Distribution of Microbiota in Fine Particulate Matter Particles in Guangzhou, China / 生物医学与环境科学（英文）

Objective@#High PM concentration is the main feature of increasing haze in developing states, but information on its microbial composition remains very limited. This study aimed to determine the composition of microbiota in PM in Guangzhou, a city located in the tropics in China.@*Methods@#In Guangzhou, from March 5 to 10 , 2016, PM was collected in middle volume air samplers for 23 h daily. The 16S rDNA V4 region of the PM sample extracted DNA was investigated using high-throughput sequence.@*Results@#Among the Guangzhou samples, , , , , and were the dominant microbiota accounting for more than 90% of the total microbiota, and was the dominant gram-negative bacteria, accounting for 21.30%-23.57%. We examined the difference in bacterial distribution of PM between Beijing and Guangzhou at the genus level; was found in both studies, but was only detected in Guangzhou.@*Conclusion@#In conclusion, the diversity and specificity of microbial components in Guangzhou PM were studied, which may provide a basis for future pathogenicity research in the tropics.

Effect of different heat treatment on mechanical properties and microstructure of laser welding CoCr-NiCr dissimilar alloys / 中华口腔医学杂志

<p><b>OBJECTIVE</b>To evaluate the effect of heat treatment and porcelain-fused-to-metal (PFM) processing on mechanical properties and microstructure of laser welding CoCr-NiCr dissimilar alloys.</p><p><b>METHODS</b>Samples of CoCr-NiCr dissimilar alloys with 0.5 mm thickness were laser-welded single-side under the setting parameters of 280 V, 10 ms pulse duration. After being welded, samples were randomly assigned to three groups, 10 each. Group1 and 2 received heat treatment and PFM processing, respectively. Group 3 was control group without any treatment. Tensile strength, microstructure and element distribution of samples in the three groups were tested and observed using tensile test, metallographic examinations, scanning electron microscope (SEM), and energy dispersive spectroscopy (EDS) analysis.</p><p><b>RESULTS</b>After heat treatment and PFM processing, tensile strength of the samples were (537.15 +/- 43.91) MPa and (534.58 +/- 48.47) MPa respectively, and elongation rates in Group 1 and 2 were (7.65 +/- 0.73)% and (7.40 +/- 0.45)%. Ductile structure can be found on tensile fracture surface of samples and it was more obvious in heat treatment group than in PFM group. The results of EDS analysis indicated that certain CoCr alloy diffused towards fusion zone and NiCr side after heat treatment and PFM processing. Compared with PFM processing group, the diffusion in the heat treatment group was more obvious.</p><p><b>CONCLUSIONS</b>Heat treatment and PFM processing can improve the mechanical properties and microstructure of welded CoCr-NiCr dissimilar alloy to a certain degree. The improvements are more obvious with heat treatment than with porcelain treatment.</p>