MRI susceptibility artefacts caused by orthodontic wire.

OBJECTIVES: To evaluate magnetic susceptibility artefacts produced by orthodontic wires on MRI and the influence of wire properties and MRI image sequences on the magnitude of the artefact. METHODS: Arch form orthodontic wires [four stainless steels (SS), one cobalt chromium (CC) alloy, 13 titanium (Ti) alloys] were embedded in a polyester phantom, and scanned using a 1.5-T superconducting magnet scanner with an eight-channel phased-array coil. All wires were scanned with T1-weighted spin echo (SE) and gradient echo (GRE) sequences according to the American Society for Testing and Materials (ASTM) F2119-07 standard. The phantom was also scanned other eight sequences. Artefacts were measured using the ASTM F2119-07 definition and OsiriX software. Artefact volume was analyzed according to metal composition, wire length, number of wires, wire thickness, and imaging sequence as factors. RESULTS: With SE/GRE, black/white artefacts volumes from all SS wires were significantly larger than those produced by CC and Ti wires (P < 0.01). With the GRE, the black artefacts volume was highest with the SS wires. With the SE, the black artefacts volume was small, whereas white artefacts were noticeable. The cranio-caudal extent of the artefacts was significantly longer with SS wires (P < 0.01). Although a direct relationship of wire length, number of wires and wire thickness with artefact volume was noted, these factors did not influence artefact extension in the cranio-caudal direction. CONCLUSIONS: Ferromagnetic/paramagnetic orthodontic wires create artefacts due to local alteration of magnetic field homogeneity. The SS-type wires produced the largest artefacts followed by CC and Ti.

Accessory lingual mental foramen: A case report of a rare anatomic variation.

INTRODUCTION: The mandibular nerve and the mental foramen have occasionally shown variations in its anatomy. This report aims to present a case of lingual mental foramen recognised on three-dimensional cone beam computed tomographic imaging (CBCT). CASE REPORT: Routine Orthopantomogram (OPG) and CBCT images were evaluated to assess the status of impact third molars in a 31-year-old female who had visited the dental clinics in our institution. The OPG image failed to reveal any anatomic variation in the position of the mental foramen. On tracing the course of the mandibular canal in CBCT images, two foramina were traced at the region of premolar. One opened towards the buccal cortical plate at the normal position of the mental foramen and an accessory lingual mental foramen had an opening on the lingual cortical bone at the same level as the mental foramen. CONCLUSION: Understanding variations of the mental foramen is extremely essential in dentistry to carry out successful anaesthetic or surgical interventions and to avoid complications such as nerve damage or excessive bleeding.