An 11-channel radio frequency phased array coil for magnetic resonance guided high-intensity focused ultrasound of the breast.

In this study, a radio frequency phased array coil was built to image the breast in conjunction with a magnetic resonance guided high-intensity focused ultrasound (MRgHIFU) device designed specifically to treat the breast in a treatment cylinder with reduced water volume. The MRgHIFU breast coil was comprised of a 10-channel phased array coil placed around an MRgHIFU treatment cylinder where nearest-neighbor decoupling was achieved with capacitive decoupling in a shared leg. In addition a single loop coil was placed at the chest wall making a total of 11 channels. The radio frequency coil array design presented in this work was chosen based on ease of implementation, increased visualization into the treatment cylinder, image reconstruction speed, temporal resolution, and resulting signal-to-noise ratio profiles. This work presents a dedicated 11-channel coil for imaging of the breast tissue in the MRgHIFU setup without obstruction of the ultrasound beam and, specifically, compares its performance in signal-to-noise, overall imaging time, and temperature measurement accuracy to that of the standard single chest-loop coil typically used in breast MRgHIFU.

Improving image quality in transcranial magnetic resonance guided focused ultrasound using a conductive screen.

Transcranial Magnetic Resonance guided Focused Ultrasound (TcMRgFUS) has been proven to be an effective treatment for some neurological disorders such as essential and Parkinson's tremor. However, magnetic resonance guidance at 3 Tesla (3T) frequencies and using the large hemispherical transducers required for TcMRgFUS results in artifactual low-signal bands that pass through key regions of the brain. The purpose of this work was to investigate the use of a circular conductive Radio Frequency (RF) screen, that is bent to have a 12 cm radius in one direction and positioned near the top or back of the head, to reduce or remove these artifactual low-signal bands in TcMRgFUS. The impact of using an RF screen to remove these low signal bands was studied in both imaging experiments and electromagnetic simulations. Hydrophone measurements of the acoustic transparency of the bronze 2 mm diameter square mesh screen used in the imaging studies were compared with temperature measurements with and without the screen in heating studies in the TcMRgFUS system. The imaging and simulation studies both show that for the different screen configurations studied in this work, RF screen removes the low-signal bands and increases both homogeneity and signal-to-noise ratio (SNR) throughout the region of the brain. Hydrophone and heating studies indicate that even a 2 mm wire mesh provides minimal attenuation to the ultrasound beam. Simulation results also suggest that a 1 cm mesh will provide adequate artifact suppression with even less ultrasound attenuation. An RF screen that disrupts the natural waveguide nature of the transducer in the 3T MR environment can change the electromagnetic field profile to reduce unwanted artifacts and provide an imaging region which has more homogeneity and higher SNR throughout the brain.

Radio-frequency coil selection for MR imaging of the brain and skull base.

Radio-frequency coils play a crucial role in the quest for optimal magnetic resonance (MR) image resolution. Given the growing variety of specialized coils available for neuroradiologic imaging applications, it is critical that radiologists use a coherent strategy for successfully matching these coils to specific imaging situations. First, fundamental concepts of coil design are reviewed. Subsequently, a coil-selection algorithm for neuroimaging applications is described. The algorithm uses the patient's clinical history to derive a region of interest, a desired spatial resolution, and a desired contrast resolution. These factors are then used to impose anatomic coverage and imaging protocol constraints on the set of available coils. Finally, coil selection is further refined according to patient tolerance factors. The following coils are considered for use with a 1.5-T superconducting MR imager; namely, quadrature birdcage head, neurovascular phased-array, and dual single-circular-element coils, as well as investigational coils that have not yet been approved by the U.S. Food and Drug Administration: reduced-volume birdcage end-cap, temporal lobe phased-array, carotid artery phased-array, coils. Rationales are discussed regarding appropriate coil selection for screening whole brain and imaging brainstem, cranial nerves, orbits, cerebral cortex, mesial temporal lobes, and internal auditory canal, and for MR angiography.

A three-coil comparison for MR angiography.

The purpose of this work was to compare intracranial magnetic resonance angiography (MRA) image quality using three different radiofrequency coils. The three coil types included a reduced volume quadrature birdcage coil with endcap, a commercially available quadrature birdcage head coil, and a four-element phased-array coil. Signal-to-noise ratio (SNR) measurements were obtained from comparison studies performed on a uniform cylindrical phantom. MRA comparisons were performed using data acquired from 15 volunteers and applying a thick-slab three-dimensional time-of-flight sequence. Analysis was performed using the signal difference-to-noise ratio, a quantitative measure of the relative vascular signal. The reduced-volume endcap and phased-array coils, which were designed specifically for imaging the intracranial volume of the head, improved the image SNR and vascular detail considerably over that obtained using the commercially available head coil. The endcap coil configuration provided the best vascular signal overall, while the phased-array coil provided the best results for arteries close to the coil elements.

BSH distributions in the canine head and a human patient using 11B MRI.

A 3D projection reconstruction (3DPR) method was used to obtain in vivo 11B images in a large canine brain tumor model and in a human infused with borocaptate sodium (BSH). Studies were performed in dogs with and without gliosarcomas implanted and grown to a size of 2-3 cm. The 3DPR method demonstrates a signal-to-noise ratio (SNR) that allows qualitative kinetic studies of the boron compound in normal and tumor tissue of the head. The measurements indicate initial uptake of the BSH compound in tumor to be less than that in muscle with no uptake in normal brain tissue. Moreover, uptake of BSH in tissue was found to lag the boron concentration in blood with delays that depend on tissue type. In addition, the first human boron images were obtained on a patient who underwent surgical resection and volumetric debulking of a large (7 cm) glioblastoma multiforme. BSH was readily taken up in residual tumor tissue, while diffusion into the resection volume was slower.