A streamlined controlled-expansion covered tapered stent for TIPS in the treatment of PHT.

Transjugular intrahepatic portosystemic shunt (TIPS) relieves cirrhotic complications by reducing portacaval pressure gradient (PCG), but it lacks precision in achieving a targeted post-TIPS PCG simply through diameter adjustment of equal diameter stents. This study aimed to present a controlled-expansion, streamlined, and covered tapered stent, and examined its effects on pressure reduction compared with equal- diameter stents. Twenty-four patients who underwent standardized 8-mm stent TIPS implantation at West China Hospital from December 2017 to February 2021 were included in the current study. Virtual equal-diameter stent graft with different diameter and streamlined tapered stents were created in the post-TIPS 3-dimentional models reconstructed based on computed tomography angiography data. The numerical simulation showed that only two patients achieved targeted post-TIPS PCG consistent with the clinical invasive measurement. When 6-mm and 10-mm equal-diameter stents were employed, simulated post-TIPS PCGs for most patients remained outside the safe range, and recirculating flow was observed at the stent-portal vein anastomosis. In contrast, the use of the new streamlined taper stent resulted in post-TIPS PCGs within the 10-12 mmHg range for 17 out of 24 patients, with no recirculating flow observed at the anastomotic sites. In conclusion, the streamlined tapered stent could pose an effective solution to the problem that the big jump depressurization between two different equal-diameter stents and it would improve the hemodynamics in the region near the PV-stent anchorage. Therefore, the streamlined tapered stent may present a superior alternative for TIPS procedure.

A new computational fluid dynamics based noninvasive assessment of portacaval pressure gradient.

Accurate assessment of portacaval pressure gradient (PCG) in patients with portal hypertension (PH) is of great significance both for diagnosis and treatment. This study aims to develop a noninvasive method for assessing PCG in PH patients and evaluate its accuracy and effectiveness. This study recruited 37 PH patients treated with transjugular intrahepatic portosystemic shunt (TIPS). computed tomography angiography was used to create three dimension (3D) models of each patient before and after TIPS. Doppler ultrasound examinations were conducted to obtain the patient's portal vein flow (or splenic vein and superior mesenteric vein). Using computational fluid dynamics (CFD) simulation, the patient's pre-TIPS and post-TIPS PCG was determined by the 3D models and ultrasound measurements. The accuracy of these noninvasive results was then compared to clinical invasive measurements. The results showed a strong linear correlation between the PCG simulated by CFD and the clinical invasive measurements both before and after TIPS (R2 = 0.998, P < 0.001 and R2 = 0.959, P < 0.001). The evaluation accuracy of this noninvasive method reached 94 %, and the influence of ultrasound result errors on the numerical accuracy was found to be marginal if the error was less than 20 %. Furthermore, the information about the hemodynamic environment in the portal system was obtained by this numerical method. Spiral flow patterns were observed in the portal vein of some patients. In a conclusion, this study proposes a noninvasive numerical method for assessing PCG in PH patients before and after TIPS. This method can assist doctors in accurately diagnosing patients and selecting appropriate treatment plans. Additionally, it can be used to further investigate potential biomechanical causes of complications related to TIPS in the future.

The effect of splenic vein diameter on the diagnosis of portal vein thrombosis.

BACKGROUND: It was still controversial that whether the increase of splenic vein (SV) diameter increased the risk of portal vein thrombosis (PVT), which was a severe disease with high mortality, in the clinic. PURPOSES: This study, using computational fluid dynamics method, aimed to investigate how the increase of SV diameter affects the portal vein hemodynamics under different anatomical and geometric features of the portal venous system, thus how it induced to PVT. METHODS: The ideal models of the portal system, including different anatomical structures according to the location of left gastric vein (LGV) and inferior mesenteric vein (IMV), and different geometric morphological parameters models were established to carry out numerical simulation in this study. In addition, the morphological parameters of real patients were measured to verify the numerical simulation results. RESULTS: First, the wall shear stress (WSS) and helicity intensity, which were closely related to the occurrence of thrombosis, gradually decreased with the increase of SV diameter in all models. However, the degree of decrease was bigger in following models: (1) the models with LGV and IMV linking to SV compared with them linking to PV; (2) the models with big angle of PV and SV compared with small angle. In addition, the morbidity of PVT was higher when LGV and IMV linked to SV rather than them linked to PV in the real patients. Moreover, the angle of PV and SV was also different between PVT and non-PVT patients (125.53° ± 16.90° vs. 115.03° ± 16.10°, p = 0.01). CONCLUSION: Whether the increase of SV diameter will result in PVT is depended on the anatomical structure of portal system and the angle between PV and SV, this is also the reason leading to the clinical controversy that the increase of SV diameter is the risk factor of PVT.

A novel potential mechanism for the development of portal vein thrombosis in cirrhosis based on portal hemodynamics.

