RESUMO
High-quality cerium-doped ß-Ga2O3 (Ga2O3:Ce) thin films could be achieved on (0001)α-Al2O3 substrates using a pulsed-laser deposition method. The impact of dopant contents concentration on crystal structure, optical absorption, photoluminescence, and photoelectric properties has been intensively studied. X-ray diffraction analysis results have shown that Ga2O3:Ce films are highly (2¯01) oriented, and the lattice spacing of the (4¯02) planes is sensitive to the Ce doping level. The prepared Ga2O3:Ce films show a sharp absorption edge at about 250 nm, meaning a high transparency to deep ultraviolet (DUV) light. The photoluminescence results revealed that the emissions were in the violet-blue-green region, which are associated with the donor-acceptor transitions with the Ce3+ and oxygen vacancies related defects. A simple DUV photodetector device with a metal-semiconductor-metal structure has also been fabricated based on Ga2O3:Ce thin film. A distinct DUV photoresponse was obtained, suggesting a potential application in DUV photodetector devices.
RESUMO
In this work, a Schottky barrier diode (SBD) is fabricated and demonstrated based on the edge-defined film-fed grown (EFG) Ga2O3 crystal substrate. At the current stage, for high resistance un-doped Ga2O3 films and/or bulk substrates, the carrier concentration (and other electrical parameters) is difficult to be obtained by using the conventional Hall measurement. Therefore, we extracted the electrical parameters such as on-state resistance (Ron), Schottky barrier height (ÏB), the ideal factor (n), series resistance (Rs) and the carrier concentration (Nd) by analyzing the current density-voltage (J-V) and capacitance-voltage (C-V) curves of the Ga2O3-based SBD, systematically. The detailed measurements and theoretical analysis are displayed in this paper.
RESUMO
A heterojunction is an essential strategy for multispectral energy-conservation photodetection for its ability to separate photogenerated electron-hole pairs and tune the absorption edge by selecting semiconductors with appropriate bandgaps. A broadband ultraviolet (200-410 nm) self-powered photodetector is constructed on the exfoliated ß-Ga2O3/CuI core-shell microwire heterostructure. Benefiting from the photovoltaic and photoconductive effects, our device performs an excellent ultraviolet (UV) discriminability with a UVC/visible rejection ratio (R225/R600) of 8.8 × 103 and a UVA/visible rejection ratio (R400/R600) of 2.7 × 102, and a self-powered photodetection with a responsivity of 8.46 mA/W, a detectivity of 7.75 × 1011 Jones, an on/off switching ratio of 4.0 × 103, and a raise/decay speed of 97.8/28.9 ms under UVC light. Even without encapsulation, the photodetector keeps a superior stability over ten months. The intrinsically physical insights of the device behaviors are investigated via energy band diagrams, and the charge carrier transfer characteristics of the ß-Ga2O3/CuI interface are predicted by first principle calculation.
RESUMO
Flexible photodetectors (PDs) have become the latest research interest owing to their potential applications in future implantable sensors and foldable/wearable optoelectronics. Ga2O3, an emerging ultrawide band gap semiconductor, is considered as the native photosensitive material for solar-blind PDs. The reported fabrication temperature of Ga2O3 films is usually above 600 °C, which hinders its practical application for flexible devices. In this work, flexible PDs based on graphene/amorphous Ga2O3 van der Waals heterojunctions are fabricated, which demonstrate promising photoresponse to solar-blind ultraviolet light. The device yields a high photo-to-dark current ratio (â¼105) and large responsivity (22.75 A/W) under 254 nm light illumination, which could be ascribed to the efficient photogenerated electron-hole pair separation by the strong built-in field. Moreover, flexible PDs also show long-term environmental stability and outstanding mechanical flexibility without any encapsulation. Our work provides a new potential candidate for realizing cost-effective high-performance flexible optoelectronic applications.
