Optimizing Active Sites for High CO Selectivity during CO2 Hydrogenation over Supported Nickel Catalysts.

Controlling the selectivity of CO2 hydrogenation catalysts is a fundamental challenge. In this study, the selectivity of supported Ni catalysts prepared by the traditional impregnation method was found to change after a first CO2 hydrogenation reaction cycle from 100 to 800 °C. The usually high CH4 formation was suppressed leading to full selectivity toward CO. This behavior was also observed after the catalyst was treated under methane or propane atmospheres at elevated temperatures. In situ spectroscopic studies revealed that the accumulation of carbon species on the catalyst surface at high temperatures leads to a nickel carbide-like phase. The catalyst regains its high selectivity to CH4 production after carbon depletion from the surface of the Ni particles by oxidation. However, the selectivity readily shifts back toward CO formation after exposing the catalysts to a new temperature-programmed CO2 hydrogenation cycle. The fraction of weakly adsorbed CO species increases on the carbide-like surface when compared to a clean nickel surface, explaining the higher selectivity to CO. This easy protocol of changing the surface of a common Ni catalyst to gain selectivity represents an important step for the commercial use of CO2 hydrogenation to CO processes toward high-added-value products.

Controlling Reaction Selectivity over Hybrid Plasmonic Nanocatalysts.

The localized surface plasmon resonance (LSPR) excitation in plasmonic nanoparticles has been used to accelerate several catalytic transformations under visible-light irradiation. In order to fully harness the potential of plasmonic catalysis, multimetallic nanoparticles containing a plasmonic and a catalytic component, where LSPR-excited energetic charge carriers and the intrinsic catalytic active sites work synergistically, have raised increased attention. Despite several exciting studies observing rate enhancements, controlling reaction selectivity remains very challenging. Here, by employing multimetallic nanoparticles combining Au, Ag, and Pt in an Au@Ag@Pt core-shell and an Au@AgPt nanorattle architectures, we demonstrate that reaction selectivity of a sequential reaction can be controlled under visible light illumination. The control of the reaction selectivity in plasmonic catalysis was demonstrated for the hydrogenation of phenylacetylene as a model transformation. We have found that the localized interaction between the triple bond in phenylacetylene and the Pt nanoparticle surface enables selective hydrogenation of the triple bond (relative to the double bond in styrene) under visible light illumination. Atomistic calculations show that the enhanced selectivity toward the partial hydrogenation product is driven by distinct adsorption configurations and charge delocalization of the reactant and the reaction intermediate at the catalyst surface. We believe these results will contribute to the use of plasmonic catalysis to drive and control a wealth of selective molecular transformations under ecofriendly conditions and visible light illumination.

Reaction Pathway Dependence in Plasmonic Catalysis: Hydrogenation as a Model Molecular Transformation.

The localized surface plasmon resonance (LSPR) excitation in plasmonic nanoparticles can enhance or mediate chemical transformations. Increased reaction rates for several reactions have been reported due to this phenomenon; however, the fundamental understanding of mechanisms and factors that affect activities remains limited. Here, by investigating hydrogenation reactions as a model transformation and employing different reducing agents, H2 and NaBH4 , which led to different hydrogenation reaction pathways, we observed that plasmonic excitation of Au nanoparticle catalysts can lead to negative effects over the activities. The underlying physical reason was explored using density functional theory calculations. We observed that positive versus negative effects on the plasmonic catalytic activity is reaction-pathway dependent. These results shed important insights on our current understanding of plasmonic catalysis, demonstrating reaction pathways must be taken into account for the design of plasmonic nanocatalysts.

Bioinspired-Metalloporphyrin Magnetic Nanocomposite as a Reusable Catalyst for Synthesis of Diastereomeric (-)-Isopulegol Epoxide: Anticancer Activity Against Human Osteosarcoma Cells (MG-63).

In the present study, we developed a green epoxidation approach for the synthesis of the diastereomers of (-)-isopulegol benzyl ether epoxide using molecular oxygen as the oxidant and a hybrid manganese(III)-porphyrin magnetic reusable nanocomposite as the catalyst. High activity, selectivity, and stability were obtained, with up to four recycling cycles without the loss of activity and selectivity for epoxide. The anticancer effect of the newly synthesized isopulegol epoxide diastereomers was evaluated on a human osteosarcoma cell line (MG-63); both diastereomers showed similar in vitro potency. The measured IC50 values were significantly lower than those reported for other monoterpene analogues, rendering these epoxide isomers as promising anti-tumor agents against low prognosis osteosarcoma.

Economically attractive route for the preparation of high quality magnetic nanoparticles by the thermal decomposition of iron(III) acetylacetonate.

The thermal decomposition (TD) methods are among the most successful in obtaining magnetic nanoparticles with a high degree of control of size and narrow particle size distribution. Here we investigated the TD of iron(III) acetylacetonate in the presence of oleic acid, oleylamine, and a series of alcohols in order to disclose their role and also investigate economically attractive alternatives for the synthesis of iron oxide nanoparticles without compromising their size and shape control. We have found that some affordable and reasonably less priced alcohols, such as 1,2-octanediol and cyclohexanol, may replace the commonly used and expensive 1,2-hexadecanediol, providing an economically attractive route for the synthesis of high quality magnetic nanoparticles. The relative cost for the preparation of Fe3O4 NPs is reduced to only 21% and 9% of the original cost when using 1,2-octanediol and cyclohexanol, respectively.

Insights into the active surface species formed on Ta2O5 nanotubes in the catalytic oxidation of CO.

