Biological life support for manned missions by ESA.

The anticipated evolution of life support technologies for ESA, considering both the complementary life support system requirements and the missions' characteristics, is presented. Based on these results, promising biological life support technologies for manned space missions have been selected by ESA either for their intrinsic ability and performance in effecting specific tasks for atmosphere-, water-, waste-management versus physico-chemical alternatives and/or for longer-term application to a more ecological concept (CES) focusing ultimately on food production. Actual status and plan for terrestrial and space testing of biological life support presented focusing on the "task specific" decontamination technology of the Biological Air Filter (BAF), and on food reprocessing technologies from biodegradable wastes with the MELISSA microbial ecosystem.

Optical oxygen sensor instrumentation based on the detection of luminescence lifetime.

Optical oxygen sensors are mainly based on the principle of luminescence quenching. In contrast to arready existing intensity-based systems, the measurement of the luminescence lifetime provides certain advantages, such as insensitivity to photobleaching or leaching of the dye, or changes in the intensity of excitation light. This facilitates the use of simple optical systems or optical fibres. A new family of oxygen-sensitive dyes, the porphyrin-ketones, has been introduced, which exhibits favorable spectral properties and decay times in the order of tens and hundreds of microseconds. This allows the use of simple optoelectronic circuitry and low-cost processing electronics. An optical oxygen sensor module has been developed with the dimensions of only 120 x 60 x 30 mm. The prototype is based on the measurement of the decay time of the luminophore by measuring the phase shift between the square-wave excitation and the detected square-wave of the emission coming from the sensor. The instrument is based on semiconductor devices (light-emitting diodes, photodiodes) and may be used for the detection of oxygen in gaseous or liquid samples. The measurement range of the device is from 0 to 200 hPa oxygen partial pressure with a resolution of < 1 hPa over the whole measurement range. The overall measurement accuracy of < +/- 1 hPa has been obtained for periods of 24 h of continuous measurement in a thermostatted environment. The sensor response times t90 are typically < 1 s for gases and 0.5 to 5 min for liquid samples.

Microbial and higher plant biomass selection for closed ecological systems.

A selection of higher plants and microbial strains is presented with its rationale in order to progressively regenerate food from waste in future space and planetary missions.

Application of light-emitting diodes in bioreactors: flashing light effects and energy economy in algal culture (Chlorella pyrenoidosa).

Light-emitting diodes (LEDs) were used as the sole light source in continuous culture of the green alga Chlorella pyrenoidosa. The LEDs applied show a peak emission at 659 nm with a half-power bandwidth of 30 nm. Selection of this wavelength range, which is optimal for excitation of chlorophylls a and b in their "red" absorption bands makes all photons emitted potentially suitable for photosynthesis. No need for additional supply of blue light was found. A standardized panel with 2 LEDs cm(-2) fully covered one side of the culture vessel. At standard voltage in continuous operation the light output of the diode panel appeared more than sufficient to reach maximal growth. Flash operation (5-mus pulse duration) enables potential use of higher operating voltages which may render up to three times more light output. Flat airlift fermentor-type continuous culture devices were used to estimate steady state growth rates of Chlorella pyrenoidosa as a function of the light flux (micromol photons x m(-2) x s(-1)) and the flashing frequency of the light-emitting diodes (which determines the duration of the dark "off" time between the 5-micros "on" pulses). At the fixed voltage and turbidostat setting applied a 20-kHz frequency, which equals dark periods of 45 mus, still permitted the maximum growth rate to become nearly reached. Lower frequencies fell short of sustaining the maximal growth rate. However, the light flux decrease resulting from lowering of the flash frequency appeared to reduce the observed growth rates less than in the case of a similar flux decrease with light originating from LEDs in continuous operation. Flash application also showed reduction of the quantum requirement for oxygen evolution at defined frequencies. The frequency domain of interest was between 2 and 14 kHz. LEDs may open interesting new perspectives for studies on optimization of mixing in mass algal culture via the possibility of separation of interests in the role of modulation on light energy conversion and saturation of nutrient supply. Use of flashing LEDs in indoor algal culture yielded a major gain in energy economy in comparison to luminescent light sources. (c) 1996 John Wiley & Sons, Inc.