Complex Geometric Structure of a Simple Solid-Liquid Interface: GaN(0001)-Ga.

The equilibrium atomic interface structure between Ga and GaN(0001) is shown to contain substrate surface vacancies followed by substrate-induced layering and preferential lateral ordering in the liquid. The uncovered presence of point defects, in the form of vacancies at both sides of the solid-liquid interface, is an important structural feature which governs the local physical properties. Our x-ray diffraction study reveals that the layering is very stable and persists up to a temperature of 1123 K and a nitrogen pressure of 32 bar. The Ga layer spacing agrees remarkably well with the Friedel oscillation period for this system.

Metal diffusion barriers for GaAs solar cells.

In this study accelerated ageing testing (AAT), J-V characterization and TEM imaging in combination with phase diagram data from literature are used to assess the potential of Ti, Ni, Pd and Pt as diffusion barriers for Au/Cu-based metallization of III-V solar cells. Ni barriers show the largest potential as at an AAT temperature of 250 °C both cells with 10 and 100 nm thick Ni barriers show significantly better performance compared to Au/Cu cells, with the cells with 10 nm Ni barriers even showing virtually no degradation after 7.5 days at 250 °C (equivalent to 10 years at 100 °C at an Ea of 0.70 eV). Detailed investigation shows that Ni does not act as a barrier in the classical sense, i.e. preventing diffusion of Cu and Au across the barrier. Instead Ni modifies or slows down the interactions taking place during device degradation and thus effectively acts as an 'interaction' barrier. Different interactions occur at temperatures below and above 250 °C and for thin (10 nm) and thick (100 nm) barriers. The results of this study indicate that 10-100 nm thick Ni intermediate layers in the Cu/Au based metallization of III-V solar cells may be beneficial to improve the device stability upon exposure to elevated temperatures.

Degradation mechanism(s) of GaAs solar cells with Cu contacts.

Substrate-based GaAs solar cells having a dense Au/Cu front contact grid with 45% surface coverage were exposed to accelerated life testing at temperatures between 200 and 300 °C. TEM analysis of the front contacts was used to gain a better understanding of the degradation process. During accelerated life testing at 200 °C only intermixing of the Au and Cu in the front contact occurs, without any significant influence on the J-V curve of the cells, even after 1320 h (55 days) of accelerated life testing. At temperatures ≥250 °C a recrystallization process occurs in which the metals of the contact and the GaAs front contact layer interact. Once the grainy recrystallized layer starts to approach the window, diffusion via grain boundaries to the window and into the active region of the solar cells occurs, causing a decrease in Voc due to enhanced non-radiative recombination via Cu trap levels introduced in the active region of the solar cell. To be a valid simulation of space conditions the accelerated life testing temperature should be <250 °C in future experiments, in order to avoid recrystallization of the metals with the GaAs contact layer.

Phase transition driven discontinuity in thermodynamic size selection.

We show how an order-disorder phase transition in a two-dimensional system can discontinuously alter the shape and size of stress-stabilized self-assembled nanostructures. Low energy electron microscopy was used to study the dealloying of the Cu(111)-sqrt[3]×sqrt[3]-R30°-Bi surface alloy. The gradual expulsion of embedded bismuth from the alloy with increasing temperature induces a hard-hexagon-type order-disorder transition in the surface alloy. Our low energy electron microscopy results demonstrate how the loss of long-range order induces enormous changes in the domain patterns that the alloy forms with a Bi overlayer phase. We propose that the occurrence of phase transitions in one of the two surface phases that constitute a self-assembled domain pattern, provides a general, largely unexplored, mechanism that can be used to influence the morphological details of two-dimensional nanostructures.

Generic nano-imprint process for fabrication of nanowire arrays.

A generic process has been developed to grow nearly defect-free arrays of (heterostructured) InP and GaP nanowires. Soft nano-imprint lithography has been used to pattern gold particle arrays on full 2 inch substrates. After lift-off organic residues remain on the surface, which induce the growth of additional undesired nanowires. We show that cleaning of the samples before growth with piranha solution in combination with a thermal anneal at 550 degrees C for InP and 700 degrees C for GaP results in uniform nanowire arrays with 1% variation in nanowire length, and without undesired extra nanowires. Our chemical cleaning procedure is applicable to other lithographic techniques such as e-beam lithography, and therefore represents a generic process.

On the mechanism of solid-state phase transitions in molecular crystals - the role of cooperative motion in (quasi)racemic linear amino acids.

