Реферат
Objective: To evaluate the effects of pre-sintering heating rate and powder size on dental recycled zirconia. Methods: Recycled zirconia powders were sieved to obtain the large (50 μm<particle diameter≤125 μm) and small (particle diameter≤50 μm) particles, these powders were then formed into green bodies. According to the pre-sintering heating rates, the recycled-zirconia green bodies were divided into 3 groups: group A, pre-sintering heating rate of 2 ℃/min; group B, pre-sintering heating rate of 5 ℃/min; group C, pre-sintering heating rate of 8 ℃/min. The relative density open porosity and machinability of the recycled zirconia pre-sintered bodies were evaluated and compared with the commercial zirconia pre-sintered bodies. Zirconia pre-sintered bodies were then fully sintered according to the manufacturer's instructions. The relative density, open porosity, linear shrinkage and flexural strength of fully sintered zirconia were further compared. The microstructure of fracture surfaces and the crystalline structure were analyzed by scanning electron microscope and X-ray diffractometer, respectively. Results: With the same particle size, the recycled zirconia pre-sintered at different heating rates showed no significant differences in the relative densities, and the open porosities (P>0.05). When the pre-sintering heating rates were 2 ℃/min, 5 ℃/min, and 8 ℃/min, the flexural strengths of the large-particle recycled zirconia were (421.2±54.7), (444.2±70.1) and (427.5±68.4) MPa, the flexural strengths of the small-particle recycled zirconia were (750.1±74.1), (777.2±95.5) and (746.7±73.0) MPa, respectively. The flexural strength of commercial zirconia was (988.4±129.8) MPa. The flexural strengths of the recycled zirconia were significantly lower than that of the commercial zirconia (P<0.05). At the same pre-sintering heating rate, the flexural strengths of the small-particle recycled zirconia were significantly higher than that of the large-particle recycled zirconia (P<0.05). Conclusions: Compared with the large particles, small-particle recycled zirconia powders can effectively improve the properties of recycled zirconia, while the pre-sintering heating rate has no effect on the properties of the recycled zirconia.