RESUMO
OBJECTIVE: Develop a hydrophobic, degradation-resistant dental restorative based on an Oxirane-Acrylate IPN System (OASys) with low shrinkage-stress to substantially extend clinical lifetime. METHODS: Unfilled OASys blends were prepared using dipenta-erythritol-hexaacrylate (DPHA) and p-cycloaliphatic-diepoxide (EP5000). Varying proportions of camphorquinone/iodonium photoinitiator, with a co-reactant oligomeric-diol, served as the experimental curing system. The effects of oxirane-acrylate ratio on the degree-of-cure (Durometer-D hardness), hydrophobicity (contact angle), mechanical properties (3-point bending), near-infrared FTIR degree-of-conversion (DoC), polymerization shrinkage, and shrinkage stress were determined. 70:30 BisGMA:TEGDMA resin served as control. RESULTS: Oxirane tended to decrease hardness and increase hydrophobicity. 0:100, 25:75, 50:50 EP5000:DPHA are harder after 24h than control. 75:25 and 100:0 EP5000:DPHA increased in hardness over 24h, but were softer than control. All groups increased in contact angle over 24h. After 24h, 50:50, 75:25 and 0:100 EP5000:DPHA were more hydrophobic (â¼75-84°) than the control (â¼65°). Acrylate DoC was â¼60% across all experimental groups. Initial oxirane conversion varied from â¼42% in 100:0 EP5000:DPHA to â¼82% 75:25 EP5000:DPHA. However, oxirane DoC increased for 100:0 EP5000:DPHA to â¼73° over 24h, demonstrating dark cure. Moduli and ultimate transverse strengths of OASys groups were higher than for 0:100 EP5000:DPHA, with 50:50 EP5000:DPHA having higher modulus than other experimental groups. However, the control had higher modulus and UTS than all experimental groups. Volumetric shrinkage averaged 7% for experimental groups, but stress decreased dramatically with increasing oxirane content. SIGNIFICANCE: Hydrophobic, low shrinkage-stress OASys resins are promising for development of composites that improve longevity and reduce the cost of dental care.