Nonlinear Frequency Modulation for Fourier Transform Ion Mobility Mass Spectrometry Improves Experimental Efficiency.

Through optimization of terminal frequencies and effective sampling rates, we have developed nonlinear sawtooth-shaped frequency sweeps for efficient Fourier transform ion mobility mass spectrometry (FT-IM-MS) experiments. This is in contrast to conventional FT-IM-MS experiments where ion gates are modulated according to a linear frequency sweep. Linear frequency sweeps are effective but can be hindered by the amount of useful signal obtained using a single sweep over a large frequency range imposed by ion gating inefficiencies, particularly small ion packets, and gate depletion. These negative factors are direct consequences of the inherently low gate pulse widths of high-frequency ion gating events, placing an upper bound on FT-IM-MS performance. Here, we report alternative ion modulation strategies. Sawtooth frequency sweeps may be constructed for the purpose of either extending high-SNR transients or conducting efficient signal-averaging experiments for low-SNR transients. The data obtained using this approach show high-SNR signals for a set of low-mass tetraalkylammonium salts (<1000 m/z) where resolving powers in excess of 500 are achieved. Data for low-SNR obtained for multimeric protein complexes streptavidin (53 kDa) and GroEL (800 kDa) also reveal large increases in the signal-to-noise ratio for reconstructed arrival time distributions.

Optimization of a Digital Mass Filter for the Isolation of Intact Protein Complexes in Stability Zone 1,1.

Digital mass filters are advantageous for the analysis of large molecules due to the ability to perform ion isolation of high-m/z ions without the generation of very high radio frequency (RF) and DC voltages. Experimentally determined Mathieu stability diagrams of stability zone 1,1 for capacitively coupled digital waveforms show a voltage offset between the quadrupole rod pairs is introduced by the capacitors which is dependent on the voltage magnitude of the waveform and the duty cycle. This changes the ion's a value from a = 0 to a < 0. These effects are illustrated for isolation for single-charge states for various protein complexes up to 800 kDa (GroEL) for stability zone 1,1. Isolation resolving power (m/Δm) of approximately 280 was achieved for an ion of m/z 12,315 (z = 65+ for 800.5 kDa GroEL D398A), which corresponds to an m/z window of 44.

Fourier Transform-Ion Mobility Linear Ion Trap Mass Spectrometer Using Frequency Encoding for Recognition of Related Compounds in a Single Acquisition.

Fourier transform-ion mobility spectrometry is implemented by coupling a 3D-printed drift tube ion mobility spectrometer, operated at atmospheric pressure, to a linear ion trap mass spectrometer. FT-IMS separations are demonstrated for tetraalkylammonium salts, explosives, fentanyls, and amphetamines. Mobility resolving powers of up to 17 are measured for the tetraalkylammonium cations. When ions are fragmented in the FT-IMS mode, the product ions maintain the frequency and amplitude relationships established during the mobility measurement. Therefore, precursors and product ion relationships can be identified through the mobility information. Using in-source activation for nonspecific fragmentation of all precursors, functional group families of precursors and product ions are identified in a single acquisition. The identity of the precursor ion is not known a priori, but the m/z values for both precursors and product ions are measured.

High-throughput, low-cost reaction screening using a modified 3D printer.

We describe a reaction screening system, based on a 96-well array, and scaled to suit use on the individual scientist's bench. The system was built by modifying a desktop 3D printer and fitting it with a glass syringe and microtiter plate. The effects of experimental variables were characterized, and the performance of the system was optimized. Precise volumes of reaction mixtures (<3% CV) were dispensed into the 96-well array in ca. 40 minutes. The system was used to screen reagents and solvents for the N-alkylation, Katritzky transamination, and Suzuki cross-coupling reactions. Product distributions derived from electrospray mass spectra and represented as heat maps facilitated recognition of optimum conditions. Screening of 96 reaction mixtures was completed in the modest time of approximately 105 minutes (∼65 seconds per reaction mixture). The system is constructed from open-source software and inexpensive 3D printer hardware.

