RESUMO
In orthopedics and dentistry, there is an urgent need to obtain low-stiffness implants that suppress the stress shielding caused by the use of metallic implants. In this study, we aimed to fabricate alloys that can reduce the stiffness by increasing the strength while maintaining a low Young's modulus based on the metastable ß-Ti alloy. We designed alloys in which Ti was partially replaced by Zr based on the ISO-approved metastable ß-Ti alloy Ti-15Mo-5Zr-3Al. All alloys prepared by arc melting and subsequent solution treatment showed a single ß-phase solid solution, with no formation of the ω-phase. The alloys exhibited a low Young's modulus equivalent to that of Ti-15Mo-5Zr-3Al and a high strength superior to that of Ti-15Mo-5Zr-3Al and Ti-6Al-4V. This strengthening was presumed to be due to solid-solution strengthening. The biocompatibility of the alloys was as good as or better than that of Ti-6Al-4V. These alloys have potential as metallic materials suitable for biomedical applications.
RESUMO
This study investigates the nanostructural properties of pseudo-binary Al-1.0Mg2Si (mass%) alloys with and without 0.5Cu using transmission electron microscopy (TEM) and small-angle neutron scattering (SANS). The TEM results show that both alloys exhibit extra electron diffraction spots related to MgSiMg second clusters at peak-aged conditions. High-resolution TEM images have revealed that the second cluster exists as a needle-shaped precipitate that is shorter and thicker than the ßâ³ phase. We found that the second cluster, which we referred to as the R phase in this paper, is more likely to form partially along the longitudinal axis of a random-type precipitate. Thus, the atomic arrangement in the random-type precipitate is not completely random. SANS is used to quantify the size and volume fraction of the observed needle-shaped precipitates since the R phase is difficult to observe with TEM. The R phase forms even in the Cu-free alloy, but the volume fraction is low, and the growth and formation are retarded near the peak-aged conditions. Undoubtedly, the Cu addition has the effect of stabilizing the growth of the R phase and also promoting its formation. Therefore, the R phase also contributes to the increase in hardness at both under- and peak-aged conditions in the Cu-containing alloy in addition to the strengthening ßâ³ phases.