Waste-to-energy: Co-pyrolysis of potato peel and macroalgae for biofuels and biochemicals.

Waste-to-energy conversion presents a pivotal strategy for mitigating the energy crisis and curbing environmental pollution. Pyrolysis is a widely embraced thermochemical approach for transforming waste into valuable energy resources. This study delves into the co-pyrolysis of terrestrial biomass (potato peel) and marine biomass (Sargassum angastifolium) to optimize the quantity and quality of the resultant bio-oil and biochar. Initially, thermogravimetric analysis was conducted at varying heating rates (5, 20, and 50 °C/min) to elucidate the thermal degradation behavior of individual samples. Subsequently, comprehensive analyses employing FTIR, XRD, XRF, BET, FE-SEM, and GC-MS were employed to assess the composition and morphology of pyrolysis products. Results demonstrated an augmented bio-oil yield in mixed samples, with the highest yield of 27.1 wt% attained in a composition comprising 75% potato peel and 25% Sargassum angastifolium. As confirmed by GC-MS analysis, mixed samples exhibited reduced acidity, particularly evident in the bio-oil produced from a 75% Sargassum angastifolium blend, which exhibited approximately half the original acidity. FTIR analysis revealed key functional groups on the biochar surface, including O-H, CO, and C-O moieties. XRD and XRF analyses indicated the presence of alkali and alkaline earth metals in the biochar, while BET analysis showed a surface area ranging from 0.64 to 1.60 m2/g. The favorable characteristics of the products highlight the efficacy and cost-effectiveness of co-pyrolyzing terrestrial and marine biomass for the generation of biofuels and value-added commodities.

Producing submicron chitosan-stabilized oil Pickering emulsion powder by an electrostatic collector-equipped spray dryer.

Chitosan (CS) was modified with two fatty acids, i.e., capric acid (CA) and palmitic acid (PA). Particle size (315.8 nm), zeta potential (31.8 mV), and viscosity (29.4 mPa.s) of CS-PA nanogels were lower than CS-CA nanogels (793.2 nm, 53.3 mV, and 70.7 mPa.s). First, hempseed oil-in-water Pickering nanoemulsions were stabilized by CS-based particles/maltodextrin (MD). Then, the emulsions were dried using an electrostatic collector-equipped spray dryer. The D50 of re-dispersed emulsion powders with CS-PA/MD coating was 936 nm. According to the FE-SEM images, oil coated with CS-PA/MD showed higher porosity and C/O ratio at the particle surface compared to the CS-CA/MD coating leading to more oil leakage. In addition, the crystallinity of hempseed oil coated with CS-PA/MD was higher than the one coated with CS-CA/MD. These findings showed that submicron Pickering emulsion powders could be achieved by targeted modification of CS and using a spray dryer equipped with an electrostatic collector.

Managing the hazardous waste cooking oil by conversion into bioenergy through the application of waste-derived green catalysts: A review.

Waste cooking oil (WCO) is a hazardous waste generated at staggering values globally. WCO disposal into various ecosystems, including soil and water, could result in severe environmental consequences. On the other hand, mismanagement of this hazardous waste could also be translated into the loss of resources given its energy content. Hence, finding cost-effective and eco-friendly alternative pathways for simultaneous management and valorization of WCO, such as conversion into biodiesel, has been widely sought. Due to its low toxicity, high biodegradability, renewability, and the possibility of direct use in diesel engines, biodiesel is a promising alternative to mineral diesel. However, the conventional homogeneous or heterogeneous catalysts used in the biodiesel production process, i.e., transesterification, are generally toxic and derived from non-renewable resources. Therefore, to boost the sustainability features of the process, the development of catalysts derived from renewable waste-oriented resources is of significant importance. In light of the above, the present work aims to review and critically discuss the hazardous WCO application for bioenergy production. Moreover, various waste-oriented catalysts used to valorize this waste are presented and discussed.