RESUMO
Although various types of bifacial solar cells exist, few studies have been conducted on bifacial semitransparent CuInSe2 solar cells (BS-CISe SCs) despite the attractive potential in power generation from both sides in an albedo environment. The optimized BS-CISe SCs with 300 and 800 nm-thick absorber via a streamlined single-stage co-evaporation process exhibit a power conversion efficiency (PCE) of 6.32% and 10.6%, respectively. When double-sided total 2.0 sun illumination is assumed in an albedo environment, the bifacial power generation densities (BPGD) of them increases to 9.41% and 13.9%. Four-terminal bifacial semitransparent tandem solar cells (4T-BST SCs) are fabricated to increase the BPGD by mechanically stacking a BS-perovskite (PVK) top cell on top of a BS-CISe bottom cell with the 300 and 800 nm-thick absorber layers. When summed up, the best top and bottom cell PCEs of the 4T-BST SC with 300 and 800 nm-thick BS-CISe SC are 18.8% and 21.1%, respectively. However, the practical BPGD values of the 4T-BST SC under total 2 sun illumination are interestingly 23.4% and 24.4%, respectively. This is because the BS-CISe bottom cell's thickness affects how much rear-side illumination is transmitted to the BS-PVK top cell, increasing its current density and BPGD.
RESUMO
Auger and surface recombinations are major drawbacks that deteriorate a photon-to-electron conversion efficiencies in nanostructured (NS) Si solar cells. As an alternative to conventional frontside nanostructuring, we report how backside nanostructuring is beneficial for carrier collection during photovoltaic operation that utilizes a 50-µm-thin wafer. Ultrathin (4.3-nm-thin) zinc oxide was also effective for providing passivated tunneling contacts at the nanostructured backsides, which led to the enhancement of 24% in power conversion efficiency.
RESUMO
We report three-dimensionally assembled nanoparticle structures inducing multiple plasmon resonances for broadband light harvesting in nanocrystalline silicon (nc-Si:H) thin-film solar cells. A three-dimensional multiscale (3DM) assembly of nanoparticles generated using a multi-pin spark discharge method has been accomplished over a large area under atmospheric conditions via ion-assisted aerosol lithography. The multiscale features of the sophisticated 3DM structures exhibit surface plasmon resonances at multiple frequencies, which increase light scattering and absorption efficiency over a wide spectral range from 350-1100 nm. The multiple plasmon resonances, together with the antireflection functionality arising from the conformally deposited top surface of the 3D solar cell, lead to a 22% and an 11% improvement in power conversion efficiency of the nc-Si:H thin-film solar cells compared to flat cells and cells employing nanoparticle clusters, respectively. Finite-difference time-domain simulations were also carried out to confirm that the improved device performance mainly originates from the multiple plasmon resonances generated from three-dimensionally assembled nanoparticle structures.
RESUMO
OBJECTIVE: To biomechanically evaluate the stability of internal fixation methods for femoral neck fractures in small-breed dogs. Furthermore, the possibility of replacing the headed screw with fully threaded headless cannulated screws in the fixation method was assessed. METHODS: The study was conducted from December 12, 2023, to February 7, 2024. A total of 18 femurs from 9 canine cadavers were used in this study. After a simple neck fracture was created, in group A (n = 6), the fracture was stabilized with three 1.1-mm parallel Kirschner wires (K-wires). In group B (n = 6), a 3.0-mm partially threaded cannulated screw and an antirotation pin were used. In group C (n = 6), a 2.5-mm fully threaded headless cannulated screw and an antirotation pin were used. A mechanical test was conducted to apply a single axial compressive load to the femoral head. RESULTS: 9 adult small-breed dogs weighing 3.6 to 8.3 kg (mean ± SD; 5.9 ± 1.6). The mean maximum failure load was highest in group C (495 ± 81 N), followed by group B (454 ± 50.4 N), and then group A (222 ± 21.6 N). Significant differences in maximum failure load were observed between groups A and B as well as groups A and C but not between groups B and C. CONCLUSION: The use of fully threaded headless cannulated screws presents a promising method for internal fixation of canine femoral neck fractures. CLINICAL RELEVANCE: To demonstrate the potential stability and reliability of fully threaded headless cannulated screws.
