Formation and sedimentation of oil-mineral aggregates in the presence of chemical dispersant.

The formation and sedimentation of oil-mineral aggregates (OMAs) is the major method to transport spilled oil to the seafloor. In this study, the formation and sedimentation experiments of OMA using montmorillonite and four crude oils were performed in a wave tank in the presence of chemical dispersant. Most of the formed OMAs were droplet OMAs, and single droplet OMA would aggregate into multiple ones under the action of the dispersant. The size of the oil droplets trapped in the OMA increased with time and was larger for the oil with higher viscosity. The sinking velocities of OMAs formed in this study were between 100-1200 µm s-1 and they were positively correlated with their diameter. The density of OMA was of the same order as that of the crude oil that formed them. An increase in the dispersant dosage could promote the formation of OMAs. The oil content in OMAs was higher for the denser oil in the presence of a dispersant. The maximum oil trapping efficiency of OMAs was 48.05%. This study provides fundamental data on the formation kinetics of OMAs.

Impact of mixing energy and dispersant dosage on oil dispersion and sedimentation with microplastics in the marine environment.

Recently, the fate of spilled oil in the presence of microplastics (MPs) in the sea has attracted attention of researchers. Merey crude oil and polyethylene terephthalate (PET) were used as the experimental materials in this study. The effects of mixing energy and dispersant dosage on oil dispersion and sedimentation in the presence of MPs in the water column were investigated by laboratory experiments simulating actual sea conditions. The increase of mixing energy showed a promoting effect on oil dispersion. When the oscillation frequency increased from 140 rpm to 180 rpm, the oil dispersion efficiency (ODE) ranged from 2.1 %-3.7 % to 17.4 %-30.8 %, and the volumetric mean diameter (VMD) of the suspended oil droplets/MPs-oil agglomerates (MOA) decreased from 99.9-131.4 µm to 76.6-88.2 µm after 2 h oscillation. The application of chemical dispersant led to an increase in both the quantity and size of the formed sunken MPs-oil-dispersant agglomerates (MODA). At the dispersant-to-oil ratio (DOR) of 1:5, the ODE declined from 77.7 % to 62.6 % when the MPs concentration increased from 0 to 150 mg/L, while the oil sinking efficiency (OSE) rose from 3.4 % to 15.6 % when the MPs increased from 25 to 150 mg/L; the maximum size of the sunken MODA reached 13.0 mm, and the total volume of the MODA formed per unit volume oil reached 389.7 µL/mL oil at the MPs concentration of 150 mg/L. Meanwhile, the results showed that the presence of MPs inhibited the oil dispersion by increasing the oil-water interfacial tension. The outcomes of this work may provide assistance in predicting the transport of spilled oil and developing emergency measures.

Formation of oil-particle aggregates in the presence of marine algae.

After an oil spill, the formation of oil-particle aggregates (OPAs) is associated with the interaction between dispersed oil and marine particulate matter such as phytoplankton, bacteria and mineral particles. Until recently, the combined effect of minerals and marine algae in influencing oil dispersion and OPA formation has rarely been investigated in detail. In this paper, the impacts of a species of flagellate algae Heterosigma akashiwo on oil dispersion and aggregation with montmorillonite were investigated. This study has found that oil coalescence is inhibited due to the adhesion of algal cells on the droplet surface, causing fewer large droplets to be dispersed into the water column and small OPAs to form. Due to the role of biosurfactants in the algae and the inhibition of algae on the swelling of mineral particles, both the oil dispersion efficiency and oil sinking efficiency were improved, which reached 77.6% and 23.5%, respectively at an algal cell concentration (Ca) of 1.0 × 106 cells per mL and a mineral concentration of 300 mg L-1. The volumetric mean diameter of the OPAs decreased from 38.4 µm to 31.5 µm when Ca increased from 0 to 1.0 × 106 cells per mL. At higher turbulent energy, more oil tended to form larger OPAs. The findings may add knowledge about the fate and transport of spilled oil and provide fundamental data for oil spill migration modelling.

Combined effects of chemical dispersant and suspended minerals on the dispersion process of spilled oil.

The dispersion process of spilled oil is an important concern for the effective disposal of oil spills. The dispersed oil concentration and oil droplets size distribution were studied through a wave tank test under the application of chemical dispersant and suspended minerals. The results indicated that dispersant and minerals increased the dispersed oil concentration and the effect of dispersant was more significant, and they had a synergistic effect on oil dispersion. When dispersant and minerals were applied together, the volume mean diameter of oil droplets decreased in the first 30 min, then increased and reached a maximum value at 90-120 min, and decreased again. Moreover, suspended minerals could inhibit the coalescence of oil droplets. This study can afford data support for oil spill emergency response that occurs in inshore or estuaries.

Effects of oil properties on the formation of oil-particle aggregates at the presence of chemical dispersant in baffled flask tests.

The formation of oil-particle aggregates (OPA) is the major sedimental pathway of spilled oil, which can bring great harm to both the benthic communities and marine environment. In this paper, effects of GM-2 chemical dispersant and oil properties on the formation of OPA was investigated by the EPA baffled flask test. The addition of dispersant can promote the formation of OPA from montmorillonite and five test oils obviously. With the increase of the dispersant dosage, the size of trapped oil in OPA increased and the density of OPA decreased. The dispersant can increase the kinematic viscosity of crude oil, and high viscosity of the oil is advantageous for the formation of OPA. The oil-seawater interfacial tension is reduced after the addition of dispersant, which makes oil dispersed into the water column easier. A kinematic equation of dispersed oil concentration attenuation was modified by introducing the oil property coefficient ß. The modified empirical equation can calculate the mass of oil in sunken OPA in oil spill accidents.

