Subcarrier modulation based phase-coded coherent lidar.

This paper presents a lean subcarrier modulation-based phase-coded coherent lidar system with a non-quadrature receiver and sampling ratio lower than the Nyquist sampling ratio. Specifically, by utilizing the drawbacks of low Doppler tolerance in encoding signals, phase information can be obtained after pulse compression, and the mirror frequency introduced by real sampling can be negligible. Validation experiments based on inverse synthetic aperture lidar are performed, with the corresponding imaging results having a resolution superior to 4 cm, demonstrating our system's efficiency in phase acquisition that is free from frequency aliasing.

Adaptive carrier-phase-noise-canceled LiDAR for range-Doppler imaging beyond hundreds of laser coherence length.

Carrier-phase noise limits both the performance and the maximum operation range of coherent LiDAR. To address this issue, we propose a carrier-phase-noise-canceled LiDAR based on an auxiliary interferometer and adaptive filters. Compared to previous methods, this approach is calibration-free and offers higher compensation accuracy, as well as applicability of dynamic target detection. Experiments of range-Doppler imaging for stationary targets and rotating extended targets have been performed, and the detection results close to the theoretical resolution were obtained at the round trip distance to the target beyond 981 times and 106 times coherence length, respectively.

Amplitude compensation using homodyne detection for inverse synthetic aperture LADAR.

Inverse synthetic aperture LADAR (ISAL), based on an electro-optic in-phase and quadrature (I/Q) modulator, and homodyne detection, has high pulse repetition frequency, simple structure, and minimum intra-pulse phase errors. Homodyne detection can implement the de-chirp operation in the optical domain, while the output amplitude is susceptible to light intensity. However, the modulated optical signal amplitude fading, induced by radio frequency devices and the I/Q modulator, is quite tricky to measure and be compensated for. In this work, the effect of amplitude distortion on the ISAL system is analyzed. A simple and effective compensation method (based on homodyne detection) is proposed, followed by some experiments. The improvement of homodyne signal power to the compensated signal compared with non-compensated signal was about 1 dB (26%), and the image quality of our ISAL system along range direction was also improved by using the proposed method. Moreover, the image of an extended target was acquired via our ISAL system with 500 mW transmitting power at a distance of 1.1 km.