RESUMO
Flexible hydrogenated nanocrystalline (nc-Si:H) thin-film solar cells were prepared by very high frequency plasma enhanced chemical vapor deposition (VHF-PECVD), and the effect of highly crystalline intrinsic Si seed layers at the initial growth stage of i nc-Si:H absorbers on their structural and electrical properties and on the performance of solar cells was investigated. The crystallization of i nc-Si:H absorbers was significantly enforced by the introduction of highly crystalline seed layers, resulting in the reduction of defect-dense a-Si:H grain boundary and incubation layer thickness. The open circuit voltage of the nc-Si:H solar cells with the seed layers was improved by the decrease of charged defect density in the defect-rich amorphous region.
RESUMO
Among many building-integrated semitransparent photovoltaics (BISTPVs), semitransparent ultrathin (STUT) Cu(Inx ,Ga1-x )Se2 (CIGSe) solar cells are distinguishable due to their potential high power conversion efficiency (PCE) among other thin-film solar cells, versatile applicability based on thin film deposition processes, high stability consisting of all inorganic compositions, and practical expandability to bifacial applications. However, the fundamental trade-off relationship between PCE and transparency limits the performance of BISTPV because implementing a higher semitransparency lowers the optical budget of incoming light. To expand the available optical budget and to enhance the PCE while maintaining a suitable transparency in STUT CIGSe solar cell with single-stage coevaporated 500-nm-thick absorber, an atomic layer deposited wide bandgap Zn(O,S) buffer is introduced as the replacement of conventional CdS buffer, which partially limits incoming light less than 520 nm in wavelength. As a replacement result, more incoming light becomes valid for power conversion, and the short circuit current density (Jsc ) has increased comparatively by 17%, which has directly lead to a large increase in PCE up to 12.41%. Furthermore, Zn(O,S) buffer in the STUT CIGSe solar cell also has enhanced the bifacial compatible efficiency (BCE), which has increased to 14.44% at 1.3 sun and 19.42% at 2.0 sun.
RESUMO
Chalcopyrite-based materials for photovoltaic devices tend to exhibit complex structural imperfections originating from their polycrystalline nature; nevertheless, properly controlled devices are surprisingly irrelevant to them in terms of resulting device performances. The present work uses atom probe tomography to characterize co-evaporated high-quality Cu(In,Ga)Se2 (CIGS) films on flexible polyimide substrates either with or without doping with Na or doping with Na followed by K via a post-deposition treatment. The intent is to elucidate the unique characteristics of the grain boundaries (GBs) in CIGS, in particular the correlations/anti-correlations between matrix elements and the alkali dopants. Various compositional fluctuations are identified at GBs irrespective of the presence of alkali elements. However, [Cu-poor and Se/In,Ga-rich] GBs are significantly more common than [Cu-rich and Se/In,Ga-poor] ones. In addition, the anti-correlations between Cu and the other matrix elements are found to show not only regular trends among themselves but also the association with the degree of alkali segregation at GBs. The Na and K concentrations exhibited a correlation at the GBs but not in the intragrain regions. Density functional theory calculations are used to explain the compositional fluctuations and alkali segregation at the GBs. Our experimental and theoretical findings not only reveal the benign or beneficial characteristics of the GBs of CIGS but also provide a fundamental understanding of the GB chemistry in CIGS-based materials.
RESUMO
Thinning CIGSe absorber layer to less than 500 nm is desirable for reducing the cost per unit watt of photovoltaic-generated electricity, and also, the semitransparent solar cell based on such a thin absorber can be used in bifacial and superstrate configurations if the back electrode is transparent. In this study, a WO x layer is inserted between Cu(In,Ga)Se2 (CIGSe) absorber and tin-doped indium oxide back-contact to enhance the hole collection at the back electrode. A WO x interlayer with a thickness of 6 nm is found to be optimum because it causes a â¼38% relative increase in the fill factor of a â¼450 nm thick CIGSe-based device compared to the reference device without a WO x interlayer. While fixing the thickness of CIGSe, increasing the WO x interlayer thickness to ≥6 nm results in decreases of solar cell parameters primarily because of the emergence of a GaO x interfacial layer at the CIGSe/WO x junction.
