RESUMO
The CuGaTe2 thermoelectric material has garnered widespread attention as an inexpensive and nontoxic material for mid-temperature thermoelectric applications. However, its development has been hindered by its low intrinsic carrier concentration and high thermal conductivity. This study investigates the band structure and thermoelectric properties of (CuGaTe2)1-x (ZnSe)x (x = 0, 0.25%, 0.5%, 1%, 1.5%, and 2%). The research revealed that the incorporation of Zn and Se atoms enhanced the level of band degeneracy and electron density of states near Fermi level, significantly raising carrier concentration through the formation of ZnGa- point defects. Simultaneously, when the doping content reached 1.5%, the ZnTe second phase emerged, collaborating with point defects and high-density dislocations, effectively scattering phonons and substantially reducing lattice thermal conductivity. Therefore, introducing ZnSe can simultaneously optimize the material's electrical and thermal transport properties. The (CuGaTe2)0.985(ZnSe)0.015 sample reaches peak ZT of 1.32 at 823 K, representing a 159% increase compared to pure CuGaTe2.
RESUMO
Incorporating donor doping into Mg3Sb1.5Bi0.5 to achieve n-type conductivity is one of the crucial strategies for performance enhancement. In pursuit of higher thermoelectric performance, we herein report co-doping with Te and Y to optimize the thermoelectric properties of Mg3Sb1.5Bi0.5, achieving a peak ZT exceeding 1.7 at 703 K in Y0.01Mg3.19Sb1.5Bi0.47Te0.03. Guided by first-principles calculations for compositional design, we find that Te-doping shifts the Fermi level into the conduction band, resulting in n-type semiconductor behavior, while Y-doping further shifts the Fermi level into the conduction band and reduces the bandgap, leading to enhanced thermoelectric performance with a power factor as high as >20 µW cm-1 K-2. Additionally, through detailed micro/nanostructure characterizations, we discover that Te and Y co-doping induces dense crystal and lattice defects, including local lattice distortions and strains caused by point defects, and densely distributed grain boundaries between nanocrystalline domains. These defects efficiently scatter phonons of various wavelengths, resulting in a low thermal conductivity of 0.83 W m-1 K-1 and ultimately achieving a high ZT. Furthermore, the dense lattice defects induced by co-doping can further strengthen the mechanical performance, which is crucial for its service in devices. This work provides guidance for the composition and structure design of thermoelectric materials.
RESUMO
Optimizing the performance of thermoelectric materials by reducing its thermal conductivity is crucial to enhance its thermoelectric efficiency. Novel thermoelectric materials like the CuGaTe2 compound are hindered by high intrinsic thermal conductivity, which negatively impacts its thermoelectric performance. In this paper, we report that the introduction of AgCl by the solid-phase melting method will influence the thermal conductivity of CuGaTe2. The generated multiple scattering mechanisms are expected to reduce the lattice thermal conductivity while maintaining sufficient good electrical properties. The experimental results were supported by first-principles calculations confirming that the doping of the Ag will decrease the elastic constants, bulk modulus, and shear modulus of CuGaTe2, which makes the mean sound velocity and Debye temperature of Ag-doped samples lower than those of CuGaTe2, indicating the lower lattice thermal conductivity. In addition, the Cl elements within the CuGaTe2 matrix escaping during the sintering process will create holes of various sizes within the sample. These combined effects of holes and impurities will induce phonon scattering, which further reduces the lattice thermal conductivity. Based on our findings, we conclude that the introduction of AgCl into CuGaTe2 has shown a lower thermal conductivity without compromising the electrical performance, resulting in an ultra-high ZT value of 1.4 in the (CuGaTe2)0.96(AgCl)0.04 sample at 823 K.
RESUMO
Mg3Sb2-based thermoelectric materials can convert heat and electricity into each other, making them a promising class of environmentally friendly materials. Further improving the electrical performance while effectively reducing the thermal conductivity is a crucial issue. In this paper, under the guidance of the oneness principle calculation, we designed a thermoelectric Zintl phase based on Mg3.2Sb1.5Bi0.5 doped with Tb and Er. Calculation results show that using Tb and Er as cationic site dopants effectively improves the electrical properties and reduces the lattice thermal conductivity. Experimental results confirmed the effectiveness of codoping and effectively enhanced thermoelectric performance. The most immense ZT value obtained by the Mg3.185Tb0.01Er0.005Sb1.5Bi0.5 sample was 1.71. In addition, the average Young's modulus of the Mg3.185Tb0.01Er0.005Sb1.5Bi0.5 sample is 51.85 GPa, and the Vickers hardness is 0.99 GPa. Under the same test environment, the material was subjected to 12 cycles in the temperature range of 323-723 K, and the average power factor error range was 1.8% to 2.1%, which is of practical significance for its application in actual device scenarios.