Novel label-free and high-throughput microchip electrophoresis platform for multiplex antibiotic residues detection based on aptamer probes and target catalyzed hairpin assembly for signal amplification.

Novel label-free and multiplex aptasensors have been developed for simultaneous detection of several antibiotics based on a microchip electrophoresis (MCE) platform and target catalyzed hairpin assembly (CHA) for signal amplification. Kanamycin (Kana) and oxytetracycline (OTC) were employed as models for testing the system. These aptasensors contained six DNA strands termed as Kana aptamer-catalysis strand (Kana apt-C), Kana inhibit strand (Kana inh), OTC aptamer-catalysis strand (OTC apt-C), OTC inhibit strand (OTC inh), hairpin structures H1 and H2 which were partially complementary. Upon the addition of Kana or OTC, the binding event of aptamer and target triggered the self-assembly between H1 and H2, resulting in the formation of many H1-H2 complexes. They could show strong signals which represented the concentration of Kana or OTC respectively in the MCE system. With the help of the well-designed and high-quality CHA amplification, the assay could yield 300-fold amplified signal comparing that from non-amplified system. Under optimal conditions, this assay exhibited a linear correlation in the ranges from 0.001ngmL-1 to 10ngmL-1, with the detection limits of 0.7pgmL-1 and 0.9pgmL-1 (S/N=3) toward Kana and OTC, respectively. The platform has the following advantages: firstly, the aptamer probes can be fabricated easily without labeling signal tags for MCE detection; Secondly, the targets can just react with probes and produce the amplified signal in one-pot. Finally, the targets can be simultaneously detected within 10min in different channels, thus high-throughput measurement can be achieved. Based on this work, it is estimated that this detection platform will be universally served as a simple, sensitive and portable platform for antibiotic contaminants detection in biological and environmental samples.

A triple-amplification colorimetric assay for antibiotics based on magnetic aptamer-enzyme co-immobilized platinum nanoprobes and exonuclease-assisted target recycling.

Herein, an ultrasensitive and selective colorimetric assay for antibiotics, using chloramphenicol (CAP) as the model analyte, was developed based on magnetic aptamer-HRP-platinum composite probes and exonuclease-assisted target recycling. The composite probes were prepared through immunoreactions between the double stranded DNA antibody (anti-DNA) labeled on core-shell Fe3O4@Au nanoparticles (AuMNP-anti-DNA) as the capture probe, and the double stranded aptamer (aptamer hybrid with its complementary oligonucleotides) labeled on Pt@HRP nanoparticles as the nanotracer (ds-Apt-HRP-PtNPs). When the CAP samples were incubated with the probes for 30 min at room temperature, they could be captured by the aptamer to form a nanotracer-CAP complex, which was then released into the supernatant after magnetic separation. This is because the anti-DNA on the capture probes cannot recognize the single strand aptamer-CAP complex. The exonuclease I (Exo I) added into the supernatant can further digest the aptamer-CAP from the 3'-end of the aptamer and the CAP in the aptamer-CAP complex can be released again, which can further participate in a new cycling process to react with the probes. Pt and HRP in the nanotracer could both catalyze and dual amplify the absorbance at 650 nm ascribed to the 3,3',5,5'-tetramethylbenzidine (TMB)-H2O2 system. Moreover, Exo I can assist the target recycling, which can further amplify the signal. Thus, the triple amplified signal can be quantified by ultraviolet-visible spectroscopy. The experimental results showed that the CAP detection possessed a linear range of 0.001-10 ng mL(-1) and a detection limit of 0.0003 ng mL(-1) (S/N = 3). The assay was successfully employed to detect CAP in milk, which is much more facile, time saving, and sensitive than the commercial ELISA kits.

A "signal-on'' aptasensor for simultaneous detection of chloramphenicol and polychlorinated biphenyls using multi-metal ions encoded nanospherical brushes as tracers.

A "signal-on'' aptasensor was developed for simultaneous detection of chloramphenicols (CAP) and polychlorinated biphenyl-72 (PCB72) with a novel multi-metal ions encoded nanospherical brushes as nanotracers. To construct the assay, the respective aptamer of CAP and PCB72 labeled magnetic gold nanoparticles as capture probes (aptamer-MGPs), and their complementary single strand DNA (s-DNA) encoded metal ions (Cd(2+) and Pb(2+)) on nanospherical branched polyethylene imine brushes as tracers (s-DNA-MSPEIs), were simultaneously synthesized. After that, the capture probe and tracers were connected through a hybridization reaction between s-DNA and aptamers. In the presence of CAP and PCB72, the analytes could react with the aptamers on capture probes and release the tracers into supernatant after magnetic separation. The released tracers with metal ions (Cd(2+) and Pb(2+)) could be simultaneously detected through the square wave voltammetry (SWV) without acid dissolution, which can switch the signals of the biosensor to "on'' state. Under optimal conditions, the assay could detect CAP and PCB72 as low as 0.3 pg mL(-1) with the dynamitic range from 0.001 to 100 ng mL(-1) and exhibited excellent selectivity. More importantly, the strategy can be extended easily to other targets after changing the corresponding aptamers and other metal ions tracers, which provides a promising and facile approach in multiplex detection of ultra-trace level of pollutants in food safety without more complex separation and washing steps.