RESUMO
The theory of heat conduction paths has been widely recognized and widely studied in the research about the thermal conductivity of thermal conductive polymer composites at present. Encapsulating polymer pellets with thermally conductive fillers and processing them into thermally conductive polymer composites is a simple and effective method for constructing heat conduction paths. It is meaningful to investigate the related heat conduction mechanism of this method. Otherwise, this approach can significantly preserve the performance of the polymer substrate, making it highly valuable for practical material applications. In this work, polyethylene-octene elastomer (POE) pellets were encapsulated with thermal conductive fillers by physical absorption. Subsequently, the composite films containing heat conduction paths were fabricated using the encapsulated POE pellets through a heating press. Alumina (Al2O3), boron nitride (BN), and alumina/boron nitride hybrid (Al2O3/BN) fillers were used to prepare Al2O3@POE, BN@POE, and BN/Al2O3@POE composite films to investigate the influence of filler shapes on heat conduction path construction. The influence of the constitute and density of heat conduction paths on the thermal conductivity of composite films was analyzed by infrared thermal imaging, finite element analysis, and thermal resistance theory in detail. Owing to the reserved good adhesion and flexibility of the POE substrate, the composite films could be directly used as thermal interface materials for chip cooling, which presented a good heat dissipation effect. Furthermore, a series of integrated composite materials were prepared by the combination of encapsulated pellets with various functional films (copper foil, aluminum foil, and graphite sheet) through a one-pot heating press, exhibiting a good electromagnetic shielding effect. The performance of the composites and the corresponding preparation method demonstrate the strong significance of this research for practical applications.
RESUMO
Three series of multicomponent silicone hydrogels were prepared by the copolymerization of two hydrophobic silicon monomers bis(trimethylsilyloxy) methylsilylpropyl glycerol methacrylate (SiMA) and tris(trimethylsiloxy) 3-methacryloxypropylsilane (TRIS) with three hydrophilic monomers. The surface hydrophilicity of the silicone hydrogels was characterized by contact angle measurements, and an interesting phenomenon was found that the silicone hydrogels made from less hydrophobic monomer SiMA possess more hydrophobic surfaces than those made from TRIS. The surface properties such as morphology and elemental composition of the silicone hydrogels were explored by scanning electron microscopy (SEM) imaging and energy dispersive spectrometry (EDS) analysis, and their relationships with the surface hydrophilicity were investigated in details. The results show neither the surface morphology nor the elemental composition has obvious impact on the surface hydrophilicity. Atomic force microscopy (AFM) imaging revealed that SiMA hydrogel had a more significant phase separation structure, which also made its surface uneven: a lot of tiny holes were observed on the surface. This surface phase separation structure made SiMA hydrogel more difficult to be wetted by water or PBS buffer, i.e., more hydrophobic than TRIS hydrogel. On the basis of these results, we propose that the phase separation structure as well as the nature of silicon monomers might be the fundamental reasons of surface hydrophilicity. These results could help to design a silicone hydrogel with better surface properties and wider application.