Femtosecond pulse laser cleaning of spray paint from heritage stone surfaces.

We explore the use of femtosecond laser pulses to clean a variety of colors of spray paint from the Moruya granite, a stone with high heritage value that is widely used for monuments and sculptures in Sydney and New South Wales (Australia). The efficiency of the cleaning treatment and the effects on the stone substrate are evaluated using optical microscopy, optical profilometry, Raman spectroscopy, energy-dispersive X-ray spectroscopy, and colorimetry. We demonstrate that femtosecond laser cleans granite without damaging it and without discoloration when the laser fluence is set below the damage threshold of the stone.

Third international challenge to model the medium- to long-range transport of radioxenon to four Comprehensive Nuclear-Test-Ban Treaty monitoring stations.

In 2015 and 2016, atmospheric transport modeling challenges were conducted in the context of the Comprehensive Nuclear-Test-Ban Treaty (CTBT) verification, however, with a more limited scope with respect to emission inventories, simulation period and number of relevant samples (i.e., those above the Minimum Detectable Concentration (MDC)) involved. Therefore, a more comprehensive atmospheric transport modeling challenge was organized in 2019. Stack release data of Xe-133 were provided by the Institut National des Radioéléments/IRE (Belgium) and the Canadian Nuclear Laboratories/CNL (Canada) and accounted for in the simulations over a three (mandatory) or six (optional) months period. Best estimate emissions of additional facilities (radiopharmaceutical production and nuclear research facilities, commercial reactors or relevant research reactors) of the Northern Hemisphere were included as well. Model results were compared with observed atmospheric activity concentrations at four International Monitoring System (IMS) stations located in Europe and North America with overall considerable influence of IRE and/or CNL emissions for evaluation of the participants' runs. Participants were prompted to work with controlled and harmonized model set-ups to make runs more comparable, but also to increase diversity. It was found that using the stack emissions of IRE and CNL with daily resolution does not lead to better results than disaggregating annual emissions of these two facilities taken from the literature if an overall score for all stations covering all valid observed samples is considered. A moderate benefit of roughly 10% is visible in statistical scores for samples influenced by IRE and/or CNL to at least 50% and there can be considerable benefit for individual samples. Effects of transport errors, not properly characterized remaining emitters and long IMS sampling times (12-24 h) undoubtedly are in contrast to and reduce the benefit of high-quality IRE and CNL stack data. Complementary best estimates for remaining emitters push the scores up by 18% compared to just considering IRE and CNL emissions alone. Despite the efforts undertaken the full multi-model ensemble built is highly redundant. An ensemble based on a few arbitrary runs is sufficient to model the Xe-133 background at the stations investigated. The effective ensemble size is below five. An optimized ensemble at each station has on average slightly higher skill compared to the full ensemble. However, the improvement (maximum of 20% and minimum of 3% in RMSE) in skill is likely being too small for being exploited for an independent period.

Nanoscale mapping of catalytic activity using tip-enhanced Raman spectroscopy.

Chemical mapping of a photocatalytic reaction with nanoscale spatial resolution is demonstrated for the first time using tip-enhanced Raman spectroscopy (TERS). An ultrathin alumina film applied to the Ag-coated TERS tip blocks catalytic interference whilst maintaining near-field electromagnetic enhancement, thus enabling spectroscopic imaging of catalytic activity on nanostructured Ag surfaces.

Semi-hydrogenation of alkynes at single crystal, nanoparticle and biogenic nanoparticle surfaces: the role of defects in Lindlar-type catalysts and the origin of their selectivity.

For the first time, the method of shell-isolated nanoparticle Raman spectroscopy (SHINERS) is used in combination with cyclic voltammetry (CV) and reactivity studies to investigate the adsorption behaviour of a series of three alkynes undergoing hydrogenation on nanoparticle, single crystal and bacteria/graphite-supported platinum surfaces. It is found that a strong association of alkynes with defect sites to produce a long-lived di-sigma/pi-alkene surface complex allows for deep hydrogenation of this intermediate to the alkane product. In contrast, when platinum surface defect sites are blocked by either bismuth or polyvinylpyrrolidone (PVP) (and thus leaving behind only Pt{111} terrace adsorption sites), large increases in selectivity to the semi-hydrogenation product are observed for all three alkynes. This finding is consistent with SHINERS collected from both well-ordered and roughened Pt{111} electrodes which revealed that the di-sigma/pi-bonded surface intermediate is hardly formed at all on Pt{111} unless defect sites are introduced via electrochemical roughening. As a general method of producing selective catalysts, the elimination of toxic heavy metals from Lindlar-type catalyst, used commonly in organic chemistry, and their replacement by more benign, organic species adsorbed at defect sites is discussed.

Electroanalytical exploitation of quinone-thiol interactions: application to the selective determination of cysteine.

Square wave voltammetry was applied to the detection of cysteine through the use of an indirect assay that exploits the reaction of the thiol with a quinone indicator. Voltammetric discrimination between unreacted quinone and the corresponding quinone-cysteine adduct is possible with clear resolution of the latter peak providing a linear response from 5 to 47 microM. The selectivity of the approach was assessed with no interference from cystine, lysine, paracetamol or 4-aminophenol. The response recorded in the presence of a massive excess of ascorbic acid was also investigated and the integrity of the approach confirmed. The effects of other sulfhydryl thiols, homocysteine and glutathione, were also assessed and found to present no appreciable change in the voltammetric profile. The practical utility of the approach was investigated through examining the response to cysteine in urine.