Investigation of volatile thiol contributions to rapeseed oil by odor active value measurement and perceptual interactions.

Volatile thiols are important aroma components of rapeseed oil. This study established an identification and quantification method of volatile thiols via headspace solid-phase microextraction and gas chromatography-sulfur chemiluminescence detection. Four thiols (phenylmethanthiol, 3-sulfanyl-1-hexanol, 2-methyl-3-furanthiol, and 2-furylmethanthiol) were newly identified in microwaved rapeseed oil, and cause sesame, roasted meat, and garlic odors. The total concentration of the four thiols in rapeseed oil obtained from 13 rapeseed varieties ranged from 11.47 to 153.72 µg/kg. Determination of the threshold revealed that 3-sulfanyl-1-hexanol possessed the highest odor active value (7565), followed by phenylmethanthiol (3589), 2-furylmethanthiol (626), and 2-methyl-3-furanthiol (28). Further, perceptual interactions between volatile thiols and characteristic odor (3-butenyl isothiocyanate) of rapeseed oil were evaluated by Feller's addition model and S-curve method, which revealed that 2-methyl-3-furanthiol, 2-furylmethanthiol, phenylmethanthiol, and 3-sulfanyl-1-hexanol present a positive effect with 3-butenyl isothiocyanate. This study provides deep insights into the impact of sulfur-containing compounds on the aroma of rapeseed oil.

Process optimization and characterization of arachidonic acid oil degumming using ultrasound-assisted enzymatic method.

Ultrasound assisted enzymatic method was applied to the degumming of arachidonic acid (ARA) oil produced by Mortierella alpina. The conditions of degumming process were optimized by response surface methodology with Box- Behnken design. A dephosphorization rate of 98.82% was achieved under optimum conditions of a 500 U/kg of Phospholipase A1 (PLA1) dosage, 2.8 mL/100 g of water volume, 120 min of ultrasonic time, and 135 W of ultrasonic power. The phosphorus content of ultrasonic assisted enzymatic degumming oil (UAEDO) was 4.79 mg/kg, which was significantly lower than that of enzymatic degumming oil (EDO, 17.98 mg/kg). Crude Oil (CO), EDO and UAEDO revealed the similar fatty acid compositions, and ARA was dominated (50.97 ~ 52.40%). The oxidation stability of UAEDO was equivalent to EDO and weaker than CO, while UAEDO presented the strongest thermal stability, followed by EDO and CO. Furthermore, aldehydes, acids and alcohols were identified the main volatile flavor components for the three oils. The proportions of major contributing components such as hexanal, nonanal, (E)-2-nonanal, (E, E)-2,4-decadienal, (E)-2-nonenal and aldehydes in UAEDO and EDO were all lower than CO. Overall, Ultrasound assisted enzymatic degumming proved to be an efficient and superior method for degumming of ARA oil.

Free-Radical-Mediated Formation Mechanism of Polar Polymeric Triglycerides in Vegetable Oil Studied by Electron Spin Resonance and High-Performance Liquid Chromatography.

The free-radical-mediated formation mechanism of polar polymeric triglycerides (TAGs) was derived based on the formation of lipid-derived radicals and the degradation of TAGs in palm oil (PO), rapeseed oil (RO), and sunflower oil (SO). The experimental spectra were simulated by alkoxyl, alkyl, and 5-dimethyl-1-pyrroline N-oxide (DMPO)-oxidized adducts. DMPO-oxidized adducts were the main radical adducts in the initial stage. Then, alkyl radical adducts became the dominating radical adducts after 12 min in PO and RO. The intensity of alkyl radical adducts was the highest in SO. Therefore, based on the bimolecular reaction, polar polymeric TAGs were mainly bonded by -C-O-O-C- in the initial stage and then by -C-C- and -C-O-C- after 30 min. Besides, according to the correlation analysis between the amounts of polar polymeric TAGs and the degradation of TAGs, the main structures of polar polymeric TAGs in PO, RO, and SO were POL-LOP, POL-OOP, and POO-OOP; OLL-LnLO, OLLn-OLnO, OOO-OLO, and OLLn-OOO; and LLL-LLO, LLL-LLL, and OLL-LLO, respectively.

Effect of microwave treatment on the efficacy of expeller pressing of Brassica napus rapeseed and Brassica juncea mustard seeds.

A study was conducted to evaluate the effect of microwave heating on the efficacy of expeller pressing of rapeseed and mustard seed and the composition of expeller meals in two types of Brassica napus rapeseed (intermediate- and low-glucosinolate) and in Brassica juncea mustard (high-glucosinolate). Following microwave treatment, the microstructure of rapeseed using transmission electron microscopy showed a significant disappearance of oil bodies and myrosin cells. After 6 min of microwave heating (400 g, 800 W), the oil content of rapeseed expeller meal decreased from 44.9 to 13.5% for intermediate-glucosinolate B. napus rapeseed, from 42.6 to 11.3% for low-glucosinolate B. napus rapeseed, and from 44.4 to 14.1% for B. juncea mustard. The latter values were much lower than the oil contents of the corresponding expeller meals derived from the unheated seeds (i.e., 26.6, 22.6, and 29.8%, respectively). Neutral detergent fiber (NDF) contents showed no differences except for the expeller meal from the intermediate-glucosinolate B. napus rapeseed, which increased from 22.7 to 29.2% after 6 min of microwave heating. Microwave treatment for 4 and 5 min effectively inactivated myrosinase enzyme of intermediate-glucosinolate B. napus rapeseed and B. juncea mustard seed, respectively. In low-glucosinolate B. napus rapeseed the enzyme appeared to be more heat stable, with some activity being present after 6 min of microwave heating. Myrosinase enzyme inactivation had a profound effect on the glucosinolate content of expeller meals and prevented their hydrolysis to toxic breakdown products during the expelling process. It appeared evident from this study that microwave heating for 6 min was an effective method of producing expeller meal without toxic glucosinolate breakdown products while at the same time facilitating high yield of oil during the expelling process.

Production of novel "functional oil" rich in diglycerides and phytosterol esters with "one-pot" enzymatic transesterification.

Diglycerides and phytosterol esters are two important functional lipids. Phytosterol esters mixed with dietary diglyceride could not only influence body weight but also prevent or reverse insulin resistance and hyperlipidemia. In this study, a kind of novel "functional oil" rich in both diglycerides and phytosterol esters was prepared with "one-pot" enzymatic transesterification. First, lipase AYS (Candida rugosa) was immobilized on the porous cross-linked polystyrene resin beads (NKA) via hydrophobic interaction. The resulting immobilized AYS showed much better transesterification activity and thermal stability to freeways. On the basis of the excellent biocatalyst prepared, a method for high-efficiency enzymatic esterification of phytosterols with different triglycerides to produce corresponding functional oils rich in both diglycerides and phytosterol esters was developed. Four functional oils rich in both diglycerides and phytosterol esters with conversions >92.1% and controllable fatty acid composition were obtained under the optimized conditions: 80 mmol/L phytosterols, 160 mmol/L triglycerides, and 25 mg/mL AYS@NKA at 180 rpm and 50 °C for 12 h in hexane. The prepared functional oil possessed low acid value (≤1.0 mgKOH/g), peroxide value (≤2.1 mmol/kg), and conjugated diene value (≤1.96 mmol/kg) and high diglyceride and phytosterol ester contents (≥10.4 and ≥20.2%, respectively). All of the characteristics favored the wide application of the functional oil in different fields of functional food.