Polarization-dependent vibrational shifts on dielectric substrates.

The interaction of light with matter at surfaces of dielectrics strongly depends on polarization. Here, we present the first infrared spectroscopic evidence for significant polarization effects in the spectroscopic detection of adsorbate vibrational frequencies. In addition to much larger peak intensities for p-polarized light relative to s-polarization, a small but distinct blue shift was identified for CO adsorbed at the surfaces of two prototype dielectric substrates, CeO2(111) and CaCO3(10.4). A simulation using a layer model yields very good agreement with experiment.

Enhancing the photoluminescence of surface anchored metal-organic frameworks: mixed linkers and efficient acceptors.

We present two approaches to enhance the photoluminescence quantum yield (PLQY) of surface-anchored metal-organic frameworks (SURMOFs). In the first approach we fabricate SURMOFs from a mix of an emissive linker with an optically-inert linker of equivalent length, diluting the emissive linker while maintaining the SURMOF structure. This approach enhances the internal PLQY. However, the increase in internal PLQY is achieved at the expense of a drastic reduction in optical absorption, thus the external PLQY remains low. To overcome this limitation, a second approach is explored wherein energy-accepting guest chromophores are infiltrated into the framework of the active linker. At the correct acceptor concentration, an internal PLQY of 52% - three times higher than the previous approach - is achieved. Additionally, the absorption remains strong leading to an external PLQY of 8%, an order of magnitude better than the previous approach. Using this strategy, we demonstrate that SURMOFs can achieve PLQYs similar to their precursor chromophores in solution. This is of relevance to SURMOFs as emitter layers in general, and we examine the optimized emitter layer as part of a photon upconversion (UC) SURMOF heterostructure. Surprisingly, the same PLQY is not observed after triplet-triplet annihilation in the UC heterostructure as after its normal photoexcitation (although the UC layers exhibit low thresholds consistent with those reported in our previous work). We discuss the potential bottlenecks in energy transport that could lead to this unexpected reduction in PLQY after excitation via triplet-triplet annihilation, and how future design of SURMOF UC multilayers could overcome these limitations.

Self-assembled monolayers of benzylmercaptan and para-cyanobenzylmercaptan on gold: surface infrared spectroscopic characterization.

Self-assembled monolayers (SAMs) on gold substrates were prepared from benzylmercaptan (BM) and para-cyanobenzylmercaptan (pCBM), and the resulting surfaces were investigated using conventional infrared reflection-absorption spectroscopy (IRRAS) as well as polarization modulation infrared reflection-absorption spectroscopy (PM-IRRAS). IRRAS data are analyzed by comparison with transmission IR spectra and theoretical (DFT) simulations. The spectroscopic results indicate the presence of well-ordered monolayers of BM and pCBM with an orientation perpendicular to the surface. IRRAS and PM-IRRAS data are compared to each other and the respective merits of both methods are discussed.

Doping-Induced Electron Transfer at Organic/Oxide Interfaces: Direct Evidence from Infrared Spectroscopy.

Charge transfer at organic/inorganic interfaces critically influences the properties of molecular adlayers. Although for metals such charge transfers are well documented by experimental and theoretical results, in the case of semiconductors, clear and direct evidence for a transfer of electrons or holes from oxides with their typically high ionization energy is missing. Here, we present data from infrared reflection-absorption spectroscopy demonstrating that despite a high ionization energy, electrons are transferred from ZnO into a prototype strong molecular electron acceptor, hexafluoro-tetracyano-naphthoquinodimethane (F6-TCNNQ). Because there are no previous studies of this type, the interpretation of the pronounced vibrational red shifts observed in the experiment was aided by a thorough theoretical analysis using density functional theory. The calculations reveal that two mechanisms govern the pronounced vibrational band shifts of the adsorbed molecules: electron transfer into unoccupied molecular levels of the organic acceptor and also the bonding between the surface Zn atoms and the peripheral cyano groups. These combined experimental data and the theoretical analysis provide the so-far missing evidence of interfacial electron transfer from high ionization energy inorganic semiconductors to molecular acceptors and indicates that n-doping of ZnO plays a crucial role.

Reduction of copper in porous matrixes. Stepwise and autocatalytic reduction routes.

