ABSTRACT
It is well recognized that filter media play a crucial role in constructed wetlands (CWs) for decontamination of phosphorus (P)-rich wastewater. This study investigates the suitability of raw white hard clam shells (WHC) and white hard clam shells thermally modified at 800 °C (WHC-M800) as potential media to enhance P treatment performance in CWs. The results indicated that both WHC and WHC-M800 displayed appropriate physicochemical properties, such as high porosity, excellent hydraulic conductivity, and rich Ca content. WHC-M800 exhibited a superior P adsorption capacity (38.7 mg/g) to WHC (12.8 mg/g). However, the practical utilization of WHC-M800 as filter media in CWs may be compromised, due to certain limitations, for example: extremely high pH values in the post-adsorption solutions; high weight losses during calcination and adsorption processes; low mechanical strength; and intensive energy consumption. In contrast, the WHC demonstrated significant advantages of reasonably high P adsorption capacity, locally abundant availability, low cost, and marginal side effects. The fractionation of inorganic P of WHC and WHC-M800 revealed that Ca-bounded P was the most dominant binding form, followed by loosely bound P, Fe-P, occluded P, and Al-P. The present study demonstrates that recycling of WHC shells as a potential substrate in CWs provides a feasible method for upgrading P removal in CWs. Additionally, it helps to reduce waste WHC shells in a simple, cheap, and eco-friendly way, thus can double environmental benefits.
Subject(s)
Bivalvia , Wastewater , Adsorption , Animals , Phosphorus , Waste Disposal, Fluid , WetlandsABSTRACT
This work examined the phosphorus (P) removal from the synthetic pretreated swine wastewater using lab-scale horizontal sub-surface flow constructed wetlands (HSSF-CWs). White hard clam (Meretrix lyrata) shells (WHC) and Paspalum atratum were utilized as substrate and plant, respectively. The focus was placed on treatment performance, removal mechanisms and lifespan of the HSSF-CWs. Results indicated that WHC-based HSSF-CW with P. atratum exhibited a high P removal (89.9%). The mean P efluent concentration and P removal rate were 1.34 ± 0.95 mg/L and 0.32 ± 0.03 g/m2/d, respectively. The mass balance study showed that media sorption was the dominant P removal pathway (77.5%), followed by microbial assimilation (14.5%), plant uptake (5.4%), and other processes (2.6%). It was estimated the WHC-based bed could work effectively for approximately 2.84 years. This WHC-based HSSF-CWs technology will therefore pave the way for recycling Ca-rich waste materials as media in HSSF-CWs to enhance P-rich wastewater purification.
Subject(s)
Bivalvia , Water Pollutants, Chemical , Animals , Longevity , Phosphorus , Swine , Waste Disposal, Fluid , Wastewater , WetlandsABSTRACT
Algae is a well-known organism that its characteristic is prominent for biofuel production and wastewater remediation. This critical review aims to present the applicability of algae with in-depth discussion regarding three key aspects: (i) characterization of algae for its applications; (ii) the technical approaches and their strengths and drawbacks; and (iii) future perspectives of algae-based technologies. The process optimization and combinations with other chemical and biological processes have generated efficiency, in which bio-oil yield is up to 41.1%. Through life cycle assessment, algae bio-energy achieves high energy return than fossil fuel. Thus, the algae-based technologies can reasonably be considered as green approaches. Although selling price of algae bio-oil is still high (about $2â¯L-1) compared to fossil fuel's price of $1â¯L-1, it is expected that the algae bio-oil's price will become acceptable in the next coming decades and potentially dominate 75% of the market.
Subject(s)
Biofuels , Wastewater , Plant Oils , PolyphenolsABSTRACT
This study explores the potential of removing phosphorus from aqueous solutions and sewage by Zr(IV)-loaded okara (ZLO) in the fixed-bed column. Soybean residue (okara) was impregnated with 0.25M Zr(IV) solution to prepare active binding sites for phosphate. The effect of several factors, including flow rate, bed height, initial phosphorus concentration, pH and adsorbent particle size on the performance of ZLO was examined. The maximum dynamic adsorption capacity of ZLO for phosphorus was estimated to be 16.43mg/g. Breakthrough curve modeling indicated that Adams-Bohart model and Thomas model fitted the experimental data better than Yoon-Nelson model. After treatment with ZLO packed bed column, the effluent could meet the discharge standard for phosphorus in Australia. Successful desorption and regeneration were achieved with 0.2 NaOH and 0.1 HCl, respectively. The results prove that ZLO can be used as a promising phosphorus adsorbent in the dynamic adsorption system.
