluminescence (micro-PL) spectroscopy. As radiation sources, GeSi quantum dots were embedded in the waveguide. A set of narrow PL peaks superimposed on the broad bands were observed in the range of quantum dot emissions. At optimal parameters of Al nanodisks lattices, almost one order increasing of PL intensity was obtained. The experimental PL spectra are in good agreement with results of theoretical calculations. The realization of high-quality bound states in the continuum was confirmed by a comparative analysis of the experimental spectra and theoretical dispersion dependences. The results demonstrated the perspectives of these type structures for a flat band realization and supporting the slow light.
RESUMO
The interaction of Ge(Si)/SOI self-assembled nanoislands with modes of photonic crystal slabs (PCS) with a hexagonal lattice is studied in detail. Appropriate selection of the PCS parameters and conditions for collecting the photoluminescence (PL) signal allowed to distinguish the PCS modes of different physical nature, particularly the radiative modes and modes associated to the bound states in the continuum (BIC). It is shown that the radiative modes with relatively low Q-factors could provide a increase greater than an order of magnitude in the integrated PL intensity in the wavelength range of 1.3-1.55 µm compared to the area outside of PCS at room temperature. At the same time, the interaction of Ge(Si) islands emission with the BIC-related modes provides the peak PL intensity increase of more than two orders of magnitude. The experimentally measured Q-factor of the PL line associated with the symmetry-protected BIC mode reaches the value of 2600.
RESUMO
A new approach to improve the light-emitting efficiency of Ge(Si) quantum dots (QDs) by the formation of an ordered array of QDs on a pit-patterned silicon-on-insulator (SOI) substrate is presented. This approach makes it possible to use the same pre-patterned substrate both for the growth of spatially ordered QDs and for the formation of photonic crystal (PhC) in which QDs are embedded. The periodic array of deep pits on the SOI substrate simultaneously serves as a template for spatially ordering of QDs and the basis for two-dimensional PhCs. As a result of theoretical and experimental studies, the main regularities of the QD nucleation on the pre-patterned surface with deep pits were revealed. The parameters of the pit-patterned substrate (the period of the location of the pits, the pit shape, and depth) providing a significant increase of the QD luminescence intensity due to the effective interaction of QD emission with the PhC modes are found.