RESUMO
New chelating resins immobilizing carboxymethylated polyallylamine (CM-PAA) were prepared by immobilizing PAAs with some molecular weights on methacrylate resins and then carboxymethylating a part of amino groups in the PAAs using various amounts of sodium monochloroacetate. The molecular weight of PAA barely affected both the amount of PAA immobilized on the resin and the relationship between the carboxymethylation (CM) rate and the ratio of the amount of monochloroacetate used in the CM step. The selectivity of CM-PAA resin for solid-phase extraction of trace elements was almost the same as that of a resin immobilizing carboxylymethylated polyethyleneimine; 10 elements, namely Cd, Co, Cu, Fe, Mo, Ni, Pb, Ti, V, and Zn, could be quantitatively recovered over a wide pH range and alkali and alkaline earth elements were scarcely extracted under acidic and neutral conditions. The CM-PAA resin was applicable to the separation and preconcentration of the elements in a certified reference material (Waste Water, EU-L-1) and a real environmental water sample (ground water).
RESUMO
Cylinder-type and disk-type sintered materials consisting of Presep PolyChelate, which is a commercially available chelating resin immobilizing carboxymethylated polyethyleneimine as a functional group, and particulate polyethylene as a thermoplastic binder were prepared using a polymer sintering technique. The sintered materials had a continuously porous structure. The sintering process at 130⯰C for 20â¯min did not affect the ability of the chelating resin in the sintered materials; the selectivity of the sintered material was almost the same as that of the particulate chelating resin which was not sintered. The sintering materials could quantitatively extract 11 kinds of trace elements, namely Cd, Co, Cu, Fe, Mn, Mo, Ni, Pb, Ti, V, and Zn, at pH 5.5. When the disk-type sintered material was used, the recoveries of these elements remained almost constant at a flow rate of at least 50â¯mLâ¯min-1; the extracted elements could be eluted using 10â¯mL of 3â¯molâ¯L-1 nitric acid at a flow rate of 5â¯mLâ¯min-1. Solid-phase extraction using the disk-type sintered material was applied to the separation and preconcentration of trace elements prior to their inductively coupled plasma atomic emission spectrometric determination. The method was applicable to analyses of certified reference materials (EnviroMAT ES-L-1 ground water and EU-L-3 waste water) and a commercially available table salt.
RESUMO
The potential of Presep(®) PolyChelate as a chelating resin was studied in detail. The chelating resin with extraction capacity for Cu of 0.30 mmol L(-1) could quantitatively extract Cd, Co, Cu, Fe, Mo, Ni, Pb, V, and Zn at pH 4 or 5.5; however, only very scant amounts of Na, K, Mg, and Ca were captured at pH levels below 7. The quantitative extraction could be achieved in 100 - 1000 mL of artificial seawater and at a flow rate of 3 - 30 mL min(-1). The performance of Presep(®) PolyChelate was compared to the other aminocarboxylic acid-type chelating resins, including Nobias Chelate-PA1, Chelex 100, Muromac B-1, Lewatit TP 207, and NTA Superflow, under the same conditions. The solid-phase extraction of the nine elements in the certified reference material (ES-L-1, ground water) and a commercially available table salt was also demonstrated.