Simultaneous determination of zearalenone and alternariol mycotoxins in oil samples using mixed molecularly imprinted polymer beads.

This work reports the optimization of a method using Molecularly Imprinted Polymers (MIPs) for the simultaneous determination of zearalenone and alternariol mycotoxins. The method was optimized using a chemometric approach where in the optimized conditions, the cartridges with a mixture (50:50, w/w) of both MIPs, were loaded with 30 mL of sample, washed with 2 mL of ACN/water (20/80, v/v) and eluted with 2.5 mL of trifluoroacetic acid/MeOH (3/97, v/v). The extracts were analyzed by HPLC coupled to a fluorescence detector (FLD). The optimized method has been applied and validated to the analysis of the mycotoxins in maize, sunflower and olive oils samples with a limit of detection of 5 and 2 µg kg-1, respectively. Recoveries were in the range of 94 % to 108 % (RSD < 6 %) for zearalenone and 92 % to 113 % (RSD < 5 %) for alternariol. The results were confirmed by HPLC-MS/MS.

Extracting mycotoxins from edible vegetable oils by using green, ecofriendly deep eutectic solvents.

In this work, we developed an environmentally friendly liquid-liquid microextraction method using a natural deep eutectic solvent in combination with liquid chromatography for the simultaneous determination of four mycotoxins (deoxynivalenol, alternariol, ochratoxin A and zearalenone) in edible vegetable oils. A chemometric approach assessed the effect of the operational parameters on the mycotoxin extraction efficiency. The extracts were analyzed by HPLC coupled with a diode array and fluorescence detector. The optimum NADES composition resulted in the highest extraction recoveries, and it was applied to coextract the target mycotoxins in several types of edible vegetable oils without using hazardous solvents or requiring further clean-up. The limits of detection ranged from 0.07 to 300 µg kg-1, and recoveries were close to 100%, except for zearalenone (viz. 35%), with relative standard deviations below 9% in all cases. The proposed method was validated following the European Commission 2002/657/EC and 2006/401/EC.

Multiresidue determination of ultratrace levels of fluoroquinolone antimicrobials in drinking and aquaculture water samples by automated online molecularly imprinted solid phase extraction and liquid chromatography.

The present work describes the development of a sensitive and highly selective innovative method for the simultaneous detection of six fluoroquinolone (FQ) antimicrobials (enrofloxacin, ciprofloxacin, norfloxacin, levofloxacin, danofloxacin, and sarafloxacin) in water samples. This detection is based on online solid phase extraction, coupled to liquid chromatography (LC), using for the first time tailor-made molecularly imprinted microspherical polymer particles prepared via precipitation polymerization. Various parameters affecting the extraction efficiency of the polymer have been optimized to reduce nonspecific interactions and to achieve selective uptake of the antibiotics from real samples. The method shows good recoveries ranging between 62% and 102% (V = 25 mL) for the different FQs tested and excellent interday and intraday precision with relative standard deviation (RSD) values between 2-5% and 2-6%, respectively. The detection limits were between 1-11 ng L(-1) (drinking water) and 1-12 ng L(-1) (fish farm water) when 25 mL samples were processed. The polymer showed selectivity for FQs containing a piperazine moiety whereas no retention was found for other antibiotics or nonrelated compounds. The method has been applied to the analysis of trace amounts of the FQs tested in drinking and fish farm water samples with excellent recoveries (>91%) and good precision (RSDs <5%).

Mycotoxin extraction from edible insects with natural deep eutectic solvents: a green alternative to conventional methods.

