An environmentally friendly approach for the characterization of construction materials: determination of trace, minor, and major elements by slurry sampling high-resolution continuum source graphite furnace atomic absorption spectrometry.

A slurry sampling method was developed for the fast determination of Pb, Ni, Fe, and Mn in construction materials by high-resolution continuum source graphite furnace atomic absorption spectrometry (HR-CS GFAAS). For sample introduction into the GF, stable slurries were prepared by sonicating 10 mg of ground solid sample in 10.0 mL of 1% (v/v) Triton X-100 and 1% (v/v) HNO3 solution for 1.0 min. The determination of the four elements was carried out in three measurement runs, with Ni and Fe being determined simultaneously. The HR-CS GFAAS measurements were performed using analytical lines with adequate sensitivity, considering the content of each element in the material: Pb at 283.306 nm (42%), Mn at 403.080 nm (6.7%), Ni at 232.003 nm (100%) and Fe at 232.036 nm (1.4%). The pyrolysis and atomization temperatures and the use of chemical modifiers were optimized using both aqueous standards and slurry samples. At optimal conditions, samples with concentrations of Pb from 1.5 to 80 µg g-1, Ni from 4.0 to 75 µg g-1, Mn from 2.0 to 600 µg g-1, and Fe from 0.15 to 60 mg g-1 could be determined using a unique sample suspension. To assess the validity of the method, a fly ash certified reference material (CRM) was analysed using the slurry sampling HR-CS GFAAS method; this CRM and the construction material samples were also analysed by HR-CS GFAAS after the digestion of the samples. The obtained results using both methods were statistically comparable (Student's paired t-test for two independent methods at a 95% confidence level) demonstrating the suitability of the proposed method.

Compounding Achromobacter Phages for Therapeutic Applications.

Achromobacter species colonization of Cystic Fibrosis respiratory airways is an increasing concern. Two adult patients with Cystic Fibrosis colonized by Achromobacter xylosoxidans CF418 or Achromobacter ruhlandii CF116 experienced fatal exacerbations. Achromobacter spp. are naturally resistant to several antibiotics. Therefore, phages could be valuable as therapeutics for the control of Achromobacter. In this study, thirteen lytic phages were isolated and characterized at the morphological and genomic levels for potential future use in phage therapy. They are presented here as the Achromobacter Kumeyaay phage collection. Six distinct Achromobacter phage genome clusters were identified based on a comprehensive phylogenetic analysis of the Kumeyaay collection as well as the publicly available Achromobacter phages. The infectivity of all phages in the Kumeyaay collection was tested in 23 Achromobacter clinical isolates; 78% of these isolates were lysed by at least one phage. A cryptic prophage was induced in Achromobacter xylosoxidans CF418 when infected with some of the lytic phages. This prophage genome was characterized and is presented as Achromobacter phage CF418-P1. Prophage induction during lytic phage preparation for therapy interventions require further exploration. Large-scale production of phages and removal of endotoxins using an octanol-based procedure resulted in a phage concentrate of 1 × 109 plaque-forming units per milliliter with an endotoxin concentration of 65 endotoxin units per milliliter, which is below the Food and Drugs Administration recommended maximum threshold for human administration. This study provides a comprehensive framework for the isolation, bioinformatic characterization, and safe production of phages to kill Achromobacter spp. in order to potentially manage Cystic Fibrosis (CF) pulmonary infections.

Citizen science and expert opinion working together to understand the impacts of climate change.

In the absence of historical information on phenology available in Australia, expert opinion was used for selecting indicator species that would be suitable for monitoring phenology on a continental scale as part of ClimateWatch-a citizen science program. Jacaranda mimosifolia being the most frequently observed species was used in this study to test expert opinion and the adequacy of citizen science records in detecting the influence of climatic conditions on this species' flowering phenology. Generalised Additive Models for Location Scale and Shape were used to explore the occurrence and intensity of flowering of Jacaranda in relation to rainfall, temperature, and sun exposure. Jacaranda flowering onset was influenced by winter cold exposure, while flowering intensity was related to increasing sun exposure as spring progresses, and both were influenced by the conditions for flowering in the former flowering seasons (i.e., sun exposure and highest temperatures reached, respectively). Our models provide the first attempt to describe the climate drivers for Jacaranda mimosifolia flowering in the southern hemisphere and identify where climatic changes will most likely alter this tree's phenology in Australia and benefit or challenge its reproductive ability. They also support the choice of species for citizen science programs based on expert opinion.

