Nest trees of northern spotted owls (Strix occidentalis caurina) in Washington and Oregon, USA.

The northern spotted owl (Strix occidentalis caurina) is a federally-threatened subspecies in the United States associated with late-successional forests. In mesic forests it nests primarily in tree cavities, but also uses various types of external platform nests in drier forests. We describe 1717 northern spotted owl nests in 16 different tree species in five study areas in Washington and Oregon in the Pacific Northwest, USA. The vast majority of nests (87%) were in Douglas-fir (Pseudotsuga menziesii) trees, except on the Olympic Peninsula, Washington, where nests were about equally abundant in Douglas-fir, western red cedar (Thuja plicata), and western hemlock (Tsuga heterophylla) trees. Distribution of nests was 57.9% in top cavities of trees with broken tops, 20.3% in side cavities of hollow tree trunks, and 21.8% on external platforms of trees. Platforms were most common in the two driest study areas in the Eastern Cascades Physiographic Province, Washington (89% of nests), and the Klamath Province, Oregon (32%). The vast majority (89%) of nests were in trees with intact or declining crowns. Nests in dead trees were most common on the Olympic Peninsula. Nest trees with top and side cavities were larger and much more prevalent in study areas where annual precipitation was highest (Olympic Peninsula, Oregon Coast Range). Large nest cavities and platforms used by northern spotted owls occur almost exclusively in old forest. Managing for the retention of such forests and for their replacement is a significant challenge for land managers, especially in the face of climate change and an increasing human population, but will likely be required for the persistence of viable populations of northern spotted owls.

Association between gene expression profile and tumor invasion in oral squamous cell carcinoma.

There are limited studies attempting to correlate the expression changes in oral squamous cell carcinoma with clinically relevant variables. We determined the gene expression profile of 16 tumor and 4 normal tissues from 16 patients by means of Affymetrix Hu133A GeneChips. The hybridized RNA was isolated from cells obtained with laser capture microdissection, then was amplified and labeled using T7 polymerase-based in vitro transcription. The expression of 53 genes was found to differ significantly (33 upregulated, 20 downregulated) in normal versus tumor tissues under two independent statistical methods. The expression changes in four selected genes (LGALS1, MMP1, LAGY, and KRT4) were confirmed with reverse transcriptase polymerase chain reaction. Two-dimensional hierarchical clustering of the 53 genes resulted in the samples clustering according to the extent of tumor infiltration: normal epithelial tissue, tumors less than or equal to 4 cm in dimension, and tumors more than 4 cm in dimension (P = 0.0014). The same pattern of clustering was also observed for the 20 downregulated genes. We did not observe any associations with lymph node metastasis (P = 0.097).

Resorbable plates for the fixation of mandibular fractures: a prospective study.

PURPOSE: The hypothesis for this prospective evaluation is that resorbable plates are equal to the performance of titanium 2-mm plates, regarding healing of the fracture with bone union and restoration of function. To prove this hypothesis, specific end points will be compared with literature norms for titanium 2-mm miniplate rigid fixation. The primary end point variable for this analysis is the union of the fracture and return to normal function. Secondary end point variables included the incidence of complications such as infection, malunion with malocclusion, soft tissue dehiscence, the need for revision surgery, specific technical challenges, operative time, and the learning curve for the surgeon. PATIENTS AND METHODS: This prospective study consisted of a sequential enrollment of 50 fractures that met the inclusion criteria of having a fracture of the mandibular body, symphysis, angle, or ramus, and required an open reduction and internal fixation for stabilization and repair. The resorbable plates and screws used consisted of an amorphous injection molded copolymer of L-lactide/D-lactide/trimethylene carbonate (Inion CPS system, Tampere, Finland). Data were collated and compared with literature norms for titanium plates and also compared with nonrigid fixation data from a prospective study performed on a similar population in the same institution. RESULTS: Clinical and radiographic evaluation indicated union of all fractures at the eighth follow-up visit. Three sites (6%) noted to have clinical signs of infection were treated immediately upon presentation, with fracture union by 8 weeks. There was no need for revision surgery in this series of patients; 12 screw heads fractured during screw placement and were immediately replaced without significant fracture sequelae. CONCLUSION: Based on this limited series of patients, the hypothesis formulated for this study was validated.