الملخص
Small animal models are extensively utilized in the study of biomedical sciences. Current animal experiments and analysis are largely restricted to in vitro measurements and need to sacrifice animals to perform tissue or molecular analysis. This prevents researchers from observing in vivo the natural evolution of the process under study. Imaging techniques can provide repeatedly in vivo anatomic and molecular information noninvasively. Small animal imaging systems have been developed to assess biological process in experimental animals and increasingly employed in the field of molecular imaging studies. This review outlines the current developments in nuclear medicine imaging instrumentations including fused multi-modality imaging systems for small animal imaging.
الموضوعات
Animals , Animal Experimentation , Biological Phenomena , Models, Animal , Molecular Imaging , Nuclear Medicine , Tomography, Emission-Computed, Single-Photonالملخص
PURPOSE: The purpose of this study was to develop a small animal PET using dual layer phoswich detector to minimize parallax error that degrades spatial resolution at the outer part of field-of-view (FOV). MATERIALS AND METHODS: A simulation tool GATE (Geant4 Application for Tomographic Emission) was used to derive optimal parameters of small PET, and PET was developed employing the parameters. Lutetium Oxyorthosilicate (LSO) and Lutetium-Yttrium Aluminate-Perovskite (LuYAP) was used to construct dual layer phoswitch crystal. 8 X 8 arrays of LSO and LuYAP pixels, 2 mm X 2 mm X 8 mm in size, were coupled to a 64-channel position sensitive photomultiplier tube. The system consisted of 16 detector modules arranged to one ring configuration (ring inner diameter 10 cm, FOV of 8 cm). The data from phoswich detector modules were fed into an ADC board in the data acquisition and preprocessing PC via sockets, decoder block, FPGA board, and bus board. These were linked to the master PC that stored the events data on hard disk. RESULTS: In a preliminary test of the system, reconstructed images were obtained by using a pair of detectors and sensitivity and spatial resolution were measured. Spatial resolution was 2.3 mm FWHM and sensitivity was 10.9 cps/micro Ci at the center of FOV. CONCLUSION: The radioactivity distribution patterns were accurately represented in sinograms and images obtained by PET with a pair of detectors. These preliminary results indicate that it is promising to develop a high performance small animal PET.
الموضوعات
Animals , Electrons , Lutetium , Positron-Emission Tomography , Radioactivityالملخص
PURPOSE: Since I-125 emits low energy (27-35 keV) radiation, thinner crystal and collimator could be employed and, hence, it is favorable to obtain high quality images. The purpose of this study was to derive the optimized parameters of I-125 SPECT using a new simulation tool, GATE (Geant4 Application for Tomographic Emission). MATERIALS AND METHODS: To validate the simulation method, gamma camera developed by Weisenberger et al. was modeled. NaI (Tl) plate crystal was used and its thickness was determined by calculating detection efficiency. Spatial resolution and sensitivity curves were estimated by changing variable parameters for parallel-hole and pinhole collimator. Performances of I-125 SPECT equipped with the optimal collimator were also estimated. RESULTS: In the validation study, simulations were found to agree well with experimental measurements in spatial resolution (4%) and sensitivity (3%). In order to acquire 98% gamma ray detection efficiency, NaI (Tl) thickness was determined to be 1 mm. Hole diameter (mm), length (mm) and shape were chosen to be 0.2: 5: square and 0.5: 10: hexagonal for high resolution (HR) and general purpose (GP) parallel-hole collimator, respectively. Hole diameter, channel height and acceptance angle of pinhole (PH) collimator were determined to be 0.25 mm, 0.1 mm and 90 degree. The spatial resolutions of reconstructed image of the I-125 SPECT employing HR: GP: PH were 1.2: 1.7: 0.8 mm. The sensitivities of HR: GP: PH were 39.7: 71.9: 5.5 cps/MBq. CONCLUSION: The optimal crystal and collimator parameters for I-125 imaging were derived by simulation using GATE. The results indicate that excellent resolution and sensitivity imaging is feasible using I-125 SPECT.