Effects of roasting and ultrasound-assisted enzymatic treatment of Nigella sativa L. seeds on thymoquinone in the oil and antioxidant activity of defatted seed meal.

BACKGROUND: Black cumin seeds (black seed; BS) contain various bioactive compounds, such as thymoquinone (TQ). Roasting and ultrasound-assisted enzymatic treatment (UAET) as pre-treatments can increase the phytochemical content in the BS oil. This study aimed to investigate the effects of pre-treatments on the TQ content and the yield of the BS oil and to profile the composition of defatted BS meal (DBSM), followed by evaluating antioxidant properties of the DBSM. RESULTS: The extraction yield of crude oil from BS was not affected by the roasting time. The highest extraction yield (47.8 ± 0.4%) was obtained with UAET cellulase-pH 5 (enzyme concentration of 100%). Roasting decreased the TQ content of the oil, while the UAET cellulase-pH 5 treatment with an enzyme concentration of 100% yielded the highest TQ (125.1 ± 2.7 µg mL-1 ). Additionally, the UAET cellulase-pH 5 treatment increased total phenolics and flavonoids of DBSM by approximately two-fold, compared to roasting or ultrasound treatment (UT) alone. Principal component analysis revealed that the UAET method might be more suitable for extracting BS oil with higher TQ content than roasting and UT. CONCLUSION: Compared to roasting or UT, using ultrasound along with cellulase could improve the oil yield and TQ in the oil from BS and obtain the DBSM with higher phenolics, flavonoids, and antioxidant activity. © 2023 Society of Chemical Industry.

Phenolics in buckwheat hull extracts and their antioxidant activities on bulk oil and emulsions.

Buckwheat hulls are discarded as waste, although they have more phenolic compounds than buckwheat groats. The antioxidant activities of buckwheat hull extracts prepared with water, 50% ethanol, and 100% ethanol were investigated in bulk oil, oil-in-water (O/W), and water-in-oil (W/O) emulsions. The relationship between the phenolic compositions of the extracts and their antioxidant activities in the three different lipid systems was also evaluated. Fifty percent ethanol extract had the highest total phenolic content (327 mg gallic acid equivalent [GAE]/g extract) followed by water and 100% ethanol extracts (211 and 163 mg GAE/g extract, respectively). The total oxidation rate (k) was not significantly different among the bulk oils added with the buckwheat hull extracts. However, in the O/W emulsion, the k was more reduced by the 50% and 100% ethanol extracts than by the water extract at the concentration of 100 µg GAE/g (2.9, 2.8, and 3.7 Totox/day, respectively). The k of the W/O emulsion was more reduced by the 100% ethanol extract than by the water and 50% ethanol extract at the concentration of 100 µg GAE/g (3.8, 4.7, and 4.5 Totox/day, respectively). Multivariate statistical analysis revealed that the contents of phenolic acids and their derivatives were the highest in the water extract among the extracts, while the contents of flavonoid glycosides and methylated polyphenols were the highest in the 50% and 100% ethanol extracts, respectively. The results suggest that flavonoid glycosides and methylated polyphenols could be potential candidates for retarding the oxidation of the emulsion system. PRACTICAL APPLICATION: Buckwheat hull extracts could retard lipid oxidation. Flavonoid glycosides and methylated polyphenols in buckwheat hull extracts may have an antioxidative effect on lipids. Thus, buckwheat hulls could be used as an antioxidant in lipid systems, as flavonoid glycosides and methylated polyphenols are properly extracted from buckwheat hulls.

Formation of Au nanostructures through an alumina mask by laser-assisted deposition.

We report a new method to produce ordered arrays of metal nanostructures on substrates. The method employs a through-hole nanoporous alumina membrane as a mask that is attached onto the substrate, silicon in this study. The material of deposition, Au in this study, was provided by pulsed laser ablation of a target gold. At an early stage of the deposition, a significant portion of Au penetrated the alumina through-holes and formed an ordered nanodot array on the silicon surface. At the later stage, the through-hole deposition was blocked by the growth of Au film on the top surface of the alumina, so that the heights of the Au nanodots were limited to about 10 nm under current experimental conditions. Subsequent attempts to clean up the top surface of the alumina with a lower power laser illumination resulted in the formation of new nanostructures around the alumina pores, nanospheres, or nanorings, depending on the fluence of the laser and the duration of the cleanup. We will discuss the underlying mechanism of the formation of these nanostructures.