Tip-of-the-Iceberg Fractures: Small Fractures That Mean Big Trouble.

OBJECTIVE: Several small and seemingly unimportant fractures are associated with other more serious injuries, usually to adjacent soft tissues. The purpose of this article is to discuss 11 of these injuries, in each case describing the fracture (the tip) and the injuries that lie beneath the surface (the iceberg). CONCLUSION: Some fractures should be considered analogous to the tip of an iceberg. Their recognition is important because the commonly associated injuries, which are often more serious than the fracture itself, are typically not evident on radiographs and require advanced imaging for accurate diagnosis and treatment.

Comparison of Simulated Low-Dose and Conventional-Dose CT for Preoperative Planning in Shoulder Arthroplasty.

BACKGROUND: Shoulder computed tomography (CT) is commonly utilized in preoperative planning for total shoulder arthroplasty. Conventional-dose shoulder CT may expose patients to more ionizing radiation than is necessary to provide high-quality images for this procedure. The purpose of this study was to evaluate the utility of simulated low-dose CT images for preoperative planning using manual measurements and common preoperative planning software. METHODS: Eighteen shoulder CT scans obtained for preoperative arthroplasty planning were used to generate CT images as if they had been acquired at reduced radiation dose (RD) levels of 75%, 50%, and 25% using a simulation technique that mimics decreased x-ray tube current. This technique was validated by quantitative comparison of simulated low-dose scans of a cadaver with actual low-dose scans. Glenoid version, glenoid inclination, and humeral head subluxation were measured using 2 commercially available software platforms and were also measured manually by 3 physicians. These measurements were then analyzed for agreement across RD levels for each patient. Tolerances of 5° of glenoid version, 5° of glenoid inclination, and 10% humeral head subluxation were used as equivalent for preoperative planning purposes. RESULTS: At all RD levels evaluated, the preoperative planning software successfully segmented the CT images. Semiautomated software measurement of 25% RD images was within tolerances in 99.1% of measurements; for 50% RD images, within tolerances in 96.3% of measurements; and for 75% RD images, within tolerances in 100% of measurements. Manual measurements of 25% RD images were within these tolerances in 95.1% of measurements; for 50% RD images, in 98.8% of measurements; and for 75% RD images, in 99.4% of measurements. CONCLUSIONS: Simulated low-dose CT images were sufficient for reliable measurement of glenoid version, glenoid inclination, and humeral head subluxation by preoperative planning software as well as by physician-observers. These findings suggest the potential for substantial reduction in RD in preoperative shoulder CT scans without compromising surgical planning. CLINICAL RELEVANCE: The adoption of low-dose techniques in preoperative shoulder CT may lower radiation exposure for patients undergoing shoulder arthroplasty, without compromising image quality.

Prospective Multireader Evaluation of Photon-counting CT for Multiple Myeloma Screening.

Purpose To determine whether photon-counting CT (PCCT) acquisition of whole-body CT images provides similar quantitative image quality and reader satisfaction for multiple myeloma screening at lower radiation doses than does standard energy-integrating detector (EID) CT. Materials and Methods Patients with monoclonal gammopathy of undetermined significance prospectively underwent clinical noncontrast whole-body CT with EID and same-day PCCT (August-December 2021). Five axial scan locations were evaluated by seven radiologists, with 11% (eight of 70) of images including osteolytic lesions. Images were shown in randomized order, and each reader rated the following: discernibility of the osseous cortex and osseous trabeculae, perceived image noise level, and diagnostic confidence. Presence of lytic osseous lesions was indicated. Contrast-to-noise ratio (CNR) and signal-to-noise ratio (SNR) were calculated. Comparisons were made using paired t tests and mixed linear effects models. Results Seven participants (four women) were included (mean age, 66 years ± 9 [SD]; body mass index, 30.1 kg/m2 ± 5.2). Mean cortical definition, trabecular definition, image noise, and image quality scores were 83, 67, 75, and 78 versus 84, 66, 74, and 76 for EID and PCCT, respectively (P = .65, .11, .26, and .11, respectively). PCCT helped identify more lesions (79% [22 of 28]) than did EID (64% [18 of 28]). CNRs and SNRs were similar between modalities. PCCT had lower radiation doses than EID (volume CT dose index: EID, 11.37 ± 2.8 vs PCCT, 1.8 ± 0.6 [P = .06]; dose-length product: EID, 1654.1 ± 409.6 vs PCCT, 253.4 ± 89.6 [P = .05]). Conclusion This pilot investigation suggests that PCCT affords similar quantitative and qualitative scores as EID at significantly lower radiation doses. Keywords: CT, CT-Spectral, Skeletal-Axial, Spine, Hematologic Diseases, Whole-Body Imaging, Comparative Studies Supplemental material is available for this article. © RSNA, 2022.

Imaging of Patellofemoral Instability.

Patellar instability is a broad term that encompasses patellar dislocation, patellar subluxation, and patellar instability. Although both functional and anatomic considerations contribute to symptoms of patellar instability, the most important are thought to be patella alta, trochlear dysplasia, and lateralization of the tibial tubercle. In patients with a history suspicious for prior patellar dislocation, careful evaluation of MRI and radiographic studies can reveal characteristic findings. The most common methods to address patellofemoral instability are medial patellofemoral ligament reconstruction and tibial tubercle osteotomy with either anteromedialization or medialization. Less commonly trochleoplasty is indicated as well. Patients may be treated with one of or a combination of these techniques, each of which has specific indications and complications.

