RESUMO
INTRODUCTION: Evidence suggests that standards for resistance of furniture to ignition may lead to an increase in use of chemical flame retardants (CFRs). This is motivating the development of new approaches that maintain high levels of fire safety while facilitating a reduction in use of CFRs. However, reconciling potential fire risk with use of CFRs in relation to specific policy objectives is challenging. OBJECTIVES: To inform the development of a new policy in the UK for the fire safety of furniture, we developed for domestic furniture quantitative models of fire risk and potential for CFR exposure. We then combined the models to determine if any lower fire risk, higher CFR exposure categories of furniture were identifiable. METHODS: We applied a novel mixed-methods approach to modelling furniture fire risk and CFR exposure in a data-poor environment, using literature-based concept mapping, qualitative research, and data visualisation methods to generate fire risk and CFR exposure models and derive furniture product rankings. RESULTS: Our analysis suggests there exists a cluster of furniture types including baby and infant products and pillows that have comparable overall properties in terms of lower fire risk and higher potential for CFR exposure. DISCUSSION: There are multiple obstacles to reconciling fire risk and CFR use in furniture. In particular, these include a lack of empirical data that would allow absolute fire risk and exposure levels to be quantified. Nonetheless, it seems that our modelling method can potentially yield meaningful product clusters, providing a basis for further research.
Assuntos
Retardadores de Chama , Humanos , Decoração de Interiores e Mobiliário , Padrões de Referência , Políticas , Pesquisa QualitativaRESUMO
The toxic smoke production of four rainscreen façade systems were compared during large-scale fire performance testing on a reduced height BS 8414 test wall. Systems comprising 'non-combustible' aluminium composite material (ACM) with polyisocyanurate (PIR), phenolic foam (PF) and stone wool (SW) insulation, and polyethylene-filled ACM with PIR insulation were tested. Smoke toxicity was measured by sampling gases at two points - the exhaust duct of the main test room and an additional 'kitchen vent', which connects the rainscreen cavity to an occupied area. Although the toxicity of the smoke was similar for the three insulation products with non-combustible ACM, the toxicity of the smoke flowing from the burning cavity through the kitchen vent was greater by factors of 40 and 17 for PIR and PF insulation respectively, when compared to SW. Occupants sheltering in a room connected to the vent are predicted to collapse, and then inhale a lethal concentration of asphyxiant gases. This is the first report quantifying fire conditions within the cavity and assessing smoke toxicity within a rainscreen façade cavity.
RESUMO
Four reduced-height (5 m) BS 8414-1 façade flammability tests were conducted, three having mineral-filled aluminium composite material (ACM-A2) with polyisocyanurate (PIR) and phenolic (PF) foam and stone wool (SW) insulation, the fourth having polyethylene-filled ACM (ACM-PE) with PIR insulation. Each façade was constructed from a commercial façade engineer's design, and built by practising façade installers. The ACM-PE/PIR façade burnt so ferociously it was extinguished after 13.5 min, for safety. The three ACM-A2 cladding panels lost their structural integrity, and melted away from the test wall, whereupon around 40% of both the combustible PIR and PF insulation burnt and contributed to the fire spread. This demonstrates why all façade products must be non-combustible, not just the outer panels. For the three ACM-A2 tests, while the temperature in front of the cavity was independent of the insulation, the temperatures within it varied greatly, depending on the insulation. The system using PF/A2 allowed fire to break through to the cavity first, as seen by a sharp increase in temperature after 17 min. For PIR/A2, the temperature increased sharply at 22 minutes, as the panel started to fall away from the wall. For SW/A2, no rapid temperature rise was observed.
RESUMO
Among the many and varied applications of nanotechnology, the dispersion of nanoscopic fillers to form polymer nanocomposites with improved fire behaviour illustrates the potential and diversity of nanoscience. Different polymers decompose in different ways and fire retardants act to inhibit the decomposition or flaming combustion processes. Polymer nanocomposites form barriers between the fuel and air, reducing the rate of burning, but beyond that there is little consistency in their effects. It is shown that the decomposition products of polypropylene are changed by the presence of nanoclay, although there is only a small influence on the mass loss rate. The rheological properties of molten polymer nanocomposites are radically different from those of virgin polymers, and these will profoundly affect the heat transfer through the material, resulting in a shorter time to ignition and lower peak in the heat release rate, typical of polymer nanocomposites. The dispersion of nanofillers within polymers is generally measured in the cold polymer, but since this does not reflect the condition at the time of ignition, it is proposed that temperature ramped rheological measurements are more appropriate indicators of dispersion. The influence of polymer nanocomposite formation on the yields of toxic products from fire is studied using the ISO 19700 steady state tube furnace, and it is found that under early stages of burning more carbon monoxide and organoirritants are formed, but under the more toxic under-ventilated conditions, less toxic products are formed.
RESUMO
The 2017 Grenfell Tower fire spread rapidly around the combustible façade system on the outside of the building, killing 72 people. We used a range of micro- and bench-scale methods to understand the fire behaviour of different types of façade product, including those used on the Tower, in order to explain the speed, ferocity and lethality of the fire. Compared to the least flammable panels, polyethylene-aluminium composites showed 55x greater peak heat release rates (pHRR) and 70x greater total heat release (THR), while widely-used high-pressure laminate panels showed 25x greater pHRR and 115x greater THR. Compared to the least combustible insulation products, polyisocyanurate foam showed 16x greater pHRR and 35x greater THR, while phenolic foam showed 9x greater pHRR and 48x greater THR. A few burning drips of polyethylene from the panelling are enough to ignite the foam insulation, providing a novel explanation for rapid flame-spread within the facade. Smoke from polyisocyanurates was 15x, and phenolics 5x more toxic than from mineral wool insulation. 1 kg of burning polyisocyanurate insulation is sufficient to fill a 50m3 room with an incapacitating and ultimately lethal effluent. Simple, additive models are proposed, which provide the same rank order as BS8414 large-scale regulatory tests.
