Quasi-phase-matched second harmonic generation in silicon nitride ring resonators controlled by static electric field.

Actively-controlled second harmonic generation in a silicon nitride ring resonator is proposed and simulated. The ring was designed to resonate at both pump and second harmonic wavelengths and quasi-phase-matched frequency conversion is induced by a periodic static electric field generated by voltage applied to electrodes arranged along the ring. Nonlinear propagation simulations were undertaken and an efficiency of -21.67 dB was calculated for 60 mW of pump power at 1550 nm and for a 30V applied voltage, which compares favorably with demonstrated all-optical second harmonic generation in integrated microresonators. Transient effects were also evaluated. The proposed design can be exploited for the construction of electro-optical devices based on nonlinear effects in CMOS compatible circuits.

Temperature response of an all-solid photonic bandgap fiber for sensing applications.

The spectral shift due to temperature in the photonic bandgap (PBG) of an all-solid PBG fiber is investigated, aiming at discrete and distributed temperature sensing. A temperature rise induces a red shift in the bandgap spectra, which can be easily and precisely monitored by measuring the fiber transmission near one of the band edges. Two different situations that are potentially compatible with distributed and quasi-distributed sensing were investigated: heating a 2 m section of a longer (~10 m) fiber, and heating the whole extension of a fiber that is tens of centimeters in length and was spliced to conventional fibers on both sides. The latter setup yielded bandgap spectral shifts up to ~35 pm/°C. Aiming at discrete sensing, a short (~50 mm) fiber section was subjected to a tight bend so as to exhibit increased temperature sensitivity. Choosing the position of the bend allows for reconfiguration, on demand, of the sensor. A semi-analytical method to identify the spectral position of bandgaps was used to model the fiber transmission, as well as the bandgap shift with temperature, with consistent results.

Resonantly Increased Optical Frequency Conversion in Atomically Thin Black Phosphorus.

Optical frequency conversion via the nonlinear effect of third harmonic generation is shown to be resonantly enhanced in few-layer black phosphorus. This feature is believed to be a consequence of exciton-related resonance, as the enhancement is strongly correlated with the observation of exciton-recombination photoluminescence. Few-layer thicknesses are obtained both via mechanical exfoliation and laser thinning.

Graphene Based Waveguide Polarizers: In-Depth Physical Analysis and Relevant Parameters.

Optical polarizing devices exploiting graphene embedded in waveguides have been demonstrated in the literature recently and both the TE- and TM-pass behaviors were reported. The determination of the passing polarization is usually attributed to graphene's Fermi level (and, therefore, doping level), with, however, no direct confirmation of this assumption provided. Here we show, through numerical simulation, that rather than graphene's Fermi level, the passing polarization is determined by waveguide parameters, such as the superstrate refractive index and the waveguide's height. The results provide a consistent explanation for experimental results reported in the literature. In addition, we show that with an accurate graphene modeling, a waveguide cannot be switched between TE pass and TM pass via Fermi level tuning. Therefore, the usually overlooked contribution of the waveguide design is shown to be essential for the development of optimized TE- or TM-pass polarizers, which we show to be due to the control it provides on the fraction of the electric field that is tangential to graphene.

Fabrication and optical characterization of silica optical fibers containing gold nanoparticles.

Gold nanoparticles have been used since antiquity for the production of red-colored glasses. More recently, it was determined that this color is caused by plasmon resonance, which additionally increases the material's nonlinear optical response, allowing for the improvement of numerous optical devices. Interest in silica fibers containing gold nanoparticles has increased recently, aiming at the integration of nonlinear devices with conventional optical fibers. However, fabrication is challenging due to the high temperatures required for silica processing and fibers with gold nanoparticles were solely demonstrated using sol-gel techniques. We show a new fabrication technique based on standard preform/fiber fabrication methods, where nanoparticles are nucleated by heat in a furnace or by laser exposure with unprecedented control over particle size, concentration, and distribution. Plasmon absorption peaks exceeding 800 dB m(-1) at 514-536 nm wavelengths were observed, indicating higher achievable nanoparticle concentrations than previously reported. The measured resonant nonlinear refractive index, (6.75 ± 0.55) × 10(-15) m(2) W(-1), represents an improvement of >50×.