Partially loaded plain radiographic measurement to evaluate rotational alignment in total knee arthroplasty.

PURPOSE: Rotational alignment of prosthetic components after total knee arthroplasty (TKA) is predominantly monitored with computer tomography (CT), for example by relating the anatomical transepicondylar axis (a-TEA) of the native femur to the posterior bicondylar axis of the prosthetic component (PBCA). The purpose of the present study was to portray a reliable, novel plain radiographic method that likewise enables the evaluation of rotational positioning of prosthetic components in TKA. Furthermore, it was intended to evaluate the prosthetic femoro-tibial functional behavior under loaded conditions. METHODS: Modified plain axial radiographs under partial weight bearing (20 kg) were performed in 63 patients (63 knees) after TKA. On the obtained radiographs, all established, relevant anatomic, and prosthetic axis and angles reflecting the rotational position of the femoral (i.e., a-TEA/PBCA angle) and tibial component were detected twice by two independent examiners with an interval of one month. Additionally, in 14 cases with anterior knee pain after surgery, radiographic results were compared to obtained computer tomography images; intraclass coefficients (ICC's) for intra- and inter-rater reliability were calculated. RESULTS: All pre-assigned axis and angles could be identified doubtlessly by both examiners in all investigated knees. For all measurements, ICC's for intra-rater and inter-rater reliability ranged from 0.75 to 0.96. The comparison of the radiographic measurements with corresponding CT results (n = 14) revealed no significant differences (p > 0.05). Rotational alignment of the tibial tray in relation to the native tibial bone was not measurable due to display overlaying. Femoro-tibial behaviour of the prosthetic components under partial loading showed a high variability. CONCLUSION: We were able to establish a new reliable radiographic technique that is able to show the most established and relevant anatomic landmarks and prosthetic axis after TKA to assess the rotational alignment of the prosthetic components in TKA in relation to the distal femur. The evaluation of the femoro-tibal behaviour instead shows a high variability and so far does not allow valid explanatory conclusions.

In vivo movement of femoral flexion axis of a single-radius total knee arthroplasty.

The objective of this study was to investigate in vivo femoro-tibial motion using the movement of femoral flexion axis of a single-radius TKA. We examined 20 clinically successful knees with a single-radius posterior stabilized TKA to evaluate the kinematics of deep knee flexion using 2-3-dimensional registration techniques. The mean knee flexion range of motion was 117.8°. The mean rotation of the femoral component was 7.6° external rotation. The mean knee flexion angle at initial post-cam engagement was 55.2°. No paradoxical movement of femoral component was shown until 70° flexion, afterward the femoral component rolled back with flexion. The data showed that the design of this prosthesis might contribute to reduce the paradoxical anterior femoral movement and provide stability in mid-flexion ranges.

Higher rates of fully preserved posterior cruciate ligament in total knee arthroplasty using a double tibial cut: a prospective randomized controlled trial.

PURPOSE: In cruciate retaining total knee arthroplasty, posterior cruciate ligament damage may occur during tibial cutting. A prospective randomized study was conducted to investigate whether a novel tibial cutting technique was more effective than the currently used techniques. MATERIALS AND METHODS: Patients undergoing cruciate retaining total knee arthroplasty were recruited in a prospective, randomized, controlled trial. In 25 patients (group 1) the tibial cut was performed using a double tibial cut technique; in 25 (group 2) and 25 (group 3) patients, the bone island and en bloc resection techniques were performed, respectively. Posterior cruciate ligament integrity and femoral rollback were assessed at the end of surgery. The Oxford Knee Score, WOMAC score and range of motion were assessed postoperatively. RESULTS: Posterior cruciate ligament was completely preserved in 92% of patients in group 1 and in 64% in group 2 and 3, respectively (p = 0.03). The Oxford Knee Score and WOMAC scores did not differ between groups (p = 0.4). The mean knee flexion was 126.4°, 121.5° and 123.9° in groups 1, 2 and 3, respectively (p = 0.04). The femoral rollback at 120° flexion was 80.7%, 72.2% and 75.4% in groups 1, 2 and 3, respectively (p = 0.01). CONCLUSIONS: The double cut technique preserves the posterior cruciate ligament at significantly higher rates than the bone island or en bloc resection techniques. Better posterior cruciate ligament preservation may improve the femoral rollback and knee flexion. LEVEL OF EVIDENCE: Prospective randomized controlled trial, Level I.

Prospective sequential comparison of femoral roll-back between cruciate-retaining and posterior-stabilized total knee arthroplasty using an intra-operative sensor.

BACKGROUND: Implant design and surgical techniques affect postoperative knee kinematics in total knee arthroplasty (TKA). This study aimed to compare femoral roll-back between cruciate-retaining (CR) and posterior-stabilized (PS) TKA in the same knee by objectively quantifying the contact point kinematics of the tibiofemoral joint using a sensor. METHODS: In the present prospective study, we used an intraoperative sensor to compare medial and lateral roll-back during 0-120° knee flexion in 33 knees that underwent CR and PS TKA. We also examined the relationship between mediolateral balance and the lateral-to-medial roll-back ratio. We defined the contact percentage position as the vertical length to the contact point divided by the anteroposterior length of the tibial plate. RESULTS: The roll-back percentage following PS TKA (19.8 ± 5.1%) was significantly higher than that after CR TKA in both the medial (19.8 ± 5.1% versus 7.1 ± 2.5%, P < 0.001) and lateral (26.8% ± 3.8% versus 18.7 ± 3.8%, P < 0.001) compartments. The medial contact pressure at 90° was significantly correlated with the increased lateral-to-medial roll-back ratio in both CR and PS TKA (both P < 0.001). CONCLUSION: PS TKA resulted in a higher percentage of femoral roll-back in the medial and lateral compartments than CR TKA. CR TKA caused a higher lateral-to-medial roll-back ratio compared to PS TKA. To reproduce medial pivot knee motion similar to that of a normal knee, the medial soft tissue needed to be balanced more tightly than the lateral soft tissue during TKA. These findings provide some clinical evidence of TKA design selection and proper mediolateral balancing for successful TKA.

The risk of sacrificing the PCL in cruciate retaining total knee arthroplasty and the relationship to the sagittal inclination of the tibial plateau.

BACKGROUND: In cruciate retaining total knee arthroplasty (TKA), a partial avulsion of PCL may occur when en-bloc tibial osteotomy is performed. We evaluated the effects of a tibial cut performed with different degrees of posterior slope on PCL insertion and whether the results are affected by the sagittal inclination of the patient's tibial plateau. METHODS: We selected 83 MRIs of knees showing mild or no degenerative changes. The effects of a simulated tibial cut performed with a posterior slope of 0°, 3°, 5° and parallel to the patient's tibial plateau inclination on PCL insertion in the proximal tibia were investigated. The results were correlated with the degree of posterior inclination of the tibial plateau. RESULTS: Every angle we used for the tibial cut caused a PCL avulsion greater than 50%. The percentage of PCL avulsion significantly increased with increasing the posterior slope of the tibial cut. Patients with sagittal tibial plateau inclination <5° showed greater PCL avulsion than those with sagittal inclination >8°. CONCLUSIONS: Most of the PCL insertion is likely to be sacrificed when resection of the proximal tibia is performed en-block. The risk of PCL avulsion is reduced in patients showing a marked posterior inclination of the tibial plateau, but even in this group of patients a surgical technique aimed at sparing most of the PCL insertion is necessary.