Platelet-rich plasma (PRP) and tendon healing: comparison between fresh and frozen-thawed PRP.

Platelet-rich plasma (PRP) is increasingly used in the treatment of musculoskeletal diseases. Its preservation by freezing it for the realization of multiple injections in clinical use has never been discussed. Calcaneal tendons of rats were surgically sectioned. Platelet concentration of the PRP was 2.5 x 106/µl with autologous plasma of rats. Frozen-thawed PRP was prepared by performing two cycles of freezing and thawing on PRP aliquots. Both platelet preparations were injected in the lesion. Biomechanical and histological evaluations were carried out after 7, 20 or 40 days post surgery. After 7 and 40 days, no significant difference was observed between the PRP and the frozen-thawed PRP group. There is however a difference 20 days after surgery: the ultimate tensile strength (UTS) was greater in the fresh PRP group. No obvious difference with histological aspect was observed between the two groups. In conclusion, fresh PRP and frozen-thawed PRP injections can lead to similar results in the healing process of section calcaneal tendons of rats. Improvements with fresh PRP are slight. PRP could thus be frozen to be preserved if multiple injections are needed (e.g. osteoarthritis).

Silane influence on bonding to CAD-CAM composites: An interfacial fracture toughness study.

OBJECTIVES: To evaluate silane influence on the interfacial fracture toughness (IFT) of composite cement, with the two sub-classes of CAD-CAM composites, polymer-infiltrated ceramic networks (PICN) and dispersed fillers (DF), after hydrofluoric acid etching (HF) or airborne-particle abrasion (AB). A secondary objective was to correlate results with developed interfacial area ratio (Sdr) and surface wettability. METHODS: Experimental PICN and DF blocks were cut into equilateral half-prisms, which were treated with HF or AB, then treated with an experimental silane or not and bonded to their counterparts with an experimental light-cure resin cement. After thermocycling, samples (n=30 per group) were tested for IFT using the notchless triangular prism test in a water bath at 36°C. Moreover, profilometry and contact angle measurement were performed on rectangular samples of each group. Finally, bonding interface was analysed by SEM. RESULTS: PICN-HF treated with silane showed the highest IFT significantly. Three-way ANOVA revealed the influence of silane, material class and surface pre-treatment (HF or AB) on IFT (p<0.05). When silane was used, IFT was correlated with Sdr, while surface wettability was increased. Silane application significantly increased IFT for PICN but not for DF, while PICN performed better with HF and DF with AB. SIGNIFICANCE: Silane increases IFT of composite cement with PICNs, but not with DF materials. Results suggest that silane increases the micromechanical bond by promoting resin cement spreading and penetration in surface roughness. This roughness is significantly higher for pre-treated PICNs than for DF due to their specific honeycomb microstructure when etched, which explains their better bonding properties.

Effects of Allogeneic Platelet-Rich Plasma (PRP) on the Healing Process of Sectioned Achilles Tendons of Rats: A Methodological Description.

This article describes the experimental procedures used to observe if PRP can positively affect tendon healing. There are 4 main steps to follow: induce a lesion in the Achilles tendon; prepare PRP and inject it (or the saline solution); remove the tendon; and perform biomechanical, molecular, and histological evaluations. At each step, all the procedures and methods are described in detail, so they can be reproduced easily. Achilles tendons have been surgically sectioned (removal of a 5-mm long section). Afterwards, PRP or saline solution was injected to study whether PRP has a positive effect on the healing of the tendon. Three groups of 40 animals (a total of 120 rats were used in this study) were subdivided into 2 subgroups: PRP injection group and a saline injection control group. Rats were sacrificed at increasing time points (Group A: 5 days; Group B: 15 days; Group C: 30 days) and tendons were removed. 90 tendons underwent biomechanical testing before performing transcriptomic analysis and the 30 remaining tendons were submitted to histological analysis.