Increasing Isolation Efficiency Using a Segmented Quadrupole Mass Filter Operated with Rectangular Waveforms.

The performance of a segmented quadrupole mass filter operated with rectangular waveforms and capacitively coupled rectangular waveforms applied to the prefilters was examined on a home-built quadrupole-Orbitrap platform. For peak widths of 50 m/z, 100% isolation efficiency was achieved, which fell to approximately 20% for 5 m/z peak width for a rectangular waveform of 150 V0-p. Due to a small exit aperture following the mass filter, peak structure was observed in both experimental peak shapes and those simulated using SIMION. A larger radius quadrupole was examined and achieved similar performance. While the segmented quadrupole does remove the defocusing effects of the fringing fields, the ion beam is only slightly refocused due to the low RF voltage which limits achievable gains in isolation efficiency.

Modified Ion Source for the Improved Collisional Activation of Protein Complexes.

The analysis of large molecules is challenging, as they often have salts and adducts retained through the electrospray process, which increase the observed mass and compromise the achievable mass resolution. Mild collisional activation has been shown to be very effective for the removal of adducts and increases both measurement accuracy and mass resolution of large (>100 kDa) protein complexes. Collisionally activated protein ions are more completely desolvated due to the increased number of collisions when trapped following activation. A short square quadrupole maintained at 300 mTorr by a mechanical pump was added between the ion funnel and transmission quadrupole. This configuration and operation effectively removed adducts from the 800 kDa tetradecamer GroEL as well as fragmented smaller protein complexes like C-reactive protein. Due to the gas high pressure, ions of low size-to-charge ratio, such as those in charge reducing buffers, had low ejection efficiency. We show that segmenting the quadrupole rods greatly improves signal intensity for charge reduced GroEL D398A mutant compared to nonsegmented rods when operating at high pressure.

Atmospheric Pressure Drift Tube Ion Mobility Spectrometry Coupled with Two-Dimensional Tandem Mass Spectrometry.

Atmospheric pressure drift tube ion mobility was coupled with two-dimensional tandem mass spectrometry (2D MS/MS) in a linear ion trap to simultaneously collect ion mobility and the entire MS/MS data domain. Utilizing ion intensities from precursor ion and neutral loss scan lines, ion mobility spectra of multiple compounds with particular functional groups were acquired in a single experiment. Functional group-specific ion mobility spectra were demonstrated for a standard mixture of lipids. Additionally, ion mobility was used to separate isobaric ions prior to 2D MS/MS. The combination of these two methods offers improvements for the analysis of complex mixtures.

Implementing Digital-Waveform Technology for Extended m/z Range Operation on a Native Dual-Quadrupole FT-IM-Orbitrap Mass Spectrometer.

Here, we describe a digital-waveform dual-quadrupole mass spectrometer that enhances the performance of our drift tube FT-IMS high-resolution Orbitrap mass spectrometer (MS). The dual-quadrupole analyzer enhances the instrument capabilities for studies of large protein and protein complexes. The first quadrupole (q) provides a means for performing low-energy collisional activation of ions to reduce or eliminate noncovalent adducts, viz., salts, buffers, detergents, and/or endogenous ligands. The second quadrupole (Q) is used to mass-select ions of interest for further interrogation by ion mobility spectrometry and/or collision-induced dissociation (CID). Q is operated using digital-waveform technology (DWT) to improve the mass selection compared to that achieved using traditional sinusoidal waveforms at floated DC potentials (>500 V DC). DWT allows for increased precision of the waveform for a fraction of the cost of conventional RF drivers and with readily programmable operation and precision (Hoffman, N. M. . A comparison-based digital-waveform generator for high-resolution duty cycle. Review of Scientific Instruments 2018, 89, 084101).

Ion Manipulation in Open Air Using 3D-Printed Electrodes.