Quantitative Comparison of Binary Mix of Agro-Industrial Pozzolanic Additions for Elaborating Ternary Cements: Kinetic Parameters.

In this research work, the quantitative characterization of a binary blend comprised of two pozzolans (sugar cane straw (SCSA)-sugar cane bagasse ashes (SCBA), bamboo leaf ash (BLAsh)-SCBA and paper sludge (PS)-fly ash (FA)) taking into account the calculated values of the kinetic parameters of the reaction in the pozzolan/calcium hydroxide system is shown. The paper shows the most significant and important results obtained by the authors in the quantitative assessment (calculation of kinetic parameters) of the pozzolanic reaction of different mixtures of pozzolanic materials that are residues from agriculture or industrial processes. This allows a direct and rigorous comparison of the pozzolanic activity of the binary combinations of materials. The values of the kinetic parameters (reaction rate constant or activation free energy) constitute a very precise quantitative index of the pozzolanic activity of the binary combinations of materials, which is very useful for its employment in the elaboration of ternary cements. This paper shows that the binary blends 1SCBA60Blash40, 1SCBA50Blash50, 1SCBA70Blash30 have a very high pozzolanic reactivity followed by PSLSFA, 2SCBA50SCSA50, PSISFA and SCWI.

Recycled Precast Concrete Kerbs and Paving Blocks, a Technically Viable Option for Footways.

The linear economy paradigm in place to date has to be seriously challenged to give way to a new school of thought known as the circular economy. In this research work, precast kerbs and paving blocks made with recycled concrete (RACC-mixture) bearing 50 wt% mixed recycled aggregate (masonry content of 33%) and an eco-efficient cementitious material as 25 wt% conventional binder replacement were evaluated to assess their intrinsic potential to replace traditional raw materials, in keeping with circular economy criteria. Therefore, precast products were subjected to mechanical strength, durability and microstructure tests and were compared to conventional concrete units (CC-mixture and commercially available precast elements). Although a class demotion was observed for water absorption and some decreases in flexural strength (26%), splitting tensile strength (12.8%) and electrical resistivity (45%) and a lower class water absorption were registered, and the recycled mixture also exhibited a greater performance in terms of compressive strength (6%), a better abrasion resistance classification and a comparable porosity and microstructure, which ensures a good concrete durability. In any case, the results showed that precast pieces were European standard-compliant, thus supporting the viability of the mixed recycled aggregates and eco-efficient cementitious replacement in footways.

Sulfate Resistance in Cements Bearing Ornamental Granite Industry Sludge.

This study explores the effect on sulfate resistance of the use of ornamental granite industry waste as a supplementary cementitious material (at replacement ratios of 10% and 20%) in cement manufacture. The present paucity of scientific knowledge of the behaviour of these new cements when exposed to an external source of sulfates justifies the need for, and the originality of, this research. After characterising the waste chemically and mineralogically, cement paste specimens were prepared in order to determine the durability of the newly designed eco-cements using Köch-Steinegger corrosion indices. The new hydration products, which might induce microstructural, mineralogical, or morphological decay in the specimens, were also analysed by comparing the samples before and after soaking in a sodium sulfate solution for different test periods. Respect to the results, the damage to pastes bearing 10% granite sludge (GS) is the same as observed in OPC, whilst the former exhibit a higher Köch-Steinegger corrosion rate (1.61) than both OPC and OPC+20GS. Soaking the pastes in sodium sulfate induces matrix densification due to ettringite formation and gypsum precipitation in the pores. Further to those results, at an optimal replacement ratio of 10%, these alternative, eco-friendlier materials can be used in the design and construction of non-structural cement-based (mortar or concrete) members exposed to an external source of sulfate.

