RESUMO
The Multiple Chamber Aerosol Chemical Aging Study (MUCHACHAS) tested the hypothesis that hydroxyl radical (OH) aging significantly increases the concentration of first-generation biogenic secondary organic aerosol (SOA). OH is the dominant atmospheric oxidant, and MUCHACHAS employed environmental chambers of very different designs, using multiple OH sources to explore a range of chemical conditions and potential sources of systematic error. We isolated the effect of OH aging, confirming our hypothesis while observing corresponding changes in SOA properties. The mass increases are consistent with an existing gap between global SOA sources and those predicted in models, and can be described by a mechanism suitable for implementation in those models.
Assuntos
Aerossóis/química , Compostos Orgânicos/química , Atmosfera , Radicais Livres , Radical Hidroxila , Espectrometria de Massas/métodos , Modelos Químicos , Oxigênio/química , Ozônio , Reprodutibilidade dos Testes , Solventes/química , Raios UltravioletaRESUMO
Air pollution in the urban environment is a major concern. The ambient concentrations depend on the levels of transboundary imported pollution, the intensity of local sources and the prevailing atmospheric conditions. This work studies the relative impact of two atmospheric variables-atmospheric stability and regional scale turbulence-in determining the air pollution concentrations. We considered a setting (downtown Haifa, Israel) impacted by a large variety of sources, emitting pollutants with different chemical attributes and atmospheric life times. We found that traffic accounts for most of the locally produced pollution in the study location. However, the meteorological factors can overwhelm its impact and dictate the concentrations. The switch from stable to convective conditions and the more vigorous daytime wind are associated with a premature end of the morning peak concentrations that result from rush hour emissions of NOx, Black Carbon (BC) and ultra-fine particles. It results in daytime concentration which are lower than (winter) or equal to (summer) those at night, in spite of the much lower night-time traffic volumes. Similar, albeit weaker, impact was detected in the benzene and toluene concentrations. Sources outside the study area are responsible for most of the CO, PM1 and PM2.5 concentrations but during winter nights, characterised by strong atmospheric stability and low turbulence, their concentrations are elevated due to the local emissions. We developed a diagnostic statistical nonlinear model for the pollutant concentrations, which points to a stronger association of the atmospheric stability with the concentrations during stable conditions but turbulence dominating during convective conditions. Our findings explain the relatively low overall concentrations of locally emitted pollutants in the study area but warn of the potential for high concentrations during night-time in locations with comparable meteorological conditions.
RESUMO
Airborne mineral dust particles serve as cloud condensation nuclei (CCN), thereby influencing the formation and properties of warm clouds. It is therefore of atmospheric interest how dust aerosols with different mineralogy behave when exposed to high relative humidity (RH) or supersaturation (SS) with respect to liquid water. In this study the subsaturated hygroscopic growth and the supersaturated cloud condensation nucleus activity of pure clays and real desert dust aerosols were determined using a hygroscopicity tandem differential mobility analyzer (HTDMA) and a cloud condensation nuclei counter (CCNC), respectively. Five different illite, montmorillonite and kaolinite clay samples as well as three desert dust samples (Saharan dust (SD), Chinese dust (CD) and Arizona test dust (ATD)) were investigated. Aerosols were generated both with a wet and a dry disperser. The water uptake was parameterized via the hygroscopicity parameter kappa. The hygroscopicity of dry generated dust aerosols was found to be negligible when compared to processed atmospheric aerosols, with CCNC derived kappa values between 0.00 and 0.02 (the latter corresponds to a particle consisting of 96.7% by volume insoluble material and approximately 3.3% ammonium sulfate). Pure clay aerosols were generally found to be less hygroscopic than natural desert dust particles. The illite and montmorillonite samples had kappa approximately 0.003. The kaolinite samples were less hygroscopic and had kappa=0.001. SD (kappa=0.023) was found to be the most hygroscopic dry-generated desert dust followed by CD (kappa=0.007) and ATD (kappa=0.003). Wet-generated dust showed an increased water uptake when compared to dry-generated samples. This is considered to be an artifact introduced by redistribution of soluble material between the particles. Thus, the generation method is critically important when presenting such data. These results indicate any atmospheric processing of a fresh mineral dust particle which leads to the addition of more than approximately 3% soluble material will significantly enhance its hygroscopicity and CCN activity.
Assuntos
Aerossóis/química , Silicatos de Alumínio/química , Atmosfera/análise , Atmosfera/química , Poeira/análise , Material Particulado/química , Água/química , Absorção , Argila , Simulação por Computador , Clima Desértico , Gases/química , Tamanho da Partícula , Transição de FaseRESUMO
Hygroscopic properties of secondary organic aerosol (SOA) formed by photooxidation of different concentrations (10-27 or 220-270 ppb) of alpha-pinene precursor were investigated at different relative humidities (RH) using a hygroscopicity tandem differential mobility analyzer (HTDMA, RH=95-97%) and using the mobile version of the Leipzig Aerosol Cloud Interaction Simulator (LACIS-mobile, RH=98-99.3%). In addition, the cloud condensation nuclei (CCN) activity was measured applying two CCN counters (CCNC). An apparent single-hygroscopicity parameter, kappa, of approximately 0.09, approximately 0.07-0.13, and approximately 0.02-0.04 was derived from CCNC, HTDMA and LACIS data, respectively, assuming the surface tension of pure water. Closure between HTDMA and CCNC data was achieved within experimental uncertainty, whereas closure between LACIS and CCNC was only achieved by assuming a concentration-dependent surface tension reduction, consequently resulting in lower CCNC-derived kappa values. Comparing different experimental techniques at varying precursor concentrations in more detail reveals further open questions. Varying precursor concentration influences hygroscopic growth factors at subsaturated RH, while it has no effect on the CCN activation. This difference in behaviour might be caused by precursor concentration-dependent surface tension depression or changing droplet solution concentration dependence of the water activity coefficient with varying SOA composition. Furthermore, evidence was found that the SOA might need several seconds to reach the equilibrium growth factor at high RH.
Assuntos
Aerossóis/química , Atmosfera/química , Compostos Orgânicos/química , Material Particulado/química , Gases/química , Modelos Químicos , Tamanho da Partícula , Transição de Fase , MolhabilidadeRESUMO
Proton-transfer-reaction mass spectrometry (PTR-MS) is a useful tool in ambient trace gas analysis, especially for the analysis of oxygenated volatile organic compounds (OVOC). Many OVOCs are produced during photooxidation of volatile organic compounds and contribute to both the gas phase and secondary organic aerosols (SOA). The inlet system of the PTR-MS instrument was modified to allow also for the measurement of the particulate phase of an aerosol with a high time resolution. The new inlet consists mainly of a denuder to strip off the gas phase, and a heater (120/150 degrees C) to vaporize the aerosol particles. This inlet system was tested with pinonic acid particles generated with a nebulizer and SOA particles formed during the photooxidation of 1,3,5-trimethylbenzene and alpha-pinene with NO(x) in a smog chamber. The performance of this new technique is discussed and the partitioning coefficients for the oxidation products are estimated.