RESUMO
Solar-blind photodetectors have captured intense attention due to their high significance in ultraviolet astronomy and biological detection. However, most of the solar-blind photodetectors have not shown extraordinary advantages in weak light signal detection because the forewarning of low-dose deep-ultraviolet radiation is so important for the human immune system. In this study, a high-performance solar-blind photodetector is constructed based on the n-Ga2O3/p-CuSCN core-shell microwire heterojunction by a simple immersion method. In comparison with the single device of the Ga2O3 and CuSCN, the heterojunction photodetector demonstrates an enhanced photoelectric performance with an ultralow dark current of 1.03 pA, high photo-to-dark current ratio of 4.14 × 104, and high rejection ratio (R254/R365) of 1.15 × 104 under a bias of 5 V. Excitingly, the heterostructure photodetector shows high sensitivity to the weak signal (1.5 µW/cm2) of deep ultraviolet and high-resolution detection to the subtle change of signal intensity (1.0 µW/cm2). Under the illumination with 254 nm light at 5 V, the photodetector shows a large responsivity of 13.3 mA/W, superb detectivity of 9.43 × 1011 Jones, and fast response speed with a rise time of 62 ms and decay time of 35 ms. Additionally, the photodetector can work without an external power supply and has specific solar-blind spectrum selectivity as well as excellent stability even through 1 month of storage. Such prominent photodetection, profited by the novel geometric construction and the built-in electric field originating from the p-n heterojunction, meets greatly well the "5S" requirements of the photodetector for practical application.
RESUMO
The pursuit of high-performance photodetectors functioning in the solar-blind spectrum is motivated by both scientific and practical applications ranging from secure communication, monitoring, sensing, etc. In particular, the fabrication of heterojunctions based on the wide band gap semiconductors has emerged as an attractive strategy to promote the high-efficient photogenerated electron/hole pair separation. However, the precisely controlled growth of heterojunctions remains a huge challenge. The lattice mismatch leads to the formation of defects and/or dislocations at the interface, deteriorating the performance of devices and limiting their envisioned applications. Here, we demonstrate a simple one-step growth of amorphous/crystalline Ga2O3 phase junctions by using sputtering technique, yielding a large responsivity of 0.81 A/W, a superior photo-to-dark current ratio over 107, and an ultrahigh response speed of â¼12 ns. Compared to the previous reported solar-blind photodetectors, the obtained detectivity ≈ 5.67 × 1014 Jones is increased by 2 orders of magnitude. Such excellent photoresponse characteristics can be understood by the interfacial built-in field-promoted electron/hole pair separation for the amorphous/crystalline Ga2O3 phase junctions. Our results provide a novel path toward realizing high-performance optoelectronics functioning in the solar-blind spectrum.
RESUMO
Corundum-structured α-phase Ga1.4Sn0.6O3 thin films have been deposited on m-plane Al2O3(300) substrates using laser molecular beam epitaxy technology. With increasing of the oxygen partial pressure, the crystal lattice of Ga1.4Sn0.6O3 films expands due to tin ions valence changes from Sn4+ to Sn2+. The resistivity of the film deposited under 3 × 10-5 Pa is 3.54 × 104 Ω·cm, which decreases by about 2 orders of magnitude than that fabricated under 3 × 10-1 Pa. The mixture valence of Sn2+ and Sn4+ ions leads to the impurity altitude compensation effect. The deep ultraviolet photodetector based on α-phase Ga1.4Sn0.6O3 thin films was fabricated. With the oxygen partial pressure reducing gradually, the dark current and the photocurrent increase, and the relaxation time constants diminish, respectively.
RESUMO
Multilayer thin films based on the ferromagnetic and ultraviolet transparent semiconductors may be interesting because their magnetic/electronic/photonic properties can be manipulated by the high energy photons. Herein, the Ga2O3/(Ga1-xFex)2O3 multilayer epitaxial thin films were obtained by alternating depositing of wide band gap Ga2O3 layer and Fe ultrathin layer due to inter diffusion between two layers at high temperature using the laser molecular beam epitaxy technique. The multilayer films exhibits a preferred growth orientation of crystal plane, and the crystal lattice expands as Fe replaces Ga site. Fe ions with a mixed valence of Fe(2+) and Fe(3+) are stratified distributed in the film and exhibit obvious agglomerated areas. The multilayer films only show a sharp absorption edge at about 250 nm, indicating a high transparency for ultraviolet light. What's more, the Ga2O3/(Ga1-xFex)2O3 multilayer epitaxial thin films also exhibits room temperature ferromagnetism deriving from the Fe doping Ga2O3.