Thermal stability of Mg/Co multilayer with B4C, Mo or Zr diffusion barrier layers.

The efficiency of B(4)C, Mo and Zr barrier layers to improve thermal stability of Mg/Co multilayer up to 400 °C is investigated. Multilayers were deposited by direct current magnetron sputtering and characterized using X-ray and extreme ultraviolet reflection. The results suggest that B(4)C barrier layer is not effective due to drastic diffusion at Mg-B(4)C interface. Although introducing Mo barriers improves the thermal stability from 200 to 300 °C, it increases the interface roughness and thus degrades the optical performances. On the contrary, Zr barriers can significantly increase the thermal stability of Mg/Co up to 400 °C without optical performance degradation. Thus, Mg/Zr/Co/Zr is suitable for EUV applications requiring both optimal optical performances and heat resistance.

Structural properties of Al/Mo/SiC multilayers with high reflectivity for extreme ultraviolet light.

We present the results of an optical and chemical, depth and surface study of Al/Mo/SiC periodic multilayers, designed as high reflectivity coatings for the extreme ultra-violet (EUV) range. In comparison to the previously studied Al/SiC system, the introduction of Mo as a third material in the multilayer structure allows us to decrease In comparison to the previously studied Al/SiC system with a reflectance of 37% at near normal incidence around 17 nm, the introduction of Mo as a third material in the multilayer structure allows us to decrease the interfacial roughness and achieve an EUV reflectivity of 53.4%, measured with synchrotron radiation. This is the first report of a reflectivity higher than 50% around 17 nm. Time-of-flight secondary ion mass spectrometry (ToF-SIMS) and x-ray photoelectron spectroscopy (XPS) measurements are performed on the Al/Mo/SiC system in order to analyze the individual layers within the stack. ToF-SIMS and XPS results give evidence that the first SiC layer is partially oxidized, but the O atoms do not reach the first Mo and Al layers. We use these results to properly describe the multilayer stack and discuss the possible reasons for the difference between the measured and simulated EUV reflectivity values.

Comparison of Mg-based multilayers for solar He II radiation at 30.4 nm wavelength.

Mg-based multilayers, including SiC/Mg, Co/Mg, B(4)C/Mg, and Si/Mg, are investigated for solar imaging and a He II calibration lamp at a 30.4 nm wavelength. These multilayers were fabricated by a magnetron sputtering method and characterized by x-ray reflection. The reflectivities of these multilayers were measured by synchrotron radiation. Near-normal-incidence reflectivities of Co/Mg and SiC/Mg multilayer mirrors are as high as 40.3% and 44.6%, respectively, while those of B(4)C/Mg and Si/Mg mirrors are too low for application. The measured results suggest that SiC/Mg, Co/Mg multilayers are promising for a 30.4 nm wavelength.