Dietary prophage inducers and antimicrobials: toward landscaping the human gut microbiome.

The approximately 1011 viruses and microbial cells per gram of fecal matter (dry weight) in the large intestine are important to human health. The responses of three common gut bacteria species, and one opportunistic pathogen, to 117 commonly consumed foods, chemical additives, and plant extracts were tested. Many compounds, including Stevia rebaudiana and bee propolis extracts, exhibited species-specific growth inhibition by prophage induction. Overall, these results show that various foods may change the abundances of gut bacteria by modulating temperate phage and suggests a novel path for landscaping the human gut microbiome.

Phage on tap-a quick and efficient protocol for the preparation of bacteriophage laboratory stocks.

A major limitation with traditional phage preparations is the variability in titer, salts, and bacterial contaminants between successive propagations. Here we introduce the Phage On Tap (PoT) protocol for the quick and efficient preparation of homogenous bacteriophage (phage) stocks. This method produces homogenous, laboratory-scale, high titer (up to 10(10-11) PFU·ml(-1)), endotoxin reduced phage banks that can be used to eliminate the variability between phage propagations and improve the molecular characterizations of phage. The method consists of five major parts, including phage propagation, phage clean up by 0.22 µm filtering and chloroform treatment, phage concentration by ultrafiltration, endotoxin removal, and the preparation and storage of phage banks for continuous laboratory use. From a starting liquid lysate of > 100 mL, the PoT protocol generated a clean, homogenous, laboratory phage bank with a phage recovery efficiency of 85% within just two days. In contrast, the traditional method took upwards of five days to produce a high titer, but lower volume phage stock with a recovery efficiency of only 4%. Phage banks can be further purified for the removal of bacterial endotoxins, reducing endotoxin concentrations by over 3,000-fold while maintaining phage titer. The PoT protocol focused on T-like phages, but is broadly applicable to a variety of phages that can be propagated to sufficient titer, producing homogenous, high titer phage banks that are applicable for molecular and cellular assays.

Central diabetes insipidus: clinical profile that suggests organicity in Peruvian children: Lima - Peru 2001-2013.

BACKGROUND: Central diabetes insipidus (CDI) is a heterogeneous disease caused by arginine vasopressin deficiency; its management implies a profound understanding of the pathophysiology and the clinical spectrum. The aim of the study was to describe the clinical characteristics that indicate organicity in children and adolescents with central diabetes insipidus treated at the Department of Endocrinology from The Child Health's Institute during 2001 to 2013. METHODS: Cross-sectional, retrospective study. 79 cases of patients diagnosed with CDI (51 males and 28 females) from 1 month to 16 years of age were reviewed. For the descriptive analysis, measures of central tendency and dispersion were used; groups of organic and idiopathic CDI were compared using χ2-test and t-test. A p-value<0.05 was considered significant. RESULTS: The average age of patients was 8.1±4.2 years. Organic causes were intracranial tumors, 44 (55.7%), Langerhans cell histiocytosis (LCH), 11 (13.9%) and cerebral malformations in 7 (8.9%) patients, while the idiopathic group was 14 (17.7%) patients. Regarding clinical characteristics suggestive of organicity, headache (p=0.02) and visual disturbances (p=0.01) were found statistically significant. The anterior pituitary hormonal abnormalities were documented in 34 (52.3%) organic CDI patients. Furthermore, we did not find a significant difference in the average daily dose of desmopressin between patients with permanent vs. transitory CDI (0.81±0.65 vs. 0.59±0.62; p=0.363). CONCLUSIONS: The main clinical features suggestive of organicity in pediatric patients with central diabetes insipidus were headache and visual disturbances; furthermore, anterior pituitary hormonal abnormalities suggest an underlying organic etiology.

Embarazo intraligamentario / Intraligamentous pregnancy

Reportamos el caso de una mujer de 28 años con embarazo intraligamentario atendida en el Hospital Regional Universitario de Trujillo. Enfatizamos sus características clínicas y fisiopatológicas asi como su manejo