Ten-year hip fracture incidence rate trends in a large California population, 1997-2006.

UNLABELLED: Hip fractures are a large public health problem with significant negative impact on an individual's overall health and survival. But while the total numbers of persons affected by hip fractures may be anticipated to increase, incidence rates appear to be declining. INTRODUCTION: To describe annual hip fracture incidence rate trends in an integrated health-care organization over 1997-2006, during which a proactive bone health program was initiated program-wide and other secular trends occurred in the population. METHODS: For this ecologic trend study, we identified all men and women ≥45 years old as of January 1 of each year. Incident fractures for each year were identified using ICD-9 diagnosis codes 820-820.9, excluding all subjects who had fractures in prior years. Annual person-time at risk for hip fracture was determined from enrollment data. Sex- and age-specific and adjusted annual incidence rates were calculated. RESULTS: The overall annual hip fracture incidence rate for men declined from 1.52/1,000 person-years in 1997 to 1.29/1,000 person-years in 2006, a 15.3% (95% confidence interval [CI]=6.2-24.5) decrease. For women, incidence declined from 2.65/1,000 person-years in 1997 to 2.24/1,000 person-years in 2006, a 15.3% (95% CI=8.7-21.9) decrease. Among subjects aged 85 years or older, incidence rates for men declined from 27.0/1,000 to 18.9/1,000 person-years, and for women they declined from 32.7/1,000 to 27.1/1,000 person-years. CONCLUSION: Hip fracture incidence has been declining in all age groups over the past 10 years. While many factors may contribute to this decline, the results are consistent with a potential benefit of the active bone health intervention.

Reconstruction of the anterior cruciate ligament: association of graft choice with increased risk of early revision.

We examined the association of graft type with the risk of early revision of primary anterior cruciate ligament reconstruction (ACLR) in a community-based sample. A retrospective analysis of a cohort of 9817 ACLRs recorded in an ACLR Registry was performed. Patients were included if they underwent primary ACLR with bone-patellar tendon-bone autograft, hamstring tendon autograft or allograft tissue. Aseptic failure was the main endpoint of the study. After adjusting for age, gender, ethnicity, and body mass index, allografts had a 3.02 times (95% confidence interval (CI) 1.93 to 4.72) higher risk of aseptic revision than bone-patellar tendon-bone autografts (p < 0.001). Hamstring tendon autografts had a 1.82 times (95% CI 1.10 to 3.00) higher risk of revision compared with bone-patellar tendon-bone autografts (p = 0.019). For each year increase in age, the risk of revision decreased by 7% (95% CI 5 to 9). In gender-specific analyses a 2.26 times (95% CI 1.15 to 4.44) increased risk of hamstring tendon autograft revision in females was observed compared with bone-patellar tendon-bone autograft. We conclude that allograft tissue, hamstring tendon autografts, and younger age may all increase the risk of early revision surgery after ACLR.

Electromagnetic metal localization for removal of retained hardware in children.

Retained hardware embedded deep in soft tissues or overgrown with bone poses a challenge to the surgeon assigned to its removal. A prototype of a hand-held electromagnetic metal detector-locater was used to localize retained hardware. Stainless-steel pins, screws, plates, and staples were located in 21 consecutive hardware removal procedures in 19 pediatric patients. Time to find the hardware, length of incision, blood loss, tissue maceration, and operative time were minimized. This preliminary study suggests that a metal locater may be a valuable tool when retained hardware is not palpable or readily apparent.

Catastrophic wear of tibial polyethylene inserts.

A number of factors play an important role in the wear-resistance of tibial polyethylene inserts. Among these are manufacturing processes that adversely affect the wear-resistance of polyethylene (such as heat treatments to the articular surface or gamma irradiation used for sterilization), tibio-femoral articular geometry, polyethylene thickness, knee alignment, femoral-component-bearing surface material, modularity of the tibial inserts and tibial trays, and quality of the polyethylene itself. The authors report an unusually high rate of failure by wear of tibial polyethylene inserts from a series of 176 Porous Coated Anatomic (PCA) knees in which there were eight revisions (4.5% of the series) performed for tibial polyethylene wear at an average of 60 months. Nine additional knees (5.1%) had thinning of greater than 30% of the initial polyethylene thickness. Four of the unsuccessful knees revealed areas of osteolysis filled with membranes containing large amounts of particulate polyethylene. In addition to the 176 knees from a series from a Los Angeles university, the cases of five other knees in four patients who came for treatment from outside hospitals with full-thickness wear of the tibial polyethylene are discussed. One of these five knees was a cementless PCA knee that developed massive osteolysis in response to the particulate polyethylene debris.