BACKGROUND: Marked changes in hemodynamics have been suggested to be a potential contributing factor to portal vein thrombosis (PVT) development. This study investigated the effect of portal hemodynamics based on the anatomical structure of the portal venous system on PVT development. METHODS: The morphological features of portal venous system in patients with PVT and those without PVT subgroups were compared. In addition, idealized PV models were established to numerically evaluate the effect of the variation in the angulation of superior mesenteric vein (SMV) and splenic vein (SV) on the hemodynamics of portal venous system. RESULTS: The angle α (angulation of SMV and SV) in patients with PVT was lower than that in patients without PVT (p < 0.0001), which was the only independent risk factor (odds ratio (OR), 0.90 (95% CI 0.84-0.95); p < 0.0001) for the presence of PVT. With the change in angle α, the flow pattern of blood flow changed greatly, especially the helical flow. When α = 80°, helical flow only appeared at the local PV near the intersection of SMV and SV. When α = 120°, most regions were occupied by the helical flow. In addition, the h2 gradually increased with increasing α, when α = 80°, h2 = 12.6 m/s2; when α = 120°, h2 = 29.3 m/s2. CONCLUSIONS: The angulation of SV and SMV was closely associated with PVT development. Helical flow changed following the varying angulation of SV and SMV. Therefore, angulation of SV and SMV may help to identify high-risk cohorts for future PVT development earlier.

Influence of renal artery stenosis morphology on hemodynamics.

OBJECTIVE: Currently, the clinical classification of the severity of renal artery stenosis (RAS) solely depends on the degree of stenosis. In addition, when the stenosis degree is between 50% and 70%, the clinical strategy is decided based on whether the RAS is hemodynamically significant. In this study, the influence of RAS morphological parameters on hemodynamics was numerically analyzed to provide a theoretical basis for clinical treatment. METHODS: Idealized RAS models were established to investigate the hemodynamic effects of the stenosis length, asymmetric stenosis, and direction of the opening of the renal artery. RESULTS: The longer the stenosis length, the greater is the ratio of the low time-averaged wall shear stress (WSS) and high oscillatory shear index (OSI) area distal stenosis (when the stenosis area is the same). In addition, asymmetric stenosis leads to a significant increase in the ratio of the renal artery peak systolic velocity (R-PSV) and the abdominal aorta peak systolic velocity (A-PSV) when the stenosis area is 60-70%. Furthermore, the fraction flow reserve (FFR) of the RAS model with 12 mm stenosis length, upward eccentricity and upward direction of renal artery opening was approximately equal to the cumulative value of the influence of different stenosis morphologies on FFR. CONCLUSION: An assessment of the severity of RAS should consider the stenosis area and other morphological parameters, including the length and asymmetry of RAS as well as the direction of the opening of renal artery, particularly when the stenosis degree of RAS is between 50% and 70%.

A computational fluid dynamics analysis of a patient with acute non-A-non-B aortic dissection after type I hybrid arch repair.

The clinical presentation and natural courses in acute non-A-non-B aortic dissection (AD) are quite different from classical acute type A or type B AD, and the benefit of hybrid technique for this clinical scenario has not been validated. By using computational fluid dynamics (CFD) analysis, we aim to investigate a series of hemodynamic-related changes in aortic morphology in a patient who underwent type I hybrid arch repair (HAR). Computed tomographic angiographies (preoperative, one week, one month and one year after HAR) of a 52-year old male patient with arch-entry type acute non-A-non-B dissection were collected. Three-dimensional models were reconstructed by using an image processing package Mimics (materialize). Morphological and hemodynamic parameters of aorta and its branch vessels were analysed. Post-operatively, the false lumen index (FLI) gradually decreased from 2.02 to 0.38 and the curvature of the aortic arch was also reduced. However, the aortic arch lengthened and the diameter of the distal abdominal aorta expanded. In addition, the blood flow gradually became organised and the pressure in the true lumen (TL) increased over time and eventually approximated the pressure in the false lumen (FL). Moreover, the region of the abnormal wall shear stress (WSS) in the TL progressively decreased while the WSS in most areas of the FL remained below 4 dyne/cm2. The blood supply to most of the aortic branches returned to normal at the one-year follow-up. Type I HAR is an effective procedure for patients with acute non-A-non-B aortic dissection in terms of restoring normal blood flow in TL and facilitating positive remodeling of distal aorta. Long-term surveillance and follow-up is mandatory.

Longitudinal computational fluid dynamics study of stenosis and aneurysmal degeneration of an aortorenal bypass.

Saphenous vein graft (SVG) bypass placement is regarded as the optimal option for renal artery stenosis, which usually causes secondary hypertension and poor renal perfusion. Using computational fluid dynamics, this study aimed to investigate the underlying hemodynamic mechanism of the vein aneurysm and stenosis after aortorenal bypass surgery. Three-dimensional models were reconstructed based on computed tomographic angiography images of a 20-year-old female patient who suffered from uncontrollable hypertension using the image processing package Mimics (Materialise). The morphology and hemodynamic parameters in the healthy state, at initial presentation and at post-operative 9-month and 2-year follow-ups after surgery were analysed. The hemodynamic parameters became normal in the left and right renal arteries after bypass surgery. However, flow separation and stagnation occurred at the post-operative 9-month aorta-vein anastomosis, which caused asymmetrical flow and extremely high wall shear stress (WSS) and WSS gradients at the outflow vein tract, where the stenosis occurred 2 years later. In addition, the graft bending produced an asymmetrical flow pattern downstream. This research revealed that the abnormal hemodynamics, including flow separation and extremely high WSS values and gradients, caused by the retrograde flow of aortorenal bypass may be responsible for the SVG degeneration. In addition, flow asymmetry due to vessel bending is a potential risk factor for SVG aneurysm dilation.