Résumé
Objective:To study the influence of intensive magnet fields on radiation dose measurement, and to demonstrate the feasibility of measuring magnet field correction factor by a combination of medical linac with variable magnet fields in view of needing for accurate measurement of the doses from reference beam arising in MR image-guided radiotherapy.Methods:A photon radiation field and a variable field with 6 MV nominal high voltage were produced by using conventional medical electron linear accelerator equipped with a pair of electromagnets with magnetic field strength up to 1.5 T. Both PTW30013 and PTW31010 ionization chambers were used to test the responses of ionization chambers under different magnetic field strengths at four orientations in which the angles between ionization chamber axis and magnetic field direction were 0°, 180°, 90° and 270°, respectively. The magnetic factors, kB, M was calculated and compared with the reported values in literature. Results:The response of ionization chamber was proportional to the magnetic field strength before it reached to a peak around 1 T, and then fell down as the magnetic field continued to rise. When the magnetic field was 0.35 T, the magnetic factors of PTW31010 were 0.988 2±0.000 3 and 0.997 4±0.000 4 corresponding to 90° and 0° directions, the discrepancy between 0° scenario and literature was 0.05% ± 0.04%. When the magnetic field reached 1.5 T, the magnetic factor of PTW30013 was 0.958 9±0.000 5 at the situation of 90°, which was 0.60% ± 0.05% different from the literature value.Conclusions:Conventional 6 MV medical accelerator equipped with electromagnet can be used to measure the magnetic field factor of reference dosimetry for MRIgRT.
Résumé
Objective To explore the feasibility of application of the Monte Carlo method to simulate the whole body dose distribution in patients with total body X (γ) ray irradiation by comparing the actual measurement results.Methods A Monte Carlo model of a 6 MV Elekta Synergy Clinical linear accelerator was established by MCNPX.According to the relationship between the CT value and the density of the material,the CT of the ATOM physical phantom was converted into a voxel phantom for MCNPX calculation.The dose distribution of the whole body was simulated in the total body X (γ) ray irradiation.The simulated results were compared with the measurement values of the thermoluminescence dosimetry at different positions in the ATOM physical phantom to analyze the differences.Results The difference between the depth dose curve and the off-axis dose curve and the actual measurement values calculated by the 6 MV accelerator treatment head model in the water tank was less than 2%,with the maximum dose depth of approximately 1.5 cm and field size of 10 cm× 10 cm,which were consistent with the actual measurement values.The maximum difference between the simulated results at different locations in the body and the thermoluminescence dosimeter was approximately 4%,and the simulated results of MCNPX were almost in good agreement with the results of thermoluminescence.Conclusions The whole body dose distribution in patient with total body X (γ) ray irradiation can be accurately simulated by MCNPX.Monte Carlo simulation makes it possible to optimize the uniformity of the total body dose during the total body irradiation process.