In situ laboratory for plastic degradation in the Red Sea.

Degradation and fragmentation of plastics in the environment are still poorly understood. This is partly caused by the lack of long-term studies and methods that determine weathering duration. We here present a novel study object that preserves information on plastic age: microplastic (MP) resin pellets from the wreck of the SS Hamada, a ship that foundered twenty-nine years ago at the coast of Wadi el Gemal national park, Egypt. Its sinking date enabled us to precisely determine how long MP rested in the wreck and a nearby beach, on which part of the load was washed off. Pellets from both sampling sites were analyzed by microscopy, X-ray tomography, spectroscopy, calorimetry, gel permeation chromatography, and rheology. Most pellets were made of low-density polyethylene, but a minor proportion also consisted of high-density polyethylene. MP from inside the wreck showed no signs of degradation compared to pristine reference samples. Contrary, beached plastics exhibited changes on all structural levels, which sometimes caused fragmentation. These findings provide further evidence that plastic degradation under saltwater conditions is comparatively slow, whereas UV radiation and high temperatures on beaches are major drivers of that process. Future long-term studies should focus on underlying mechanisms and timescales of plastic degradation.

Effect of sample treatment on biomechanical properties of insect cuticle.

Experimental limitations often prevent to perform biomechanical measurements on fresh arthropod cuticle samples. Hence, in many cases short- or long-term storage of samples is required. So far, it is not known whether any of the standard lab-techniques commonly used to fix or store insect cuticle samples in any way affects the biomechanical properties of the respective samples. In this paper we systematically address this question for the first time, with a focus on practical, easily accessible and common lab-methods including storage in water, ethanol, glutaraldehyde, freezing and desiccation. We performed a comprehensive and sensitive non-destructive Dynamic Mechanical Analysis (DMA) on locust hind leg tibiae using a three-point-bending setup. Our results show that from all tested treatments, freezing samples at -20 °C was the best option to maintain the original values for Young's modulus and damping properties of insect cuticle. In addition, our results indicate that the damping properties of locust hind legs might be mechanically optimized in respect to the jumping and kicking direction.

Time resolved quantitative imaging of charring in materials at temperatures above 1000 K.

A device is presented allowing for in situ investigation of chemically changing materials by means of X-ray imaging. A representative cork ablator sample, additionally instrumented with thermocouples, is encapsulated in an evacuated cell heating a sample surface with a heat flux of 230 kW/m(2). The images show the sample surface and the in-depth progression of the char front dividing the char layer from the virgin material. Correlating the images to thermocouple data allows for the deduction of a reaction temperature. For the representative cork ablator investigated at the present conditions, the progression rate of the pyrolysis layer is determined to 0.0285 mm/s and pyrolysis temperature is 770 or 737 K, depending on the pre-existing conditions. It is found that the novel device is ideally suited for volume process imaging.