Edible insects are widely consumed in Africa, Asia, Oceania and Latin America, but less commonly so in Western countries. Since the turn of the millennium, however, entomophagy has aroused growing interest worldwide in response to the increasing scarcity of food resources. In fact, edible insects can be a source of high-quality protein, and also of fat, energy, minerals and vitamins. However, the lack of regulatory guidelines for microbiologically or chemically hazardous agents potentially present in these new foods (e.g., mycotoxins) may make their consumption unsafe. In this work, we developed an environmentally friendly analytical method using natural deep eutectic solvents (NADES or natural DES) in combination with ultra-high performance liquid chromatography/tandem mass spectrometry (UHPLC-MS/MS) for the simultaneous determination of six mycotoxins of great concern owing to their toxic effects on humans and animals (namely, fumonisin B1, fumonisin B2, T-2 toxin, HT-2 toxin, ochratoxin A and mycophenolic acid) in insect-based food products. The target mycotoxins were co-extracted from cricket flour by using the optimum DES composition (namely, a mixture of choline chloride and urea, in a 1:2 mole ratio, containing 15% water which resulted in the highest extraction recoveries for all toxins). An experimental design method (Fractional Factorial Design (FFD) was used to examine the influence of the operational variables DES volume and water content, amount of sample, extraction time and extraction temperature on the extraction efficiency for each mycotoxin. Under optimum conditions, extraction recoveries were close to 100% except for fumonisin B2 (70%) and T-2 toxin (50%), with relative standard deviations (RSDs) below 13% in all cases. The proposed NADES-UHPLC-MS/MS method was validated in accordance with the European Commission 2002/657/EC and 2006/401/EC decisions, and used to determine the target compounds in cricket flour, silkworm pupae powder and black cricket powder.

Magnetic microbeads-based amperometric immunoplatform for the rapid and sensitive detection of N6-methyladenosine to assist in metastatic cancer cells discrimination.

This work describes the preparation of an immunoplatform for the sensitive and selective determination of N6-methyladenosine (m6A). The simple and fast protocol involves for the first time the use of micromagnetic immunoconjugates to establish a direct competitive assay between the m6A target and a biotinylated RNA oligomer bearing a single m6A enzymatically labelled with a commercial conjugate of streptavidin-peroxidase (Strep-HRP) as tracer. The cathodic current change measured in the presence of H2O2/hydroquinone (HQ) at screen-printed carbon electrodes (SPCEs) upon surface capturing the magnetic bioconjugates is inversely proportional to the m6A target concentration. After evaluating the effect of key variables, the analytical characteristics were established for the determination of three different targets: the N6-methyladenosine-5'-triphosphate (m6ATP) ribonucleotide, a short synthetic RNA oligomer bearing a single m6A and the positive control provided in a commercial colorimetric kit for m6A-RNA quantification. The obtained results show that this immunoplatform is competitive with other methods reported to date, achieving an improved sensitivity (limit of detection of 0.9 pM for the short synthetic oligomer) using a much simpler and faster protocol (~1 h) and disposable electrodes for the transduction. Furthermore, the applicability for discriminating the metastatic potential of cancer cells by directly analyzing a small amount of raw total RNA without enriching or fragmenting was also preliminary assessed.

Multiplexed magnetic beads-assisted amperometric bioplatforms for global detection of methylations in nucleic acids.

This work reports the first electrochemical bioplatform developed for the multidetection of 5-methylcytosine (5-mC) and 5-hydroxymethylcytosine (5-hmC) in DNA, DNA N6-methyladenine (6mA) and RNA N6-methyladenosine (m6A) methylations at global level. Direct competitive immunoassays were implemented on the surface of magnetic beads (MBs) and optimized for the single amperometric determination of different targets varying in length, sequence and number of methylations on screen-printed carbon electrodes. After evaluating the sensitivity and selectivity of such determinations and the confirmation of no cross-reactivity, a multiplexed disposable platform allowing the simultaneous determination of the mentioned four methylation events in only 45 min has been prepared. The multiplexed bioplatform was successfully applied to the determination of m6A in cellular total RNA and of 5-mC, 5-hmC and 6mA in genomic DNA extracted from tissues. The developed bioplatform showed its usefulness to discriminate the aggressiveness of cancerous cells and between healthy and tumor tissues of colorectal cancer patients.

Accelerated development procedure for molecularly imprinted polymers using membrane filterplates.

A novel technique for the synthesis and testing of large numbers of molecularly imprinted polymers is described requiring much less time than the commonly used miniMIP approach. Instead of vials, the polymers are synthesized on the surface of microfiltration membranes in multiwell filterplates. The thin polymeric films enable accelerated template removal. The MIP development procedure is thereby shortened to two days. Performance of the system was demonstrated by creating a combinatorial library of MIPs selective for cimetidine, an antiulcer drug. The polymer composition has been optimized. An experimental design combined with a multivariate analysis (i.e., response surface modeling) was used to minimize the number of experiments in the optimization process. The highest imprinting factor was obtained using a MAA/EDMA/template molar ratio of 3.5:19.5:1.