Subject(s)
Phosphates/chemistry , Sewage/chemistry , Water Pollutants, Chemical/chemistry , Zirconium/chemistry , Adsorption , Australia , Hydrogen-Ion Concentration , Kinetics , Phosphates/analysis , Phosphorus/analysis , Phosphorus/chemistry , Waste Disposal, Fluid , Water Pollutants, Chemical/analysisABSTRACT
This work deals with the capture of phosphorus from aqueous solutions by biosorption onto zirconium loaded okara (ZLO). The batch-mode experiments were conducted to examine the effect of pH, biosorbent dose, initial phosphorus concentration, contact time, and temperature on the process. It was found that, the adsorption was most favored in the pH range of 2-6. The optimal doses for the adsorption, at initial phosphorus concentrations of 5, 10, 25, 50mg/L were 2, 3, 7, 10g/L, respectively. The maximum adsorption capacity of ZLO was approximately 44.13mg PO4/g at 298K. The phosphate removal was rapid, reaching 95% in 30min. Freundlich model best fitted the equilibrium data, while Pseudo-second order model satisfactorily described the kinetic results. Thermodynamic analysis revealed feasible, spontaneous, and endothermic nature of the process. The research would be beneficial for developing a promising, eco-friendly phosphorus biosorbent from a plentiful AWB - okara.
Subject(s)
Phosphorus/chemistry , Plant Proteins/chemistry , Polysaccharides/chemistry , Water Pollutants, Chemical/chemistry , Water Purification/methods , Zirconium/chemistry , Adsorption , Biodegradation, Environmental , Kinetics , Molybdenum , Phosphorus/analysis , Soy Foods , Thermodynamics , Water Pollutants, Chemical/analysisABSTRACT
Cationization of agricultural by-products using metal salts is widely used to activate their phosphorous capture ability. This study developed three kinds of new metal loaded soybean milk by-product 'okara' for phosphorus biosorption. A comparative study among these biosorbents was carried out with respect to their performances in terms of affinity, stability and reusability. Zirconium loaded okara (ZLO) was found to have the highest affinity towards PO(4)(3-) anions (47.88 mg/g), followed by iron/zirconium loaded okara--IZLO (40.96 mg/g) and iron loaded okara--ILO (16.39 mg/g). ZLO was successfully desorbed with 0.2M NaOH and activated with 0.1 HCl prior to the next cycle. After five consecutive cycles, the efficiency of both adsorption and desorption of ZLO remained about 85% whilst no Zr(IV) leakage was observed. Conversely, IZLO and ILO suffered from vital short comings such as high metal release and/or sharp reduction in PO4(3-) sequestering capability after multi operation cycles.
Subject(s)
Metals/chemistry , Phosphorus/isolation & purification , Plant Proteins/chemistry , Polysaccharides/chemistry , Soy Milk/chemistry , Water Pollutants, Chemical/isolation & purification , Adsorption , Biodegradation, Environmental , Iron/chemistry , Kinetics , Solutions , Soy Foods , Temperature , Zirconium/chemistryABSTRACT
This study investigated the feasibility of using soybean milk by-products (okara) as a sustainable biosorbent for phosphate removal in water and wastewater. The results show that raw okara could hardly decontaminate phosphate from aqueous solutions. Hence, in this work, okara was modified by being cationized using FeCl3 0.25 M (namely iron loaded okara, ILO) to enhance the phosphorus adsorption capacity. The phosphate sorption onto ILO was well achieved under the conditions of pH 3, initial phosphorous concentration of 25 mg/L, biosorbent dose of 20 mg/L and contact time of 7 h. Based on Langmuir model, the maximum adsorption capacity of phosphate by ILO was 4.785 mg/g. The effects of interfering anions were in the order of CO3(2-)>SO4(2-)>NO3(-). It was also observed that Fe(III) was detached during operation. This problem can hinder the sustainable usability of ILO. Thus, further research would be necessary for improving the modification method.
Subject(s)
Iron/chemistry , Phosphorus/isolation & purification , Plant Proteins/chemistry , Polysaccharides/chemistry , Wastewater/chemistry , Water Pollutants, Chemical/isolation & purification , Adsorption , Anions , Hydrogen-Ion Concentration , Metals/chemistry , Phosphates/isolation & purification , Solutions , Soy Foods , Spectroscopy, Fourier Transform Infrared , Temperature , Time FactorsABSTRACT
A novel fluidized bed bioreactor (FBBR) was designed by integration of anaerobic granular activated carbon and aerobic sponge reactors. This FBBR was evaluated at different sponge volume fractions for treating a synthetic wastewater. Polyester urethane sponge with cube size of 1 × 1 × 1 cm and density of 28-30 kg/m(3) with 90 cells per 25 mm was used as biomass carrier. The results indicate that the FBBR could remove more than 93% of dissolved organic carbon (DOC). The highest nutrient removal efficiencies (58.2% PO4-P and 75.4% NH4-N) were achieved at 40% sponge volume fraction. The system could provide a good condition for biomass growth (e.g. 186.2 mg biomass/g sponge). No significant different performance in specific oxygen uptake rate was observed between 30, 40, and 50% sponge volume fractions.
