RESUMO
The 7th Amendment to the EU Cosmetics Directive and the EU REACH Regulation have reinforced the need for in vitro ocular test methods. Validated in vitro ocular toxicity tests that can predict the human response to chemicals, cosmetics and other consumer products are required for the safety assessment of materials that intentionally, or inadvertently, come into contact with the eye. The EpiOcular Eye Irritation Test (EIT), which uses the normal human cell-based EpiOcular™ tissue model, was developed to address this need. The EpiOcular-EIT is able to discriminate, with high sensitivity and accuracy, between ocular irritant/corrosive materials and those that require no labelling. Although the original EpiOcular-EIT protocol was successfully pre-validated in an international, multicentre study sponsored by COLIPA (the predecessor to Cosmetics Europe), data from two larger studies (the EURL ECVAM-COLIPA validation study and an independent in-house validation at BASF SE) resulted in a sensitivity for the protocol for solids that was below the acceptance criteria set by the Validation Management Group (VMG) for eye irritation, and indicated the need for improvement of the assay's sensitivity for solids. By increasing the exposure time for solid materials from 90 minutes to 6 hours, the optimised EpiOcular-EIT protocol achieved 100% sensitivity, 68.4% specificity and 84.6% accuracy, thereby meeting all the acceptance criteria set by the VMG. In addition, to satisfy the needs of Japan and the Pacific region, the EpiOcular-EIT method was evaluated for its performance after extended shipment and storage of the tissues (4-5 days), and it was confirmed that the assay performs with similar levels of sensitivity, specificity and reproducibility in these circumstances.
Assuntos
Olho/efeitos dos fármacos , Irritantes/toxicidade , Testes de Toxicidade/métodos , Alternativas aos Testes com Animais , HumanosRESUMO
Three-dimensional, organotypic models of the oral mucosa have been developed to study a wide variety of phenomena occurring in the oral cavity. Although a number of models have been developed in academic research labs, only a few models have been commercialized. Models from academic groups offer a broader range of phenotypes while the commercial models are more focused on the oral and gingival mucosa. The commercialized models are manufactured under highly controlled conditions and meet the requirements of quality standards, which leads to high levels of reproducibility. These in vitro models have been used to evaluate the irritancy of oral care products such as toothpastes, mouthwashes, and mucoadhesives. The effects of cigarette smoke on oral cavity tissues have been studied and compared to those of e-cigarettes. Oral tissue models have facilitated investigation of the mechanisms of oral mucositis and oral candidiasis and have been used to examine transbuccal drug delivery rates and the absorption of nanoparticles. Infection studies have investigated the effects of HIV-1 along with the effects of commensal and pathogenic bacteria. More recently, a differentiated oral tissue model has been shown to express the ACE2 receptor, which is known to be important for the receptor-mediated entry of the SARS-CoV-2 coronavirus into human cells and tissues. Hence, oral mucosal models may find application in determining whether viral infection of the oral mucosa is possible and whether such infection has implications vis-a-vis the current COVID-19 pandemic. As is apparent, these models are used in a broad variety of applications and often offer advantages versus animal models in terms of reproducibility, avoiding species extrapolation, and the ethical concerns related to human and animal experimentation. The goals of this paper are to review commercially available models of the human buccal and gingival mucosa and highlight their use to gain a better understanding of a broad range of phenomena affecting tissues in the oral cavity.
Assuntos
Materiais Dentários/efeitos adversos , Infecções , Mucosa Bucal/citologia , Mucosa Bucal/virologia , Técnicas de Cultura de Tecidos/métodos , COVID-19/transmissão , Sistemas de Liberação de Medicamentos/efeitos adversos , Sistemas de Liberação de Medicamentos/métodos , Humanos , Infecções/microbiologia , Infecções/virologia , Boca , Mucosa Bucal/microbiologia , Mucosa Bucal/patologia , Controle de Qualidade , SARS-CoV-2/patogenicidade , Técnicas de Cultura de Tecidos/instrumentação , Engenharia Tecidual , Nicotiana , Cremes Dentais/efeitos adversos , Raios Ultravioleta/efeitos adversosRESUMO
Assessment of dermal irritation is an essential component of the safety evaluation of medical devices. Reconstructed human epidermis (RhE) models have replaced rabbit skin irritation testing for neat chemicals and their mixtures (OECD Test Guideline 439). However, this guideline cannot be directly applied to the area of medical devices (MD) since their non-toxicity assessment is largely based on the testing of MD extracts that may have very low irritation potential. Therefore, the RhE-methods previously validated with neat chemicals needed to be modified to reflect the needs for detection of low levels of potential irritants. A protocol employing RhE EpiDerm was optimized in 2013 using known irritants and spiked polymers (Casas et al., 2013, TIV). In 2014 and 2015 MatTek In Vitro Life Science Laboratories (IVLSL) and RIVM assessed the transferability of the assay. After the successful transfer and standardization of the protocol, 17 laboratories were trained in the use of the protocol in the preparation for the validation. Laboratories produced data with 98% agreement of predictions for the selected references and controls. We conclude that a modified RhE skin irritation test has the potential to address the skin irritation potential of the medical devices. Standardization and focus on the technical issues is essential for accurate prediction.
Assuntos
Epiderme/efeitos dos fármacos , Equipamentos e Provisões , Irritantes/toxicidade , Polímeros/toxicidade , Testes de Irritação da Pele , Alternativas aos Testes com Animais , Epiderme/metabolismo , Humanos , Interleucina-1alfa/metabolismo , Reprodutibilidade dos TestesRESUMO
The Organisation for Economic Co-operation and Development (OECD) Test Guideline (TG) 439 is an in vitro test method of reconstructed human epidermis (RhE), which was developed for hazard identification of irritating chemicals in accordance with a primary skin irritation test using rabbits with 4-hr exposure. A regulation for quasi-drugs in Japan requires data from primary skin irritation tests using rabbits to undergo 24-hr exposure, and this is used as an evidence for 24-hr closed patch tests in humans. In this study with the same chemicals, primary skin irritation test data using rabbits undergoing 24-hr exposure and a 24-hr occlusive human patch test data were analyzed by comparing the results obtained with four test methods adopted in OECD TG 439. The performances of in vitro test methods showed a positive predictive value of 72.7-85.7% to predict the results of 24-hr primary rabbit skin irritation test knowing that its positive predictive value was 57.1% against humans only. The prediction factors of in vitro test methods were higher for the human patch test data with a sensitivity reaching 60 to 80%. Three surfactants gave false negatives in some of the RhE methods evaluated with the human patch test, but in each case, they were correctly classified as positive when evaluated at double concentration. Therefore, the approach of setting the margin to 2 was effective in eliminating false negatives. This suggests that in vitro test methods are useful for assessing skin irritation potential without animal testing for the application of quasi-drugs in Japan.