Effects of chemical dispersant on the surface properties of kaolin and aggregation with spilled oil.

After oil spills occur, dispersed oil droplets can collide with suspended particles in the water column to form the oil-mineral aggregate (OMA) and settle to the seafloor. However, only a few studies have concerned the effect of chemical dispersant on this process. In this paper, the mechanism by which dispersant affects the surface properties of kaolin and the viscosity and oil-seawater interfacial tension (IFTow) of Roncador crude oil were separately investigated by small-scale tests. The results indicated that the presence of dispersant impairs the zeta potential and enhances the hydrophobicity of kaolin. The viscosity of Roncador crude oil rose slightly as the dosage of dispersant increased, while IFTow decreased significantly. Furthermore, the oil dispersion and OMA formation at different dispersant-to-oil ratio (DOR) were evaluated in a wave tank. When DOR was less than 1:40, the effect of dispersant on the dispersion of spilled oil was not obvious. With the increasing DOR, the effect became more pronounced, and the adhesion between oil droplets and kaolin was inhibited. The size ratio between oil droplets and particles is the significant factor for OMA formation. The closer the oil-mineral size ratio is to 1, the more difficultly the OMA forms.

Performance of dispersed oil and suspended sediment during the oil-sediment aggregation process.

Oil-sediment aggregation is an important transport and transformation process of spilled oil, which has been considered as a pathway of spill remediation. This work focused on the individual performance of dispersed oil and sediment during the aggregation process. Dispersion of three oils was first tested and validated in a water tank. An approach of estimating the mass variation of the sediment that has participated in forming the oil-sediment aggregates (OSAs) has been developed by density analysis. Results indicated that the density of the formed OSAs increases during the aggregation. In the context of remediation, it takes longer for sediment to reach equilibrium than for dispersed oil, especially under high mixing energy at a large sediment concentration, which results in the formation of dense OSAs, as well as high aggregation degree and rate. Roncador oil possesses a relatively high capability of capturing sediment to form dense OSAs, especially at an initial sediment concentration of over 150 mg/L. Oil sinking efficiency and the characteristic change rate of aggregated oil mass seem to be proportional to oil dispersion efficiency, and decrease with the mean size of dispersed oil droplets. The process of aggregation can further promote the dispersion of oil into water column. This study also provides fundamental data for the formation kinetics of OSAs.

Effect of the concentration and size of suspended particulate matter on oil-particle aggregation.

After spill, the dispersed oil droplets may collide with suspended particulate matter in the water column to form oil-particle aggregates (OPAs) in turbulent environments. It may be an effective pathway to stabilize the oil by taking advantage of the particulate matter to clean up the contaminated waters. A theoretical model in Payne et al. (2003) is adopted to describe the oil-particle aggregation, and a solution method is proposed and validated against a group of experiments. The effect of the particle size and mass concentration on the aggregation has been examined quantitatively in detail. The particles and the oil droplets are consumed at a fixed ratio. Under the same mass concentration, smaller particles can trap more oil droplets, while larger particles tend to interact more quickly with the oil. The oil-particle aggregation rate and the oil trapping efficiency mainly depend on the particle concentration. The theoretical model is applied to predict the decrease of the dispersed oil in nearshore environments, based on the parameters obtained from the experiments. It is efficient to promote the oil-particle aggregation by increasing the particle concentration in the closed bay. In the open sea, the decrease of the dispersed oil can be effectively enhanced by increasing the particle concentration when it is below 0.50 kg/m3. The information presented in this paper can serve to predict the fate of the dispersed oil in coastal waters and provide technical support for oil spill management strategies.

Effects of physical parameters and chemical dispersant on the formation of oil-particle aggregates (OPAs) in marine environments.

Floating oil and sediments can interact to form oil-particle aggregates (OPAs) in marine environments. Laboratory batch experiments were conducted to investigate the effects of the concentration and size of sediment, temperature, oil types and chemical dispersant on the formation of OPAs. The results showed that the mass of OPAs and oil-particle aggregation rate are mainly related to the sediment concentration. Under the same mass concentration, more oil droplets can be trapped by smaller particles. Nevertheless, larger particles tend to interact more quickly with oil droplets. The effect of temperature on the formation of OPAs is substantially attributed to its influence on oil viscosity, and there is a threshold for oil viscosity which will bring about the maximum OPAs. Spilled oil with a high asphaltene can interact more effectively with the sediments. Appropriate addition of chemical dispersant is favorable for the formation of OPAs while excess addition will inhibit it.

Effects of the suspended sediment concentration and oil type on the formation of sunken and suspended oils in the Bohai Sea.

The unsourced oil contamination on the coast of Bohai Sea has recently attracted scholars to study the formation of sunken and suspended oils (SSO) from oil slicks on the sea surface. In this research, batch experiments have been conducted to study the time-scale effect of the different concentrations of suspended sediments on the formation of sunken oils and suspended oils using three oils (Oman crude oil, Merey crude oil, and 380# fuel oil) and two sediments (sand and silt) at different temperatures. The results showed that the sunken and suspended oils formed quickly within the mixing time and reached a maximum at the equilibrium time, te, and that te had a wide range of variation with sediment concentration and type. The oil sinking and submerging efficiency could reach up to 6.33%, 43.82% and 44.44% for 380# fuel oil, Oman crude oil and Merey crude oil, respectively. It is noted that the increase in sediment concentration and environmental temperature could enhance the formation of SSO but that it had a close relationship with the oil type. Overall, hydrophobic sand had a significantly higher oil sedimentation effect than silt.