RESUMO
This paper uses fire statistics to show the importance of fire toxicity on fire deaths and injuries, and the importance of upholstered furniture and bedding on fatalities from unwanted fires. The aim was to compare the fire hazards (fire growth and smoke toxicity) using different upholstery materials. Four compositions of sofa-bed were compared: three meeting UK Furniture Flammability Regulations (FFR), and one using materials without flame retardants intended for the mainland European market. Two of the UK sofa-beds relied on chemical flame retardants to meet the FFR, the third used natural materials and a technical weave in order to pass the test. Each composition was tested in the bench-scale cone calorimeter (ISO 5660) and burnt as a whole sofa-bed in a sofa configuration in a 3.4â¯×â¯2.25â¯×â¯2.4â¯m3 test room. All of the sofas were ignited with a No. 7 wood crib; the temperatures and yields of toxic products are reported. The sofa-beds containing flame retardants burnt somewhat more slowly than the non-flame retarded EU sofa-bed, but in doing so produced significantly greater quantities of the main fire toxicants, carbon monoxide and hydrogen cyanide. Assessment of the effluents' potential to incapacitate and kill is provided showing the two UK flame retardant sofa-beds to be the most dangerous, followed by the sofa-bed made with European materials. The UK sofa-bed made only from natural materials (Cottonsafe®) burnt very slowly and produced very low concentrations of toxic gases. Including fire toxicity in the FFR would reduce the chemical flame retardants and improve fire safety.
Assuntos
Retardadores de Chama/toxicidade , Decoração de Interiores e Mobiliário , Fumaça , Leitos/normas , Monóxido de Carbono/toxicidade , Incêndios/prevenção & controle , Gases/toxicidadeRESUMO
Here, we propose a self-assembly process to prepare hierarchical HM-SiO2@Co-Al LDH@graphene, with the purpose of combining their outstanding performance. Hollow mesoporous silica was first synthesized as the core, using a novel sonochemical method, followed by a controlled shell coating process and chemical reduction. As a result of the electrostatic potential difference among HM-SiO2, Co-Al LDH, and graphene oxide, the HM-SiO2 spheres were coated by Co-Al LDH and graphene. Subsequently, the HM-SiO2@Co-Al LDH@graphene spheres were introduced into an epoxy resin (EP) matrix for investigation of their toxic effluents capture and elimination effectiveness during combustion. The amount of toxic CO and volatile organic compounds from the epoxy resin decomposition significantly suppressed after incorporating the HM-SiO2@Co-Al LDH@graphene hybrids, implying a reduced toxicity.
Assuntos
Incêndios , Retardadores de Chama , Decoração de Interiores e Mobiliário , Fumaça , Reino UnidoRESUMO
The production of carbon monoxide from disposable barbecues in an enclosed room has been investigated. Hazard calculations have shown that lethal concentrations of CO and CO2 can be produced easily. Burning rates and the relative formation of CO and CO2 depend on the ambient oxygen concentration. Smoke does not correlate with CO concentration as it is mostly produced by the combustion of volatile hydrocarbons added to facilitate ignition. In a typical room, this results in smoke clearing before the maximum CO concentration is reached. Smoke obscuration is therefore a poor indicator of the danger posed by CO. This is an important observation for those discovering or attempting to resuscitate or rescue comatose victims. Dilution caused by ventilation is described numerically and has allowed total volumes of CO and CO2 produced to be estimated.
RESUMO
Hierarchical mesoporous silica@Co-Al layered double hydroxide (m-SiO2@Co-Al LDH) spheres were prepared through a layer-by-layer assembly process, in order to integrate their excellent physical and chemical functionalities. TEM results depicted that, due to the electrostatic potential difference between m-SiO2 and Co-Al LDH, the synthetic m-SiO2@Co-Al LDH hybrids exhibited that m-SiO2 spheres were packaged by the Co-Al LDH nanosheets. Subsequently, the m-SiO2@Co-Al LDH spheres were incorporated into epoxy resin (EP) to prepare specimens for investigation of their flame-retardant performance. Cone results indicated that m-SiO2@Co-Al LDH incorporated obviously improved fire retardant of EP. A plausible mechanism of fire retardant was hypothesized based on the analyses of thermal conductivity, char residues, and pyrolysis fragments. Labyrinth effect of m-SiO2 and formation of graphitized carbon char catalyzed by Co-Al LDH play pivotal roles in the flame retardance enhancement.
RESUMO
A fire experiment conducted in a British 1950s-style house is described. Measurements of temperature, smoke, CO, CO2 , and O2 were taken in the Lounge, stairwell, and front and back bedrooms. The front bedroom door was wedged open, while the door to the back bedroom was wedged closed. Contrary to expectations and despite the relatively small fire load, analysis and hazard calculations show permeation of toxic fire gases throughout the property with lethal concentrations of effluent being measured at each sampling point. A generally poor state of repair and missing carpets in the upper story contributed to a high degree of gas and smoke permeation. The available egress time was calculated as the time before the main escape route became impassable. Given known human responses to fire, such an incident could have caused fatalities to sleeping or otherwise immobile occupants.