RESUMO
Platelets are anucleate cytoplasmic fragments derived from bone marrow megakaryocytes, and endothelial cells constitute the barrier between bloodstream and adjacent tissues. Although platelets are thought to regulate the biological functions of endothelial cells, the molecular mechanisms involved are poorly understood. With human umbilical vein endothelial cells and freshly isolated platelets, we established an in vitro model of platelet-induced endothelial cell proliferation. Platelets stimulated endothelial cell proliferation in a dose-dependent manner and transwell experiments with semi-permeable membranes suggested that direct cell-to-cell contacts were required. We developed mAbs against platelets and selected a mAb that blocks their proliferative effect. We purified the antigen by immunoprecipitation and identified it by Q-TOF MS analysis as the tetraspanin CD9. Since both platelets and endothelial cells expressed CD9 strongly on their surfaces we carried out a pre-treatment experiment that showed that CD9 molecules on the endothelial cells participate in the mitogenic effect of the platelets. The inhibitory effect of our mAb was comparable to that of a well-known functional anti-CD9 mAb. These results suggest that the tetraspanin CD9 plays an important role in endothelial regeneration.
Assuntos
Anticorpos Monoclonais/imunologia , Antígenos CD/fisiologia , Plaquetas/fisiologia , Proliferação de Células/efeitos dos fármacos , Endotélio Vascular/citologia , Glicoproteínas de Membrana/fisiologia , Antígenos CD/imunologia , Técnicas de Cocultura , Endotélio Vascular/efeitos dos fármacos , Humanos , Glicoproteínas de Membrana/imunologia , Tetraspanina 29RESUMO
OBJECTIVE: This study was to identify small inhibitory RNAs (siRNAs) that are effective in inhibiting growth of cervical cancer cell lines harboring human papilloma virus (HPV) and to examine how siRNAs interact with interferon beta (IFN-ß) and thimerosal. METHODS: The HPV18-positive HeLa and C-4I cell lines were used. Four types of siRNAs were designed according to their target (both E6 and E7 vs. E6 only) and sizes (21- vs. 27-nucleotides); Ex-18E6/21, Ex-18E6/27, Sp-18E6/21, and Sp-18E6/27. Each siRNA-transfected cells were cultured with or without IFN-b and thimerosal and their viability was measured. RESULTS: The viabilities of HPV18-positive tumor cells were reduced by 21- and 27-nucleotide siRNAs in proportion to the siRNA concentrations. Of the two types of siRNAs, the 27-nucleotide siRNA constructs showed greater inhibitory efficacy. Sp-18E6 siRNAs, which selectively downregulates E6 protein only, were more effective than the E6- and E7-targeting Ex-18E6 siRNAs. siRNAs and IFN-ß showed the synergistic effect to inhibit HeLa cell survival and the effect was proportional to both siRNA and IFN-ß concentrations. Thimerosal in the presence of siRNA exerted a dose-dependent inhibition of C-4I cell survival. Finally, co-treatment with siRNA, IFN-ß, and thimerosal induced the most profound decrease in the viability of both cell lines. CONCLUSION: Long (27-nucleotides) siRNAs targeting E6-E7 mRNAs effectively reduce the viability of HPV18-positive cervical cancer cells and show the synergistic effect in combination with IFN-b and thimerosal. It is necessary to find the rational design of siRNAs and effective co-factors to eradicate particular cervical cancer.
RESUMO
Mosapride citrate (Mosapride) is a new prokinetic agent that enhances the gastrointestinal (GI) motility by stimulation of 5-HT4 receptors. This agent stimulates acetylcholine release from enteric cholinergic neurons in the GI wall. It was reported in several studies that mosapride selectively enhanced the upper, but not lower, GI motor activity. However, in these studies other 5-HT4 receptor agonists exerted stimulating effects on the motility of the colon. Moreover, it is well known that the receptors of 5-HT4 are also located in the colon. The purpose of this study was to estimate the effect of mosapride on the motility of the stomach, ileum and colon in the guinea pig and to investigate whether or not mosapride influenced the colonic motility. Mosapride significantly increased the amplitude of the contraction waves in the guinea pig stomach by electrical stimulation. In addition, it significantly increased the number of peaks, the area under the curve and the propagation velocity of the peristaltic contraction of the guinea pig ileum in a concentration dependent fashion. Mosapride also significantly shortened the transit time of the guinea pig colon. Accordingly, we concluded that mosapride exerted prokinetic effect on the entire GI tract of the guinea pig. Based on the possibility of similar results in humans, we suggest the potential use of mosapride for lower GI motor disorders such as constipation and upper GI motor disorders such as gastroesophageal reflex disease or gastroparesis.