Versatile Electroanalytical Bioplatforms for Simultaneous Determination of Cancer-Related DNA 5-Methyl- and 5-Hydroxymethyl-Cytosines at Global and Gene-Specific Levels in Human Serum and Tissues.

This paper reports the preparation of versatile electrochemical biosensing platforms for the simple, rapid, and PCR-independent detection of the most frequent DNA methylation marks (5-methylcytosine, 5-mC, and/or 5-hydroxymethylcytosine, 5-hmC) both at global and gene-specific levels. The implemented strategies, relying on the smart coupling of immuno-magnetic beads (MBs), specific DNA probes and amperometric detection at screen-printed carbon electrodes (SPCEs), provided sensitive and selective determination of the target methylated DNAs in less than 90 min with a great reproducibility and demonstrated feasibility for the simultaneous detection of the same or different cytosine epimarks both at global level and in different loci of the same gene or in different genes. The bioplatforms were applied to determine global methylation events in paraffin-embedded colorectal tissues and specific methylation at promoters of tumor suppressor genes in genomic DNA extracted from cancer cells and paraffin-embedded colorectal tissues, and in serum without previous DNA extraction from cancer patients.

Influence of initiator and different polymerisation conditions on performance of molecularly imprinted polymers.

A set of polymers was imprinted with (-)-ephedrine using two different initiators. A chemometrics approach was used to optimise experiments aimed at analysis of the interplay of parameters such as polymerisation time, temperature and percentage of initiator. The results presented demonstrate the importance of keeping the right balance between these various parameters of polymerisation conditions. It is shown that enhancing one single parameter such as polymer rigidity does not necessarily improve polymer performance. In general it could be concluded that MIPs should be synthesised over a long period of time using low concentration of initiator and low temperature. The best selectivity was achieved for polymers prepared by photo-initiation with 2,2-dimethoxy-2-phenylacetophenone as initiator.

Experimental mixture design as a tool for the synthesis of antimicrobial selective molecularly imprinted monodisperse microbeads.

The effect of the cross-linker on the shape and size of molecular imprinted polymer (MIP) beads prepared by precipitation polymerization has been evaluated using a chemometric approach. Molecularly imprinted microspheres for the selective recognition of fluoroquinolone antimicrobials were prepared in a one-step precipitation polymerization procedure using enrofloxacin (ENR) as the template molecule, methacrylic acid as functional monomer, 2-hydroxyethyl methacrylate as hydrophilic comonomer, and acetonitrile as the porogen. The type and amount of cross-linker, namely ethylene glycol dimethacrylate, divinylbenzene or trimethylolpropane trimethacrylate, to obtain monodispersed MIP spherical beads in the micrometer range was optimized using a simplex lattice design. Particle size and morphology were assessed by scanning electron microscopy, dynamic light scattering, and nitrogen adsorption measurements. Electron paramagnetic resonance spectroscopy in conjunction with a nitroxide as spin probe revealed information about the microviscosity and polarity of the binding sites in imprinted and nonimprinted polymer beads.

Continuous solid-phase extraction and preconcentration of bisphenol A in aqueous samples using molecularly imprinted columns.

A bisphenol A (BPA) molecularly imprinted polymer, the composition of which was optimised using a chemometric approach, has been applied to the selective preconcentration of the template from aqueous samples. The selectivity of the polymer toward BPA and related compounds was evaluated chromatographically. The BPA-imprinted polymer was packed in a column and used for continuous on-column solid-phase extraction (MISPE) of aqueous samples followed by subsequent analysis by HPLC with fluorescence detection of the eluted fractions. The composition of the washing solvent applied in the MISPE procedure was optimised to favour the specific interactions of the MIP with BPA and to remove the non-selectively bound matrix components. The MISPE method has proven to be effective for selective preconcentration of BPA in aqueous samples (recoveries >84% obtained in the eluate for 10-100 mL sample volumes) enabling detection and quantification limits of 1.0 and 3.3 ng mL(-1), respectively (based on 25 mL sample size). Analytical recoveries were between 92 and 101% for river water samples spiked with known amounts of BPA (30, 60, and 80 ng mL(-1)); relative standard deviations (RSD) were lower than 5.0%.