RESUMO
A hybrid metal-semiconductor nanosystem for the generation of THz radiation, based on the fabrication of GaAs quantum molecules-Ga metal nanoparticles complexes through a self assembly approach, is proposed. The role of the growth parameters, the substrate temperature, the Ga and As flux during the quantum dot molecule (QDM) fabrication and the metal nanoparticle alignment are discussed. The tuning of the relative positioning of QDMs and metal nanoparticles is obtained through the careful control of Ga droplet nucleation sites via Ga surface diffusion. The electronic structure of a typical QDM was evaluated on the base of the morphological characterizations performed by atomic force microscopy and cross sectional scanning electron microscopy, and the predicted results confirmed by micro-photoluminescence experiments, showing that the Ga metal nanoparticle-GaAs quantum molecule complexes are suitable for terahertz generation from intraband transition.
RESUMO
In As atmosphere, we analyzed the crystallization dynamics during post-growth annealing of Ga droplets residing at the top of self-assisted GaAs nanowires grown by molecular beam epitaxy. The final crystallization steps, fundamental to determining the top facet nanowire morphology, proceeded via a balance of Ga crystallization via vapor-liquid-solid and layer-by-layer growth around the droplet, promoted by Ga diffusion out of the droplet perimeter, As desorption, and diffusion dynamics. By controlling As flux and substrate temperature the transformation of Ga droplets into nanowire segments with a top surface flat and parallel to the substrate was achieved, thus opening the possibility to realize atomically sharp vertical heterostructures in III-As self-assisted nanowires through group III exchange.
RESUMO
We present the fabrication of axial InAs/GaAs nanowire heterostructures on silicon with atomically sharp interfaces by molecular beam epitaxy. Our method exploits the crystallization at low temperature, by As supply, of In droplets deposited on the top of GaAs NWs grown by the self-assisted (self-catalyzed) mode. Extensive characterization based on transmission electron microscopy sets an upper limit for the InAs/GaAs interface thickness within few bilayers (≤1.5 nm). A detailed study of elastic/plastic strain relaxation at the interface is also presented, highlighting the role of nanowire lateral free surfaces.
RESUMO
Resonant sensors with nanostructured surfaces have long been considered as an emergent platform for high-sensitivity transduction because of the potentially very large sensing areas. Nevertheless, until now only complex, time-consuming, expensive and sub-optimal fabrication procedures have been described; in fact, especially with reference to in-liquid applications, very few devices have been reported. Here, we first demonstrate that, by immersing standard, ultra-low-cost quartz resonators with un-polished silver electrodes in a conventional zinc nitrate/HMTA equimolar nutrient solution, the gentle contamination from the metallic package allows direct growth on the electrodes of arrays of high-density (up to 10 µm⻲) and well-separated (no fusion at the roots) ZnO nanowires without any seed layer or thermal annealing. The combination of high-density and good separation is ideal for increasing the sensing area; moreover, this uniquely simple, single-step process is suitable for conventional, ultra-low-cost and high-frequency quartzes, and results in devices that are already packaged and ready to use. As an additional advantage, the process parameters can be effectively optimized by measuring the quartz admittance before and after growth. As a preliminary test, we show that the sensitivity to the liquid properties of high-frequency (i.e. high sensitivity) quartzes can be further increased by nearly one order of magnitude and thus show the highest ever reported frequency shifts of an admittance resonance in response to immersion in both ethanol and water.