During single-crystal-to-single-crystal (SCSC) phase transitions, a polymorph of a compound can transform to a more stable form while remaining in the solid state. By understanding the mechanism of these transitions, strategies can be developed to control this phenomenon. This is particularly important in the pharmaceutical industry, but also relevant for other industries such as the food and agrochemical industries. Although extensive literature exists on SCSC phase transitions in inorganic crystals, it is unclear whether their classications and mechanisms translate to molecular crystals, with weaker interactions and more steric hindrance. A comparitive study of SCSC phase transitions in aliphatic linear-chain amino acid crystals, both racemates and quasi-racemates, is presented. A total of 34 transitions are considered and most are classified according to their structural change during the transition. Transitions without torsional changes show very different characteristics, such as transition temperature, enthalpy and free energy, compared with transitions that involve torsional changes. These differences can be rationalized using classical nucleation theory and in terms of a difference in mechanism; torsional changes occur in a molecule-by-molecule fashion, whereas transitions without torsional changes involve cooperative motion with multiple molecules at the same time.

Experimental and computational morphology of three polymorphs of the free base of Venlafaxine: a comparison of morphology prediction methods.

In this paper the experimental and the computational studies of the morphology of three polymorphs of the free base of Venlafaxine ((N,N-dimethyl)-2-(1-hydroxy cyclohex-1-yl)-2-(4-methoxyphenyl) ethylamine) are reported. The morphology of all polymorphs has been predicted using the Bravais-Friedel-Donnay-Harker method, the attachment energy method and kinetic Monte Carlo growth simulations and these predictions have been compared with experimental observations. The Monte Carlo simulations allow for a detailed simulation of the growth process, including driving force and growth mechanism, which leads to a semi-quantitative prediction of the growth morphologies of all three phases. For phase I two distinct growth habits are found experimentally under the same conditions. This is explained by the occurrence of a spiral growth mechanism in one of the two, which was observed using AFM and which is also supported by the Monte Carlo simulations. The habit of phase II could only be explained from simulations when a spiral growth mechanism is assumed; the shape of phase III could not be modeled accurately from the Monte Carlo simulations. Although the shape of the crystal is reproduced accurately, some of the indices of the faces predicted are not in agreement with the indices measured. The deviations are interpreted to be due to the presence of domains in the crystals as a result of the layered structure.

On the definition of a Monte Carlo model for binary crystal growth.

We show that consistency of the transition probabilities in a lattice Monte Carlo (MC) model for binary crystal growth with the thermodynamic properties of a system does not guarantee the MC simulations near equilibrium to be in agreement with the thermodynamic equilibrium phase diagram for that system. The deviations remain small for systems with small bond energies, but they can increase significantly for systems with large melting entropy, typical for molecular systems. These deviations are attributed to the surface kinetics, which is responsible for a metastable zone below the liquidus line where no growth occurs, even in the absence of a 2D nucleation barrier. Here we propose an extension of the MC model that introduces a freedom of choice in the transition probabilities while staying within the thermodynamic constraints. This freedom can be used to eliminate the discrepancy between the MC simulations and the thermodynamic equilibrium phase diagram. Agreement is achieved for that choice of the transition probabilities yielding the fastest decrease of the free energy (i.e., largest growth rate) of the system at a temperature slightly below the equilibrium temperature. An analytical model is developed, which reproduces quite well the MC results, enabling a straightforward determination of the optimal set of transition probabilities. Application of both the MC and analytical model to conditions well away from equilibrium, giving rise to kinetic phase diagrams, shows that the effect of kinetics on segregation is even stronger than that predicted by previous models.

Crystal growth in a three-phase system: diffusion and liquid-liquid phase separation in lysozyme crystal growth.

In the phase diagram of the protein hen egg-white lysozyme, a region is present in which the lysozyme solution demixes and forms two liquid phases. In situ observations by optical microscopy show that the dense liquid droplets dissolve when crystals grow in this system. During this process the demixed liquid region retracts from the crystal surface. The spatial distribution of the dense phase droplets present special boundary conditions for Fick's second law for diffusion. In combination with the cylindrical symmetry provided by the kinetically roughened crystals, this system allows for a full numerical analysis. Using experimental data for setting the boundary conditions, a quasi-steady-state solution for the time-dependent concentration profile was shown to be valid. Comparison of kinetically rough growth in a phase separated system and in a nonseparated system shows that the growth kinetics for a three-phase system differs from a two-phase system, in that crystals grow more slowly but the duration of growth is prolonged.

Epitaxial 2D nucleation of the stable polymorphic form of the steroid 7alphaMNa on the metastable form: implications for Ostwald's rule of stages.

This paper presents in situ observations of the epitaxial nucleation and growth of the stable polymorph of a steroid, 7alphaMna, on a specific face of the metastable form at low supersaturation, using optical microscopy and in situ Raman spectroscopy. The presence of the metastable polymorph is essential for the nucleation and growth of the stable one. The order of the metastable zones of the stable and metastable polymorphs is reversed for the epitaxial growth process as compared to the case of 3D nucleation. The rate of transformation of the metastable polymorph to the stable one can be controlled by the supersaturation.