ABSTRACT
The nutraceutical value, and physicochemical profile as well as anti-inflammatory activity potential of Odonthalia floccose and Odonthalia dentata (red macroalgae) dry biomass were investigated in this study. Proximate composition study results revealed that the dry biomass of O. floccose and O. dentae were found to be as ash: 9.11 & 8.7 g 100 g-1, moisture: 8.24 & 8.1 g 100 g-1, total fat: 6.9 & 7.2 g 100 g-1, protein: 24.52 & 25.6 g 100 g-1, and total carbohydrate/polysaccharides: 53.84 & 48.85 g 100 g-1 of dry weight biomass respectively. Both algae biomass contain considerable quantity of minerals (Fe, Cu, Mg, and Zn). Furthermore, the major saturated fatty acids (6.24 & 5.82 g FAME 100 g-1 of total fat of O. floccose and O. dentate) (ΣFAs) present in the test algae were stearic acid, palmitic acid, and margaric acids. O. floccose and O. dentata also contain remarkable protein composition profile that compiled with considerable quantity of essential and non-essential amino acids. The vitamins such as vitamin A, B1, B2, B3, B6, B9, C, and E of O. floccose and O. dentate biomass were also identified at sufficient quantity level. The swelling capacity (SWC), water holding capacity (WHC), and oil holding capacity (OHC) properties of O. floccose and O. dentate at various temperature conditions (25 and 37 áµC) were found to be 8.11 & 7.02 mL g-1 and 8.95 & 7.55 mL g-1, 5.1 & 4.87 and 4.8 & 4.1 mL g-1, as well as 2.11 & 1.81 and 1.96 & 1.89 mL g-1 respectively. Among these two marine red macroalgae samples, the O. dentate showed better anti-inflammatory activity than O. floccose at 150 µg mL-1 dosage. Thus, this O. floccose and O. dentate biomass can be considerable as nutritional supplement and pharmaceutical product development related research.
ABSTRACT
Nannochloropsis microalgae biochar has become increasingly attractive due to its potential as a component of microalgae-based biodiesel blends. This biochar is a by-product of the pyrolysis process, but its use in the energy sector has been limited. In this study, pellets were formed using microalgae residues and their physiochemical properties were analyzed to assess the feasibility of using microalgae biochar as a fuel source. Three types of biomasses, namely date seed dust, coconut shell waste, and microalgae biochar, were utilized to produce fuel pellets. These pellets were categorized into three types, B1, B2, and B3, based on the composition of the biomass. The inclusion of microalgae biochar in the pellets resulted in enhanced calorific value, as well as improved heating value and bulk density. Moreover, the mechanical strength of microalgae-based pellets was higher due to their high lignin content compared to another biomass. The moisture absorption test results showed that the use of mixed biomass reduced the moisture content over an extended period. Microalgae pellets exhibited higher young's modulus and greater impact resistance, indicating greater mechanical strength. Furthermore, due to their higher calorific value, the combustion time of microalgae pellets was greater than that of other biomass. In conclusion, the results of this study suggest that microalgae biochar can be a promising alternative fuel source for the energy sector.