The reduction of Cu(II) oxide species in siliceous matrixes of different porosity (MFI, FAU, MCM-48) and in alumosilicate MFI was studied by temperature-programmed reduction in hydrogen (TPR), by X-ray absorption fine structure (after stationary hydrogen treatments), and by transmission electron microscopy. It was found that the reduction may proceed in one or in two reduction steps. The two-step scheme known for zeolites was observed also for Cu(II) in siliceous microporous matrixes, with similar temperature of Cu(II) reduction onset as for the alumosilicate MFI. Therefore, the two-step scheme cannot be explained by the stabilization of Cu ions by intra-zeolite electrical fields. CuOx clusters in MCM-48 were reduced in a one-step scheme (similar to bulk CuO) at high Cu content (6 wt %) but in a two-step scheme at low Cu content (1 wt %). The two reduction steps observed with most samples cannot be identified with the transitions of all Cu(II) to Cu(I) and of Cu(I) to Cu(0). Instead, Cu(0) nuclei were observed already at low reduction temperatures and were found to coexist with Cu ions over temperature ranges of different extension. This coexistence range was narrow in materials that favor aggregation of the Cu nuclei into particles: Cu-MCM-48 of low Cu content and Cu-ZSM-5. In the latter, metal segregation from the pore system was found to be accompanied by an autocatalytic initiation of the second reduction step. In the siliceous microporous matrixes, the Cu(0) nuclei were observed to coexist with Cu ions over wide temperature ranges (100 K for MFI) at temperatures far above that of Cu reduction in the bulk oxide. These observations suggest that oligomeric Cu metal nuclei which may have been formed, e.g., at the intersections of the MFI channel system, may be unable to activate hydrogen, which would be required for rapid reduction of the coexisting Cu ions.

Atomically precise semiconductor--graphene and hBN interfaces by Ge intercalation.

The full exploration of the potential, which graphene offers to nanoelectronics requires its integration into semiconductor technology. So far the real-world applications are limited by the ability to concomitantly achieve large single-crystalline domains on dielectrics and semiconductors and to tailor the interfaces between them. Here we show a new direct bottom-up method for the fabrication of high-quality atomically precise interfaces between 2D materials, like graphene and hexagonal boron nitride (hBN), and classical semiconductor via Ge intercalation. Using angle-resolved photoemission spectroscopy and complementary DFT modelling we observed for the first time that epitaxially grown graphene with the Ge monolayer underneath demonstrates Dirac Fermions unaffected by the substrate as well as an unperturbed electronic band structure of hBN. This approach provides the intrinsic relativistic 2D electron gas towards integration in semiconductor technology. Hence, these new interfaces are a promising path for the integration of graphene and hBN into state-of-the-art semiconductor technology.

Synthesis of polycyclic aromatic hydrocarbons and graphite islands via surface-induced reaction of small molecules.

Attractive materials for molecular electronics are the polycyclic aromatic hydrocarbons (PAHs), the hydrogen-terminated segments of a graphitic plane. Since the processing of larger PAHs, for example hexa-peri-hexabenzocoronene, is complicated by their extremely low solubilities and very small vapor pressures, the possibility of a surface-assisted synthesis of planar PAHs is investigated starting from diphenylacetylene (left) and hexaphenylbenzene (right), as shown in the picture.

Electrochemical investigation of covalently post-synthetic modified SURGEL coatings.

Thiol-yne click chemistry is used to covalently link a ferrocenyl derivative to the pore walls of a fully organic porous polymer coating (SURGEL). By cyclic voltammetry, it is demonstrated that the ferrocene bound to the SURGEL via a flexible alkyl linker can be reversibly reduced and oxidised. Surprisingly, when adding ferrocene as an electrolyte, a Nernstian diffusion limited process is observed. We explain this observation in terms of a high permeability of the SURGELs for ferrocene after the post synthetic modification.

Carbon nanowalls: the next step for physical manifestation of the black body coating.

The optical properties of carbon nanowall (CNW) films in the visible range have been studied and reported for the first time. Depending on the film structure, ultra-low total reflectance up to 0.13% can be reached, which makes the CNW films a promising candidate for the black body-like coating, and thus for a wide range of applications as a light absorber. We have estimated important trends in the optical property variation from sample to sample, and identified the presence of edge states and domain boundaries in carbon nanowalls as well as the film mass density variation as the key factors. Also we demonstrated that at much lower film thickness and density than for a carbon nanotube forest the CNWs yield one order higher specific light absorption.

MOF-on-MOF heteroepitaxy: perfectly oriented [Zn2(ndc)2(dabco)]n grown on [Cu2(ndc)2(dabco)]n thin films.

We report the successful heteroepitaxial growth of perfectly oriented hybrid MOF thin films. By employing step-by-step liquid-phase epitaxy (LPE), [Zn(2)(ndc)(2)(dabco)](n) was grown on [Cu(2)(ndc)(2)(dabco)](n), thus demonstrating that the MOF-on-MOF deposition scheme developed for powdered microcrystalline MOF materials can also be applied in connection with LPE for MOF thin films or multilayers. The deposition was monitored by surface plasmon resonance (SPR) spectroscopy, the resulting MOF heterostructures were characterized using IR spectroscopy and different types of X-ray diffraction (XRD)-based techniques. The results suggest that the LPE method is a promising way to fabricate and grow MOF heterostructures, and also demonstrates the potential of [Cu(2)(ndc)(2)(dabco)](n) MOF thin films as substrates for the LPE-based growth of different MOFs on top.