Robotic Surgical Assistant (ROSA™) Rehearsal: Using 3-Dimensional Printing Technology to Facilitate the Introduction of Stereotactic Robotic Neurosurgical Equipment.

BACKGROUND: The use of frameless stereotactic robotic technology has rapidly expanded since the Food and Drug Administration's approval of the Robotic Surgical Assistant (ROSA™) in 2012. Although the safety and accuracy of the ROSA platform has been well-established, the introduction of complex robotic technology into an existing surgical practice poses technical and logistical challenges particular to a given institution. OBJECTIVES: To better facilitate the integration of new surgical equipment into the armamentarium of a thriving pediatric neurosurgery practice by describing the use of a three-dimensional (3D)-printed patient model with in situ 3D-printed tumor for presurgical positioning and trajectory optimization in the stereotactic biopsy of a pontine lesion in a pediatric patient. METHODS: A 3D model was created with an added silicone mock tumor at the anatomical position of the lesion. In a preoperative rehearsal session, the patient model was pinned and registered using the ROSA platform, and a mock biopsy was performed targeting the in Situ silicone tumor. RESULTS: Utilization of the 3D-printed model enabled workflow optimization and increased staff familiarity with the logistics of the robotic technology. Biopsy trajectory successfully reached intralesional tissue on the 3D-printed model. The rehearsal maneuvers decreased operative and intubation time for the patient and improved operative staff familiarity with the robotic setup. CONCLUSION: Use of a 3D-printed patient model enhanced presurgical positioning and trajectory planning in the biopsy of a difficult to reach pontine lesion in a pediatric patient. The ROSA rehearsal decreased operative time and increased staff familiarity with a new complex surgical equipment.