Oxidation of Sulphur pollutants in model and real fuels using hydrodynamic cavitation.

Hydrodynamic Cavitation (HC) offers an attractive platform for intensifying oxidative desulphurization of fuels. In the first part of this work, we present new results on oxidising single ring thiophene in a model fuel over the extended range of volume fraction of organic phase from 2.5 to 80 v/v %. We also present influence of type and scale of HC device on performance of oxidative desulphurization. Further experiments revealed that oxidising radicals generated in-situ by HC alone were not able to oxidise dual ring thiophenes. External catalyst (formic acid) and oxidising agents (hydrogen peroxide, H2O2) were therefore used with HC. Based on our prior work with acoustic cavitation (AC), the volumetric ratios for H2O2 and formic acid were identified as 0.95 v/v % and 6.25 v/v % respectively. The data of oxidation of dual ring thiophenes with n-dodecane and n-hexane as model fuels and typical transport fuels (diesel, kerosene, and petrol) using these oxidant and catalyst is presented. The observed performance with HC was compared with results obtained from a stirred tank and AC set-up. The presented data indicates that HC is able to intensify oxidation of sulphur species. The presented results provide a sound basis for further developments on HC based oxidative desulphurization processes.

Is cavitation a truly sensible choice for intensifying photocatalytic oxidation processes? - Implications on phenol degradation using ZnO photocatalysts.

Phenols are recalcitrant compounds that constitute the majority of organic contaminants in industrial wastewaters. Their removal at large scales require a combination of various processes to reach the desired discharge quality. An extensive body of work has already been published in the area of phenol removal from wastewater, however none of them have focussed on a truly 'sensible' approach for coupling advanced oxidation processes (AOPs). Rather, a higher removal efficiency was targeted by unduly complicating the process by combining multiple AOPs. The most influential AOP as the primary method typically driven by the nature of the pollutant should form the basis for a hybrid AOP followed by a complementary AOP to intensify the oxidation process. This strategy is lacking in current literature. We address this knowledge gap directly by systematically identifying the best hybrid process for ZnO mediated photocatalysis of phenol. Either a cavitation mediated pre-treatment of ZnO or cavitation-photocatalysis-peroxide based hybrid AOP was investigated. While the pre-treatment approach led to >25% increase in phenol oxidation compared to bare ZnO photocatalysis, the hydrodynamic cavitation-photocatalysis-peroxide based system was found to have a cavitational yield 5 times higher than its acoustic cavitation counterpart. A new phenomenon known as the 'pseudo staggered effect' was also observed and established in hydrodynamic cavitation mediated photocatalysis-peroxide hybrid process for the first time. While we demonstrated that cavitation is a truly 'sensible' choice to enhance photocatalysis, the nature of the pollutant under investigation must always be the key driver when designing such hybrid AOPs.

Quantifying OH radical generation in hydrodynamic cavitation via coumarin dosimetry: Influence of operating parameters and cavitation devices.

Hydrodynamic cavitation (HC) has been extensively investigated for effluent treatment applications. Performance of HC devices or processes is often reported in terms of degradation of organic pollutants rather than quantification of hydroxyl (OH) radicals. In this study, generation of OH radicals in vortex based cavitation device using coumarin dosimetry was quantified. Coumarin was used as the chemical probe with an initial concentration of 100 µM (15 ppm). Generation of OH radicals was quantified by analysing generated single hydroxylated products. The influence of operating parameters such as pH and type of acid used to adjust pH, dissolved oxygen, and inlet and outlet pressures was investigated. Acidic pH was found to be more conducive for generating OH radicals and therefore subsequent experiments were performed at pH of 3. Sulphuric acid was found to be more than three times effective than hydrochloric acid in generating OH radicals. Effect of initial levels of dissolved oxygen was found to influence OH radical generation. Performance of vortex based cavitation device was then compared with other commonly used cavitation devices based on orifice and venturi. The vortex based cavitation device was found to outperform the orifice and venturi based devices in terms of initial per-pass factor. Influence of device scale (nominal flow rate through the device) on performance was then evaluated. The results presented for these devices unambiguously quantifies their cavitational performance. The presented results will be useful for evaluating computational models and stimulate further development of predictive computational models in this challenging area.

Removal of single and dual ring thiophene's from dodecane using cavitation based processes.

Utilising cavitation for enhancing oxidative desulphurization has been investigated for nearly-two decades with recent investigations shifting focus from low-capacity acoustic cavitation (AC) to scalable hydrodynamic cavitation (HC). This work focuses on developing a viable means for removing thiophene's from fuels. In the first phase of this work, use of vortex based HC devices for removal of single and dual ring thiophenes from dodecane was investigated. HC was shown to be able to remove single ring thiophene from dodecane without using any external catalyst or additives. However, in absence of catalyst or additives, it was not possible to remove dual ring thiophenes such as dibenzothiophene using HC. Therefore, in the second phase of this work, various strategies based on use of catalyst or additives to augment cavitation based process were investigated. AC based experiments were opted for shortlisting suitable catalysts and additives for intensifying cavitation based processes. The influence of using oxidant (H2O2) and carboxylic acid catalysts on efficacy of removal of dual ring thiophenes is presented. Several conditions were tested, and the optimal volumetric ratios of 0.95 v/v % H2O2 and 6.25 v/v % HCOOH was identified and utilised throughout the remainder of the study. Regeneration of extractant which accumulates oxidised sulphur species from dodecane was also investigated using AC. The additives and process conditions reported in this work are useful for enhancing desulphurization performance.

Estimation of chemical and physical effects of cavitation by analysis of cavitating single bubble dynamics.

Cavitation events create extreme conditions in a localized 'bubble collapse' region, leading to the formation of hydroxyl radicals, shockwaves and microscopic high-speed jets, which are useful for many chemical and physical transformation processes. Single bubble dynamics equations have been used previously to investigate the chemical and physical effects of cavitation. In the present study, the state of the art of the single bubble dynamics equations was reviewed and certain noteworthy modifications were implemented. Simulations reaffirmed previously reported collapse temperatures of the order ~5,000 K and collapse pressures well over ~1,000 bar under varying operating conditions. The chemical effects were assessed in terms of the hydroxyl radical generation rate (OHG), calculated by applying the minimization of the Gibb's Free Energy method using simulated collapse conditions. OHG values as high as 1x1012OH molecules per collapse event were found under certain operating conditions. A new equation was proposed to assess the physical effects, in terms of the impact pressure of the water jet - termed as the jet hammer pressure (JHP), formed due to the asymmetrical collapse of a bubble near a wall. The predicted JHP were found to be within a range of ~100 to 1000 bar under varying operating conditions. Important issues such as the onset of cavitation and chaotic solutions, for a cavitating single bubble dynamics were discussed. The Blake threshold pressure was found to be a sufficient criterion to capture the onset of cavitation. The impact of key operating parameters on the chemical and physical effects of cavitation were investigated exhaustively through simulations, over the parameter ranges relevant to acoustic and hydrodynamic cavitation processes. Presented methodology and results will be useful for optimisation and further investigations of a broad range of acoustic and hydrodynamic cavitation-based applications.