Your browser doesn't support javascript.
loading
節目: 20 | 50 | 100
结果 1 - 3 de 3
过滤器
添加過濾器








研究类型
年份範圍
1.
文章 在 中文 | WPRIM | ID: wpr-1019829

摘要

Objective The metabolism and excretion of isochlorogenic acid B in rats were investigated by UHPLC-MS.Methods Feces,urine and plasma were individually collected before and at different time points after administration of 20 mg·kg-1.Post-prepared samples were analyzed by UHPLC-MS.Results According to the retention times,m/z,characteristic fragment ions and related literature,a total of 22 metabolites were detected,of which 18 metabolites were present in rat feces,3 metabolites in urine and one metabolite in plasma.The main metabolic pathways contain hydrolysis,hydrogenation,methylation,sulfation and so on.The cumulative excretion of isochlorogenic acid B and its main metabolite chlorogenic acid in feces and urine was further performed.Conclusion The metabolism and excretion of isochlorogenic acid B in rats were explored to provide experimental basis for its further research and development.

2.
文章 在 中文 | WPRIM | ID: wpr-928212

摘要

The body weight support rehabilitation training system has now become an important treatment method for the rehabilitation of lower limb motor dysfunction. In this paper, a pelvic brace body weight support rehabilitation system is proposed, which follows the center of mass height (CoMH) of the human body. It aims to address the problems that the existing pelvic brace body weight support rehabilitation system with constant impedance provides a fixed motion trajectory for the pelvic mechanism during the rehabilitation training and that the patients have low participation in rehabilitation training. The system collectes human lower limb motion information through inertial measurement unit and predicts CoMH through artificial neural network to realize the tracking control of pelvic brace height. The proposed CoMH model was tested through rehabilitation training of hemiplegic patients. The results showed that the range of motion of the hip and knee joints on the affected side of the patient was improved by 25.0% and 31.4%, respectively, and the ratio of swing phase to support phase on the affected side was closer to that of the gait phase on the healthy side, as opposed to the traditional body weight support rehabilitation training model with fixed motion trajectory of pelvic brace. The motion trajectory of the pelvic brace in CoMH mode depends on the current state of the trainer so as to realize the walking training guided by active movement on the healthy side of hemiplegia patients. The strategy of dynamically adjustment of body weight support is more helpful to improve the efficiency of walking rehabilitation training.


Subject(s)
Humans , Biomechanical Phenomena , Gait , Hemiplegia , Pelvis , Range of Motion, Articular , Stroke Rehabilitation , Walking
3.
文章 在 中文 | WPRIM | ID: wpr-888212

摘要

The rotation center of traditional hip disarticulation prosthesis is often placed in the front and lower part of the socket, which is asymmetric with the rotation center of the healthy hip joint, resulting in poor symmetry between the prosthesis movement and the healthy lower limb movement. Besides, most of the prosthesis are passive joints, which need to rely on the amputee's compensatory hip lifting movement to realize the prosthesis movement, and the same walking movement needs to consume 2-3 times of energy compared with normal people. This paper presents a dynamic hip disarticulation prosthesis (HDPs) based on remote center of mechanism (RCM). Using the double parallelogram design method, taking the minimum size of the mechanism as the objective, the genetic algorithm was used to optimize the size, and the rotation center of the prosthesis was symmetrical with the rotation center of the healthy lower limb. By analyzing the relationship between the torque and angle of hip joint in the process of human walking, the control system mirrored the motion parameters of the lower on the healthy side, and used the parallel drive system to provide assistance for the prosthesis. Based on the established virtual prototype simulation platform of solid works and Adams, the motion simulation of hip disarticulation prosthesis was carried out and the change curve was obtained. Through quantitative comparison with healthy lower limb and traditional prosthesis, the scientificity of the design scheme was analyzed. The results show that the design can achieve the desired effect, and the design scheme is feasible.


Subject(s)
Humans , Arthroplasty, Replacement, Hip , Artificial Limbs , Biomechanical Phenomena , Hip Joint , Hip Prosthesis , Prosthesis Design , Range of Motion, Articular , Walking
搜索明细