Ambient ionization techniques provide a way to sample materials via creation of ions in the air. However, transferring and focusing of these ions is typically done in the reduced pressure environment of the mass spectrometer. Spray-based ambient ionization sources require relatively large distances between the source and mass spectrometer inlet for effective desolvation, resulting in a small fraction of the ions being collected. To increase the efficiency of ion transfer from atmosphere to vacuum, 3D-printed focusing devices made of conductive carbon nanotube doped polymers have been designed and evaluated for ion focusing in air. Three main classes of electrodes are considered: (i) conic section electrodes (conical, ellipsoidal, and cylindrical), (ii) simple conductive and non-conductive apertures, and (iii) electrodes with complex geometries (straight, chicane, and curved). Simulations of ion trajectories performed using the statistical diffusion simulation (SDS) model in SIMION showed a measure of agreement with experiment. Cross-sectional images of ion beams were captured using an ion detecting charge-coupled device (IonCCD). After optimization, the best arrangements of electrodes were coupled to an Agilent Ultivo triple quadrupole to record mass spectra. Observations suggest that electrode geometry strongly influences ion trajectories in air. Non-conductive electrodes also assisted in focusing, due to charge buildup from ion deposition. We also observed minimal spreading of the ion packet after exiting the focusing electrodes indicating that atmospheric collisions do not reduce collimation of the beam. The study suggests that high pressures need not be viewed as a hindrance to ion transport, but as a potentially useful force.

Precursor and Neutral Loss Scans in an RF Scanning Linear Quadrupole Ion Trap.

Methodology for performing precursor and neutral loss scans in an RF scanning linear quadrupole ion trap is described and compared to the unconventional ac frequency scan technique. In the RF scanning variant, precursor ions are mass selectively excited by a fixed frequency resonance excitation signal at low Mathieu q while the RF amplitude is ramped linearly to pass ions through the point of excitation such that the excited ion's m/z varies linearly with time. Ironically, a nonlinear ac frequency scan is still required for ejection of the product ions since their frequencies vary nonlinearly with the linearly varying RF amplitude. In the case of the precursor scan, the ejection frequency must be scanned so that it is fixed on a product ion m/z throughout the RF scan, whereas in the neutral loss scan, it must be scanned to maintain a constant mass offset from the excited precursor ions. Both simultaneous and sequential permutation scans are possible; only the former are demonstrated here. The scans described are performed on a variety of samples using different ionization sources: protonated amphetamine ions generated by nanoelectrospray ionization (nESI), explosives ionized by low-temperature plasma (LTP), and chemical warfare agent simulants sampled from a surface and analyzed with swab touch spray (TS). We lastly conclude that the ac frequency scan variant of these MS/MS scans is preferred due to electronic simplicity. In an accompanying manuscript, we thus describe the implementation of orthogonal double resonance precursor and neutral loss scans on the Mini 12 using constant RF voltage. Graphical Abstract ᅟ.

Electronic π-to-π* Excitations of Rhodamine Dyes Exhibit a Time-Dependent Kohn-Sham Theory "Cyanine Problem".

The longest-wavelength π-to-π* electronic excitations of rhodamine-like dyes (RDs) with different group 16 heteroatoms (O, S, Se, Te) have been investigated. Time-dependent Kohn-Sham theory (TDKST) calculations were compared with coupled-cluster (CC) and equations-of-motion (EOM) CC results for π-to-π* singlet and triplet excitations. The RDs exhibit characteristics in the TDKST calculations that are very similar to previously investigated cyanine dyes, in the sense that the singlet energies obtained with nonhybrid functionals are too high compared with the CC results at the SD(T) level. The errors became increasingly larger for functionals with increasing amounts of exact exchange. TDKST with all tested functionals led to severe underestimations of the corresponding triplet excitations and overestimations of the singlet-triplet gaps. Long-range-corrected range-separated exchange and "optimal tuning" of the range separation parameter did not significantly improve the TDKST results. A detailed analysis suggests that the problem is differential electron correlation between the ground and excited states, which is not treated sufficiently by the relatively small integrals over the exchange-correlation response kernel that enter the excitation energy expression. Numerical criteria are suggested that may help identify "cyanine-like" problems in TDKST calculations of excitation spectra.