Freestanding Ta2O5 nanotubes were prepared by an anodizing method. As-anodized amorphous nanotubes were calcined at high temperature to obtain a crystalline phase. All materials were studied by means of BET analysis, XRD, TEM, SEM, XPS, and FTIR and were evaluated in the catalytic oxidation of CO. An XPS study confirmed the formation of different tantalum surface species after high temperature treatment of amorphous Ta2O5 nanotubes. Calcination at 800 °C generated Ta(4+) while higher temperature (1000 °C) treatment led to the formation of Ta(3+) species. These materials also showed significant differences in catalytic activity. Higher activity was observed for samples calcined at 800 °C than at 1000 °C, suggesting that Ta(4+) species are active sites for CO oxidation.

Strategies to improve hydrogen activation on gold catalysts.

Catalytic reactions involving molecular hydrogen are at the heart of many transformations in the chemical industry. Classically, hydrogenations are carried out on Pd, Pt, Ru or Ni catalysts. However, the use of supported Au catalysts has garnered attention in recent years owing to their exceptional selectivity in hydrogenation reactions. This is despite the limited understanding of the physicochemical aspects of hydrogen activation and reaction on Au surfaces. A rational design of new improved catalysts relies on making better use of the hydrogenating properties of Au. This Review analyses the strategies utilized to improve hydrogen-Au interactions, from addressing the importance of the Au particle size to exploring alternative mechanisms for H2 dissociation on Au cations and Au-ligand interfaces. These insights hold the potential to drive future applications of Au catalysis.

Fe3O4@silica-thermolysin: A robust, advantageous, and reusable microbial nanobiocatalyst for proteolysis and milk-clotting.

Thermolysin (TLN) is a microbial highly-priced thermostable metallo-endoprotease with complementary substrate specificity to those of proteases widely used in science and industry for protein digestion and milk-clotting. This study is the first to immobilize TLN on aminated superparamagnetic nanoparticles (Fe3O4@silica-NH2) aiming for higher stability, recoverability, reusability, and applicability in proteolysis and as a microbial rennet-like milk-clotting enzyme. The nanobiocatalyst developed (Fe3O4@silica-TLN) displays hydrolytic activity on a synthetic TLN substrate and, apparently, was fully recovered from reaction media by magnetic decantation. More importantly, Fe3O4@silica-TLN retains TLN catalytic properties in the presence of calcium ions even after exposure to 60 °C for 48 h, storage at 4 °C for 80 days and room temperature for 42 days, use in proteolyses, and in milk-clotting for up to 11 cycles. Its proteolytic activity on bovine milk casein in 24 h furnished 84 peptides, of which 29 are potentially bioactive. Also, Fe3O4@silica-TLN catalyzed the digestion of bovine serum albumin. In conclusion, Fe3O4@silica-TLN showed to be a new, less autolytic, thermostable, non-toxic, magnetically-separable, and reusable nanobiocatalyst with highly attractive properties for both science (peptide/protein chemistry and structure, proteomic studies, and the search for new bioactive peptides) and food industry (cheese manufacture).

Solvent-Free Aerobic Oxidative Cleavage of Methyl Oleate to Biobased Aldehydes over Mechanochemically Synthesized Supported AgAu Nanoparticles.

The performance of mechanochemically synthesized supported bimetallic AgAu nanoalloy catalysts was evaluated in the oxidative cleavage of methyl oleate, a commonly available unsaturated bio-derived raw material. An extensive screening of supports (SiO2 , C, ZrO2 , Al2 O3 ), metallic ratios (Ag : Au), reaction times, temperatures, and use of solvents was carried out. The performance was optimized towards productivity and selectivity for the primary cleavage products (aldehydes and oxoesters). The optimal conditions were achieved in the absence of solvent, using Ag8 Au92 /SiO2 as catalyst, at 80 °C, reaction time of 1 h, substrate to catalyst=555 and 10 bar of molecular oxygen. A strong support effect was observed: the selectivity to aldehydes was best with silica as support, and to esters was best using zirconia. This shows not only that mechanochemical preparation of bimetallic catalysts is a powerful tool to generate useful catalyst compositions, but also that a safe, green, solventless synthesis of bio-derived products can be achieved by aerobic oxidative cleavage.

Design of a dinuclear nickel(II) bioinspired hydrolase to bind covalently to silica surfaces: synthesis, magnetism, and reactivity studies.

Presented herein is the design of a dinuclear Ni(II) synthetic hydrolase [Ni(2)(HBPPAMFF)(µ-OAc)(2)(H(2)O)]BPh(4) (1) (H(2)BPPAMFF = 2-[(N-benzyl-N-2-pyridylmethylamine)]-4-methyl-6-[N-(2-pyridylmethyl)aminomethyl)])-4-methyl-6-formylphenol) to be covalently attached to silica surfaces, while maintaining its catalytic activity. An aldehyde-containing ligand (H(2)BPPAMFF) provides a reactive functional group that can serve as a cross-linking group to bind the complex to an organoalkoxysilane and later to the silica surfaces or directly to amino-modified surfaces. The dinuclear Ni(II) complex covalently attached to the silica surfaces was fully characterized by different techniques. The catalytic turnover number (k(cat)) of the immobilized Ni(II)Ni(II) catalyst in the hydrolysis of 2,4-bis(dinitrophenyl)phosphate is comparable to the homogeneous reaction; however, the catalyst interaction with the support enhanced the substrate to complex association constant, and consequently, the catalytic efficiency (E = k(cat)/K(M)) and the supported catalyst can be reused for subsequent diester hydrolysis reactions.