Subject(s)
Bioreactors , Waste Disposal, Fluid/instrumentation , Biomass , Bioreactors/microbiology , Carbon/analysis , Hydrogen-Ion Concentration , Nitrogen/metabolism , Oxidation-Reduction , Oxygen/metabolism , Phosphorus/metabolism , Polyesters , Polyurethanes , Waste Disposal, Fluid/methods , Water Pollutants, Chemical/metabolismABSTRACT
A modified activated sludge process (ASP) for enhanced biological phosphorus removal (EBPR) needs to sustain stable performance for wastewater treatment to avoid eutrophication in the aquatic environment. Unfortunately, the overall efficiency of the EBPR in ASPs and membrane bioreactors (MBRs) is frequently hindered by different operational/system constraints. Moreover, although phosphorus removal data from several wastewater treatment systems are available, a comprehensive mathematical model of the process is still lacking. This paper presents a critical review that highlights the core issues of the biological phosphorus removal in ASPs and MBRs while discussing the inhibitory process requirements for other nutrients' removal. This mini review also successfully provided an assessment of the available models for predicting phosphorus removal in both ASP and MBR systems. The advantages and limitations of the existing models were discussed together with the inclusion of few guidelines for their improvement.
Subject(s)
Bioreactors , Membranes, Artificial , Phosphorus/isolation & purification , Sewage/chemistry , Water Purification/instrumentation , Water Purification/methods , Biodegradation, EnvironmentalABSTRACT
Palm oil fruit shells were evaluated as a new bioadsorbent to eliminate toxic copper from water and wastewater. Without any chemical treatment, palm oil fruit shells were washed, dried and grounded into powder (<75 µm) for use in the experiments. Characterization showed mesopore based bioadsorbent was prepared from palm oil fruit shells. The results indicate that the highest Cu removal efficiency was found in an aqueous solution with pH of 6.5. The equilibrium sorption capacity of copper was significantly high (between 28 and 60 mg/g) at room temperature. Nonlinear regression analyses for isotherm models revealed that three-parameter isotherms had a better fit to the experimental data (R(2)>0.994) than that of two-parameter isotherms. The copper sorption system was heterogeneous as the values of exponents were lying between 0 and 1. The highly correlated pseudo-second-order kinetics model (R(2)>0.998) ascertained the applicability of copper removal by palm oil fruit shells.
Subject(s)
Copper/isolation & purification , Models, Theoretical , Plant Oils/chemistry , Water Pollutants, Chemical/isolation & purification , Adsorption , Hydrogen-Ion Concentration , Kinetics , Palm OilABSTRACT
Floating plastic media coupled with sand filtration system was applied for treating surface water and secondary effluent from municipal sewage treatment plant. The system employed floating plastic media for the removal of suspended solids in surface water and precipitated phosphorus from secondary effluent of sewage treatment plant. Sand filtration was then used to remove further the suspended solids. For the purposes of wastewater reuse, a zeolite layer was used instead of sand filter to absorb ammonium nitrogen. Application of system for surface water treatment suggested appropriate filtration rate of 5 m3/m2 h. Polyaluminum chloride was found to be the best coagulant with an appropriate plastic and sand bed depth of 40 cm. The system could produce average effluent turbidity and suspended solids of 0.71 NTU and 0.94 mg/L respectively. Average turbidity and suspended solids removal efficiencies were 96.26% and 95.48% with low headloss development of 40.4 cm at the end of 6 h operation period. When applying 1.50 m. floating plastic media bed for the treatment of synthetic raw water, short and long-term turbidity removal efficiencies were 96.79-97.72% and 81.81-94.61% for raw water containing turbidity of 20 and 40 NTU. It could produce the effluent with turbidity less than 5NTU while having less than 1.0 m. headloss. The system was also applied for the secondary effluent treatment. An optimum filtration rate of 5 m3/m2 h was obtained when using plastic and sand bed depth of 60 and 20cm under direct filtration mode. Average turbidity removal was 60.3% and 59.6% after 6 and 48 h of operation. It was also found that 1 m3/m2 h filtration rate and 50:30 cm of plastic:zeolite bed could be used to achieve both ammonium nitrogen and phosphate removal. Suspended solids, turbidity, BOD5, NH4+, and PO4(3-) removal efficiencies were 91.9, 94.6, 95.4, 97.3, and 99.5% respectively after 24 h. As a result, the effluent from the system had average NH4+ and PO4(3-) of 0.5 mg N/L and 0.02 mg P/L.