MR Imaging of the Rotator Cuff.

The cause of rotator cuff tears is multifactorial with both intrinsic and extrinsic contributing factors. Understanding the normal MR anatomy of the rotator cuff and using an appropriate search pattern can help readers identify common pathologic conditions. Accurate designation using classification systems for tear thickness, size, and degree of retraction and muscle fatty infiltration and atrophy are important in guiding surgical management. Knowledge of common disease locations for the rotator cuff tendons can help focus reader searches and increase sensitivity.

Upper extremity exertional rhabdomyolysis: MR imaging findings in four cases.

While uncommon, exertional-induced rhabdomyolysis is an important diagnostic consideration when encountering hyperintensity within one or more muscles on fluid sensitive sequences in conjunction with signal abnormality in the overlying superficial fascia and subcutaneous fat. The clinical history of recent extreme exercise helps distinguish this disorder from other possible diagnoses, such as cellulitis, necrotizing fasciitis, compartment syndrome, inflammatory processes and diabetic myonecrosis. Patients diagnosed with severe exertional induced rhabdomyolysis often require hospital admission for intravenous hydration and serial laboratory monitoring due to the potential risk of acute renal failure. While contributory, magnetic resonance imaging findings can be nonspecific, and therefore the clinical history is often essential in making this diagnosis.

Intact flagellar motor of Borrelia burgdorferi revealed by cryo-electron tomography: evidence for stator ring curvature and rotor/C-ring assembly flexion.

The bacterial flagellar motor is a remarkable nanomachine that provides motility through flagellar rotation. Prior structural studies have revealed the stunning complexity of the purified rotor and C-ring assemblies from flagellar motors. In this study, we used high-throughput cryo-electron tomography and image analysis of intact Borrelia burgdorferi to produce a three-dimensional (3-D) model of the in situ flagellar motor without imposing rotational symmetry. Structural details of B. burgdorferi, including a layer of outer surface proteins, were clearly visible in the resulting 3-D reconstructions. By averaging the 3-D images of approximately 1,280 flagellar motors, a approximately 3.5-nm-resolution model of the stator and rotor structures was obtained. flgI transposon mutants lacked a torus-shaped structure attached to the flagellar rod, establishing the structural location of the spirochetal P ring. Treatment of intact organisms with the nonionic detergent NP-40 resulted in dissolution of the outermost portion of the motor structure and the C ring, providing insight into the in situ arrangement of the stator and rotor structures. Structural elements associated with the stator followed the curvature of the cytoplasmic membrane. The rotor and the C ring also exhibited angular flexion, resulting in a slight narrowing of both structures in the direction perpendicular to the cell axis. These results indicate an inherent flexibility in the rotor-stator interaction. The FliG switching and energizing component likely provides much of the flexibility needed to maintain the interaction between the curved stator and the relatively symmetrical rotor/C-ring assembly during flagellar rotation.

Extraction and analysis of sterols in biological matrices by high performance liquid chromatography electrospray ionization mass spectrometry.

We describe the development of a high performance liquid chromatography mass spectrometry (HPLC-MS) method that allows the identification and quantitation of sterols in mammalian cells and tissues. Bulk lipids are extracted from biological samples by a modified Bligh/Dyer procedure in the presence of eight deuterated sterol standards to allow subsequent quantitation and determination of extraction efficiency. Sterols and other lipids are resolved by HPLC on a reverse-phase C18 column using a binary gradient of methanol and water, both containing 5mM ammonium acetate. Sterol identification is performed using an Applied Biosystems (Foster City, CA) 4000 QTRAP mass spectrometer equipped with a TurboV electrospray ionization source and operated in the positive (+) selected reaction monitoring (SRM) mode. The total run time of the analysis is 30 min. Sterols are quantitated by comparison of the areas under the elution curves derived from the detection of endogenous compounds and isotopically labeled standards. The sensitivity of the method for sterol detection ranges between 10 and 2000 fmol on-column. Cultured RAW 264.7 mouse macrophages contain many different sterols, including the liver X receptor (LXR) ligand 24,25-epoxycholesterol. Tissues such as mouse brain also contain large numbers of sterols, including 24(s)-hydroxycholesterol, which is involved in cholesterol turnover in the brain. The extraction procedure described is flexible and can be tailored to sample type or information sought. The instrumental analysis method is similarly adaptable and offers high selectivity and sensitivity.

Magnetic Resonance Imaging (MRI) and Hip Arthroscopy Correlations.

The hip is a complex joint which commonly generates referrals to orthoaedic surgeons. Hip arthroscopy continues to expand its indications for addressing hip pathology. Before operative intervention, the appropriate information must be obtained with magnetic resonance imaging playing a significant role in the workup given its outstanding characterization of soft tissue anatomy. We attempt to highlight multiple hip findings to correlate intraoperative arthroscopic findings with specific magnetic resonance imaging images and sequences.